Physics for Scientists and Engineers: Foundations and Connections
1st Edition
ISBN: 9781133939146
Author: Katz, Debora M.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 33.2, Problem 33.3CE
(a)
To determine
The current in the inductor if the voltmeter reads zero.
(b)
To determine
The current in the inductor if the voltmeter reads a positive value.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A resistor of resistance R = 10 Ω is connected in series with an inductor of L = 15 mH. The RL combination is connected to a variable voltage power supply (V = 4.5 V) by a switch as shown.
a. What is the time constant (τ) of the combination in seconds?
b. The power supply is set to maintain a constant voltage of V = 4.5 V and the switch is closed. Calculate the current, in amperes, through the circuit at t = 0.29 ms after the switch is closed.
c. Calculate the current through the circuit, in amperes, after the switch has been closed for a long time.
A 90 mH inductor carries a current that varies with time according to… i(t) = t2+6t (in A with t in sec). Determine the magnitude of the voltage across the inductor at t = 4 seconds.
a.
1.26 V
b.
2.88 V
c.
3.42 V
d.
3.60 V
The 4.00 A current through a 1.30 H inductor is dissipated by a 2.00 Ω resistor in a circuit like that in the figure below with the switch in position 2.
a. What is the initial energy in the inductor?
b. How long will it take the current to decline to 15.00% of its initial value?
c. Calculate the average power dissipated in the inductor.
d. What is the ratio of the initial power dissipated by the resistor to the average power dissipated by the inductor?
Chapter 33 Solutions
Physics for Scientists and Engineers: Foundations and Connections
Ch. 33.1 - Prob. 33.1CECh. 33.1 - Prob. 33.2CECh. 33.2 - Prob. 33.3CECh. 33.3 - Prob. 33.4CECh. 33.4 - Prob. 33.5CECh. 33.5 - Prob. 33.6CECh. 33.7 - Prob. 33.7CECh. 33 - Prob. 1PQCh. 33 - Prob. 2PQCh. 33 - Prob. 3PQ
Ch. 33 - Prob. 4PQCh. 33 - Prob. 5PQCh. 33 - Prob. 6PQCh. 33 - Prob. 7PQCh. 33 - Prob. 8PQCh. 33 - Prob. 9PQCh. 33 - Prob. 10PQCh. 33 - Prob. 11PQCh. 33 - At one instant, a current of 6.0 A flows through...Ch. 33 - Prob. 13PQCh. 33 - Prob. 14PQCh. 33 - Prob. 15PQCh. 33 - In Figure 33.9A (page 1052), the switch is closed...Ch. 33 - Prob. 17PQCh. 33 - Prob. 18PQCh. 33 - Prob. 19PQCh. 33 - Prob. 20PQCh. 33 - Prob. 21PQCh. 33 - Prob. 22PQCh. 33 - In the LC circuit in Figure 33.11, the inductance...Ch. 33 - A 2.0-F capacitor is charged to a potential...Ch. 33 - Prob. 26PQCh. 33 - Prob. 27PQCh. 33 - Prob. 28PQCh. 33 - For an LC circuit, show that the total energy...Ch. 33 - Prob. 30PQCh. 33 - Prob. 31PQCh. 33 - Prob. 32PQCh. 33 - Prob. 33PQCh. 33 - Suppose you connect a small lightbulb across a DC...Ch. 33 - Prob. 35PQCh. 33 - Prob. 36PQCh. 33 - Prob. 37PQCh. 33 - Prob. 38PQCh. 33 - Prob. 39PQCh. 33 - Prob. 40PQCh. 33 - Prob. 41PQCh. 33 - Prob. 42PQCh. 33 - Prob. 43PQCh. 33 - In an ideal AC circuit with capacitance, there is...Ch. 33 - Prob. 45PQCh. 33 - Prob. 46PQCh. 33 - Prob. 47PQCh. 33 - Prob. 48PQCh. 33 - Prob. 49PQCh. 33 - An AC generator with an rms emf of 15.0 V is...Ch. 33 - Prob. 51PQCh. 33 - Prob. 52PQCh. 33 - Prob. 53PQCh. 33 - Prob. 54PQCh. 33 - Prob. 55PQCh. 33 - Prob. 56PQCh. 33 - Prob. 57PQCh. 33 - Prob. 58PQCh. 33 - Prob. 59PQCh. 33 - An AC source of angular frequency is connected to...Ch. 33 - An RLC series circuit is constructed with R =...Ch. 33 - Prob. 62PQCh. 33 - A series RLC circuit driven by a source with an...Ch. 33 - Prob. 64PQCh. 33 - Prob. 65PQCh. 33 - Prob. 66PQCh. 33 - Prob. 67PQCh. 33 - Prob. 68PQCh. 33 - Prob. 69PQCh. 33 - Prob. 70PQCh. 33 - Problems 71 and 72 paired. Figure P33.71 shows a...Ch. 33 - Prob. 72PQCh. 33 - Prob. 73PQCh. 33 - Prob. 74PQCh. 33 - Prob. 75PQCh. 33 - In a series RLC circuit with a maximum current of...Ch. 33 - Prob. 77PQCh. 33 - Two coaxial cables of length with radii a and b...Ch. 33 - Prob. 79PQCh. 33 - Prob. 80PQCh. 33 - Prob. 81PQCh. 33 - Prob. 82PQCh. 33 - Prob. 83PQCh. 33 - Prob. 84PQ
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Each of the three situations in Figure P32.68 shows a resistor in a circuit in which currents are induced. Using Lenzs law, determine whether the current in each situation is from a to b or from b to a. a. If the current I in the wire in Figure P32.68A is increased from zero to I, what is the direction of the current induced across the resistor R? b. The switch in Figure P32.68B is initially closed and is thrown open at t = 0. What is the direction of the current induced across the resistor R immediately afterward? c. A bar magnet is brought close to the circuit shown in Figure P32.68C. What is the direction of the current induced across the resistor R?arrow_forward1. An inductor of 4 H and a resistor of 10 ohms are connected to a 20 V battery. The switch connecting all three in a circuit is closed at time t=0. a. What is the initial current in the circuit? b. What is the final steady state current in the circuit? c. What is the initial rate of increase of the current? d. What is the time constant? ISarrow_forwardWhat energy is stored in an inductor of 40 mH when a current of 8 A is passing through it? O A. 160 mJ B. 1.28 J O C. 128 mJ O D. 12.8 J O E. 1.6 mJarrow_forward
- 4 The circuit given to the right has been on for a long time. a. Determine the energy stored in the capacitor. 12 mH 16 k2 18 k2 15 V 1.5μF. 9k 2 b. Determine the energy stored in the inductor. c. Determine how high you could lift a 1.0mg object on Earth if you could convert all of the capacitor's and inductor's stored energy into gravitational potential energy.arrow_forwardThe voltage across an inductor is 4.0 x 10-6 V when the current through it decreased at a rate of 4.0 A/s. a. Determine the inductance of the inductor. b. Draw an illustration of the problem.arrow_forwarda. What is the voltage output (in V) of a transformer used for rechargeable flashlight batteries, if its primary has 510 turns, its secondary 8 turns, and the input voltage is 120 V? b. What input current (in mA) is required to produce a 4.00 A output? c.What is the power input (in W)?arrow_forward
- W R₂ a a. What is the potential drop on the inductor? R₁ m Two resistors, R₁ = 125 § and R2 = 325 92, an inductor L = 3.7 mH, a 16 V battery, and a switch are connected as shown above. The switch has been in position a for a long time. What is the current through resistor R₁? What is the current through resistor R₂? Submit Answer Tries 0/10 L b. At time t = 0s the switch is moved to position b. What is the time constant of the RL circuit obtained? Submit Answer Tries 0/10 c. Find the current in this RL circuit when the time t is three-quarters of the time constant from part b. Submit Answer Tries 0/10 d. At what time has the current decayed to 0.75% of its initial value? Submit Answer Tries 0/10arrow_forwardAnswer the following questions regarding the DC circuit shown in Figure 1. 6052 R Ω P₁ 100 mA P₂ 50 92 200 mA I Figure 1 DC circuit P3 100 mA flows through 60 2 resistor and 200 mA flows through the 50 2 resistor. 1. What is the current flowing out from the battery? 2. What is the voltage difference between point P₁ and P₂? 3. What is the voltage difference between point P₁ and P3? 4. What is the voltage of the battery? 5. What is the resistance of resistor R? Hint: Consider the current flowing through resistor R.arrow_forwardAn inductance L, a capacitance C, and a resistance R are connected in series with a voltage source V(t). Given that q(0) i(0) 0, what is the second order differential equation whose solution is the current i(t) where t> 0? a. L+ IR + = 0 b. L+ iR + = v(t) +R d. e. None of the abovearrow_forward
- The current in an 80-mH inductor increases from 0 to 60 mA. How much energy is stored in the inductor? A.0 J B. 2.4 mJ C. 144 uJ D. 4.8 mJarrow_forwardI don't feel so good. A 32.0 [2] resistor, a 0.40 [H] inductor, and a 20.0 [F] capacitor are connected in series to form an LRC circuit. Which of the following best describes the charge vs. time plot of the circuit? O A. q 24 OB. O C. O D. A. B. C. D. q 9 9 t tarrow_forwardYour RL circuit has a characteristic time constant of 21.5 ns, and a resistance of 5.40 MΩ. A. What is the inductance (in H) of the circuit? B. What resistance (in MΩ) should you use (instead of the 5.40 MΩ resistor) to obtain a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning