The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect mass and friction of the pulley)Given:Weight of A=230 lb.Weight of B=300 Ib.Calculate:a) acceleration of A (ft/s"), 30° with the horizontalb) Acceleration of B (ft/s"), downwardc) the tension in the cable (Ib.)B30°

The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect mass and friction of the pulley) Given: Weight of A=230 lb. Weight of B=300 lb. Calculate: a) acceleration of A (f/s"), 30° with the horizontal b) Acceleration of B (ft/s"), downward c) the tension in the cable (Ib.)

The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect mass and friction of the pulley) Given: Weight of A=230 lb. Weight of B=300 lb. Calculate: a) acceleration of A (f/s"), 30° with the horizontal b) Acceleration of B (ft/s"), downward c) the tension in the cable (Ib.)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
The mass of the A gear is 10 kg and the turning radius is 200 mm. Of gear Bits mass is 3kg and the turning radius is 80 mm. When the system is stationary to gear B. Moment of 6 N.m is applied. By neglecting friction; a) The time elapsed until the angular velocity of gear B reaches 600 rpm.b) Find the tangential force from gear B to gear A.
In the figure above, blocks A and B have 50 and 10 kg respectively. It is given that thecoefficients of friction between all surfaces of contact are static friction=0.4 and kinetic friction=0.3.a) If P=0, determine the acceleration of B and the tension in the chord?b) If P=10, determine the acceleration of B and the tension in the chord?c) If P=100, determine the acceleration of B and the tension in the chord?
block C mass = 99 kg block D mass = 66kg horizontal force (H) = 555N and is applied at block D. Angle = 32.779 degrees note: Ignore friction. Computations must follow D'Alembert's Principle or else the solution is null and void. And answers should be in Newtons or KiloNewtons 1.) Calculate the Normal Force of Contact between blocks D and C. 2.) Determine the Block D Acceleration 3.) Determine the Block C Acceleration
Two box hang from the ends of a string suspended from a frictionless pulley. The mass on the left is chosen to create a tension of 4 N in the string. The box on the right has a weight of 2 N. What will be the acceleration of the box on the right? Assume the acceleration of gravity is 9.8 m/s?. 4 N 2 N
FIGURE BELOW shows the car having a mass of 1.40 Mg and a center of mass at Gc pulls a loaded trailer having a mass of 0.8 Mg and a mass center at Gt. a) Draw separate free body diagram showing all forces acting on the car and trailer b) Calculate the acceleration of the car and trailer c) Develop equation of motion to determine the normal reactions on both the car's front and rear wheels and the trailer's wheels if the driver applies the car's rear brakes C and causes the car to skid. Assume μc = 0.4 and assume the hitch at A is a pin or ball-and-socket joint. The wheels at B and D are free to roll. Neglect their mass and the mass of the driver.
The friction coefficient between the 3kg object and the 2kg blocks in the figure is 0.3. the horizontal plane and the rollers are frictionless and the masses move from rest. a) Find the acceleration of each blokları by showing the forces acting on each block (free body diagram). b) Find the tension in the ropes. (g = 3,8m / s^2)
weighs 60 N on Earth. (3). A system consists of a pulley (vertical wheel) that is only allowed to rotate (spin). A cord is passed over the pulley and at each end there is a mass attached to the end of the cord. The mass attached on the left is m, =0.6 kg and at the right the mass is m2 = 0.8 kg. a) Calculate both the Tension in the cord and the acceleration of the system. b) What are the accelerations of both masses, if you were to cut the cord? Neglect the friction between cord and wheel,
A 25.5 kg mass (m) is suspended by the cable assembly as shown in the figure. The cables have no mass of their own. The cable to the left (T) ) of the mass makes an angle of 0.00 with the horizontal, and the cable to the right (T;) makes an angle (02) of 40.6. If the mass is at rest, what is the tension in each of the cables, T and T; ? The acceleration due to gravity is g = 9.81 m/s?. T T = 123.52 N 123.52 TOOLS x10
In the arrangement in the figure, the reels 'a 'and 'b' are pulled at VA m/s and VB =12 m/s. since there is no friction between the block and the surfaces; a) find the velocity and acceleration of block c when roller a moves 60mm to the left and roller b moves 90mm to the right b) find the rope force acting on the cable. (a=30°)
Consider the system shown below. Block A weighs 95.0N and block B weighs55.0N. Once block B is set to downward motion, it descends at a constant speed.A) Calculate the coefficient of kinetic friction between block A and the tabletop.B) A dog, also of weight 95.0N, Falls asleep on top of block A. If block B is now setinto downward motion, what is its acceleration (magnitude and direction)?
pls send me answer of this question all the parts pls and i will rate you sure, pls solve a,b,c and d and also a and b A 200-kg dragster (racing car) exerts a constant force of 4000 N during a race. The coefficient of kinetic friction between the tires and the pavement is .15. If the drag strip is 1000 m long, determine:a. The net force on the dragster. b. The acceleration of the dragster. c. The time it takes for the dragster to finish the race.d. The dragster's velocity at the end of the race.The dragster now needs to slow down, so it opens a parachute. The force of air drag is 3500 N. The driver also locks the brakes of the dragster, and the coefficient of kinetic friction becomes .75. Determine:a. How long it will take to stop the dragster.b. The distance the dragster travels while stopping.