Traffic and Highway Engineering
5th Edition
ISBN: 9781305156241
Author: Garber, Nicholas J.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 9, Problem 19P
To determine
The level of service of a two lane section.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A particular roadway segment has a 6000-ft section of 3% upgrade, followed by a 5000-ft section of 5% upgrade. The traffic on the road includes 8% trucks and 4% recreational vehicles. Determine the PCEs.
when desiging an auxiliary lane, the deceleration length need to be determined. Briefly explain what is the deceleration length and how to determine it
A developer has applied for a construction permit to build a supermarket at the southeast cornerof an intersection that is formed by a four-lane divided highway in the east-west direction and atwo-lane road in the north-south direction. Traffic on the two-lane road is controlled by a stop signat the intersection. The speed limit on the four-lane highway is 88 km/h. using the sight trianglerequirements at the intersection (Case B1), determine whether permission should be given for theconstruction if the following conditions exist. Provide a diagram for your solution.Major road lane width = 3.6 mMinor road lane width = 3.3 mMedian lane = 2.8 mDesign vehicle is a passenger carApproach grade = 2%Maximum feasible distance building from the center of the nearest lane of four-lane road = 5.4 mMaximum feasible distance building from the center of the nearest lane of two-lane road = 16.5 m
Chapter 9 Solutions
Traffic and Highway Engineering
Knowledge Booster
Similar questions
- How many diverging conflicts are present at a 4-leg intersection where each leg is a single lane approach, as shown above? Response Feedback: NBTH with NBLT, NBTH with NBRT EBTH with EBLT, EBTH with EBRT SBTH with SBLT, SBTH with SBRT WBTH with WBLT, WBTH with WBRTarrow_forwardAn existing rural freeway in rolling terrain is to be analyzed to determine LOS using the following information: Number of lanes in each direction: 2 Peak hour volume: 2640 veh/h 18% trucks 2% recreational vehicles PHF _ 0.91 Lane width: 12 ft Lateral clearance: 10 ft Average interchange spacing: 3 miarrow_forwardDetermine the PTSF in each direction for a 4.5 mi (7.2 km) two-lane highway segmentin level terrain. Traffic volumes (two-way) are 1100 veh/h. Trucks: 10%; RVs: 7%; PHF:0.97; directional split: 60/40; no passing zones: 40%.arrow_forward
- 55 mph roadway with two northbound through lanes (both are 11 feet in width) through an intersection. Beyond the intersection, the lanes merge into one lane. Please calculate the merge taper AND the distance the sign must be place AHEAD or upstream of the beginning of the merge. Pls hand written solutionarrow_forwardAn existing urban freeway in rolling terrain is to be analyzed to determine LOS using the following information: Number of lanes in each direction: 3 Peak hour volume: 3300 veh/h (in the peak direction, mainly commuter traffic) 8% trucks 2% recreational vehicles PHF=0.95 Lane width: 11 ft Lateral clearance: 4 ft Average interchange spacing: 1.0 mile Base FFS: 70 mpharrow_forwardA horizontal curve of 250 m on a road section is operated under the posted speed of 80 km /hr . The field study shows that there is no enough ROW to realigned the curve for any instances if the new posted speed will be equal to the design speed , knowing that the posted speed is the 85 ^ (th) percentile of design speed . Is it possible that the vehicle can operate at the new posted speed ?arrow_forward
- Two adjacent signalized intersections along a major arterial are 650 ft apart (stop line to stop line distance). If the space mean speed between these two intersections is 22 mph, what should be the signal offset of the downstream intersection relative to the upstream intersection? Group of answer choices 20.0 sec 13.5 sec 40.0 sec 29.5 secarrow_forwardA six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 1 ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service? (Write the letter only)arrow_forwardA new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?arrow_forward
- 6.14 A freeway segment currently has four 11-ft wide lanes and a 3-ft right shoulder in the southbound direction. It is operating in LOS B with a traffic density of 15.6 pc/mi/ln and a peak-hour factor of 0.85. The freeway is on level terrain with 15% heavy vehicles, and currently has no on- or off- ramps within a distance of three miles upstream and downstream of the mid-point of the analysis section. New interchanges are to be constructed that would result in 6 on- and off-ramps within the distance of three miles upstream and downstream of the mid- point of the analysis section and total traffic volume is projected to double, with the same percentage of heavy vehicles, and the peak-hour factor going to 0.95. What would the new LOS and density be after the interchange construction and new traffic conditions?arrow_forwardThe following diagram illustrates the number of conflicting points at a 4-approach unsignalized intersection with one lane for each approach. The conflicting points are classified as points for merging, diverging, and crossing. How many conflict points will there be if the intersection geometry is changed to two off-set “T” intersections? Scratch your solution and label all conflicting points by classification.arrow_forwardAn existing Class I two-lane highway is to be analyzed to determine the level of servicein each direction, given the following information:Traffic data:PHV = 600 veh/h60% in the peak direction8% trucks2% recreational vehiclesPHF = 0.86No passing zones: 40%Geometric data:Rolling terrainBFFS = 55 mi/h (88 km/h)Lane width = 11 ft (3.3 m)Shoulder width = 2 ft (0.6 m)8 access points per mile (5 access points per km)arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning