There is a compressed spring between two laboratory carts of masses m1 and m2. Initially, the carts are held at rest on a horizontal track (Fig. P10.40A). The carts are released, and the cart of mass m1 has velocity
a. What is the net external force on the two-cart spring system?
b. Find an expression for the velocity of cart 2.
c. Sometimes, mistakes are made in a laboratory. For example, what changes in parts (a) and (b) if the track is not level as shown in Figure P10.40C? Explain your answer.
Trending nowThis is a popular solution!
Chapter 10 Solutions
Physics for Scientists and Engineers: Foundations and Connections
- (a) The springs of a pickup truck act like a single spring with a force constant of 1.30105 N/m . By how much will the truck be depressed by its maximum load of 1000 kg? (b) If the pickup truck has four identical springs, what is the force constant of each?arrow_forwardTable P16.59 gives the position of a block connected to a horizontal spring at several times. Sketch a motion diagram for the block. Table P16.59arrow_forwardA small ball is tied to a string and hung as shown in Figure P8.34. It is released from rest at position 1, and, during the swing, the string meets a fixed peg as shown. Explain why position 2 at which the ball comes momentarily to rest must be at the same height as position 1.arrow_forward
- A block of mass m = 2.00 kg is attached to a spring of force constant k = 500 N/m as shown in Figure P7.15. The block is pulled to a position xi = 5.00 cm to the right of equilibrium and released from rest. Find the speed the block has as it passes through equilibrium if (a) the horizontal surface is frictionless and (b) the coefficient of friction between block and surface is k = 0.350. Figure P7.15arrow_forwardThe position of a particle attached to a vertical spring is given by y=(y0cost)j. The y axis points upward, y0 = 14.5 cm. and = 18.85 rad/s. Find the position of the particle at a. t = 0 and b. t = 9.0 s. Give your answers in centimeters.arrow_forwardA uniform annular ring of mass m and inner and outer radii a and b, respectively, is pivoted around an axis perpendicular to the plane of the ring at point P (Fig. P16.35). Determine its period of oscillation. FIGURE P16.35arrow_forward
- A mass on a spring undergoing simple harmonic motion completes 4.00 cycles in 14.0 s. a. What is the period of motion for this system? b. What is the frequency, in hertz, of this system? c. What is the angular frequency of this system?arrow_forwardA 0.250-kg block along a horizontal track has a speed of 1.50 m/s immediately before colliding with a light spring of force constant 4.60 N/m located at the end of the track. (a) What is the springs maximum compression if the track is frictionless? (b) If the track is not frictionless, would the springs maximum compression be greater than, less than, or equal to the value obtained in part (a)?arrow_forwardFish are hung on a spring scale to determine their mass. (a) What is the force constant of the spring in such a scale if it the spring stretches 8.00 cm for a 10.0 kg load? (b) What is the mass of a fish that stretches the spring 5.50 cm? (c) How far apart are the half-kilogram marks on the scale?arrow_forward
- A bullet with a mass ?b=13.1 g is fired into a block of wood at velocity ?b=253 m/s. The block is attached to a spring that has a spring constant ? of 205 N/m. The block and bullet continue to move, compressing the spring by 35.0 cm before the whole system momentarily comes to a stop. Assuming that the surface on which the block is resting is frictionless, determine the mass ?w of the wooden block.arrow_forwardA block of mass 2.1 kg is sitting on a frictionless ramp with a spring at the bottom that has a spring constant of 525 N/m (refer to the figure). The angle of the ramp with respect to the horizontal is 12 degrees. a. The block, starting from rest, slides down the ramp a distance 68 cm before hitting the spring. How far, in centimeters, is the spring compressed as the block comes back to momentary rest? b. After the block comes to rest, the spring pushes the block back up the ramp. How fast, in meters per second, is the block moving right after it comes off the spring? c. What is the change of the gravitational potential eneregy, in joules, between the original position of the block at the top of the ramp and the position of the block when the spring is fully compressed?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningClassical Dynamics of Particles and SystemsPhysicsISBN:9780534408961Author:Stephen T. Thornton, Jerry B. MarionPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University