The following chart represents the Dynamic Amplification Factor (DLF) of pulses type Ramp. Time from 0 to Maximum force: td Natural Period of the structure: T What is the maximum dynamic displacement of a structure with: stiffness, k, of 150 kip/in mass, m=50/g k-sec^2/in g: gravity acceleration The ramp force reach the maximum force F=100kip in a time td-0.15 sec

The following chart represents the Dynamic Amplification Factor (DLF) of pulses type Ramp. Time from 0 to Maximum force: td Natural Period of the structure: T What is the maximum dynamic displacement of a structure with: stiffness, k, of 150 kip/in mass, m=50/g k-sec^2/in g: gravity acceleration The ramp force reach the maximum force F=100kip in a time td-0.15 sec

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Given the vibrating system below: K1 K3 K4 Find the following 1. Keq 2. Ceq 3. Natural angular velocity K2 m C1 C3 C5 C2 C4 4. Damped angular velocity 5. Type of Damping 6. Equation of motion x(t). Assume Initial conditions for displacement and velocity Graph 2 cycles of the vibrating system. You can use third party app for this. 7. M = 10 kg K1=100 N/m K2= 80 N/m K3=75 N/m K4= 120 N/m C1 = 20Ns/m C2= 40 Ns/m C3= 35Ns/m C4= 15 Ns/m C5= 10 Ns/m
Dtes 6) Take a look at the picture below. Initially the system is at rest. The spring is activated and sends the mass moving with tangential speed "v" and the disk rotating with angular velocity "w". Find expressions for these parameters in terms of the variables given. Final I nitind At Rest Dişk Rolutes Sprivag: compressx a mass と szring Cons & ingetid velocty muss Rotafiond ふnertiu ofDk
MA Figure (2) 3- The time response of a liner spring-mass-damper system with the mass of (m), the stiffness coefficient of (k), and a dampirg constant of (c) is given below in figure (2) with a set of coordinates marked by fillec circles. x(t) is in meters, it is in seconds. Indicate the units of all quantities involved in your solutions when calculate 0 -1- (0.53, 1.78) (0,0.8) 2 (2.1,-1.3) (3.7,0.9) L 4 (5.3,-0.7) - The damping ratio of the system. Its natural frequency w., damping corstart c, and stiffness coefficient k; for (m-1.25 kg). III- The amplitude of the motion if the phase angle is given as (0.4 rad). IV. Its initial conditions. (6.86, 0.5) 10 t[sec]
PIoVide ue comect u We want to design an experiment to measure oscillations of a simple pendulum on the surface of Jupiter with acceleration due to gravity g= 30 ms 2. We have to make do with a rudimentary video camera with a frame rate of 15 Hz to record oscillations in a pendulum and use it to measure the frequency of oscillation. The smallest length of the pendulum that we can send so that the correct oscillation frequency can be measured is cm. Assume perfect spatial resolution of the camera and ignore other "minor" logistical difficulties with this experiment.
The response of a certain dynamic system is given by: x(t)=0.003 cos(30t) +0.004 sin(30r) m (5Mks) Determino: (i) the amplitude of motion. (2Mks) (ii) the period of motion. (in) the linear frequency in Hz. (4) the angular frequency in rad/s. (2Mks) (2Mks) (2Mks) (2Mks) (v) the frequency in cpm. (vi) the phase angle. (2Mks) (vii) the response of the system in the form of x(t) = X sin(t +$) m.
ponse Clear selection A block attached to a spring, oscillates on a frictionless horizontal surface with a period of 0.3 s. The time needed by the block to move (for the first time) from position x = A to x = -A/2 is: O 0.2 sec 0.3 sec 0.05 sec 0.1 sec O 0.15 sec
The complete slide- back and forth motion of a single reciprocating compressor piston completes in a 2-sec period. The volume displacement of the piston though the piston cylinder is 8,902.63 in3. The stiffness of crank is said to be equal to 65.5N/m and the mass of the said piston is at 10kgs. Obtain the following 1. Plot the graph of the following relationship: A) Position vs Time graph B) Velocity vs Time C) Acceleration vs Time
2. The equation of motion for a damped multidegree of freedom system is given by Where [m] = [m]{x} + [c]{x} + [k]{x} = {f} [100 = 0 0 0 10 0 10. 1000-4 {f} [c] 8 –4 0 8 – 4 -4 4 0 8 4 = 100 2 0 = Focos(wt) -2 -2 The value of Fo 50N and w 50 rad/sec. Assuming the initial conditions to be zero and using the modal coordinate approach, find out the steady state solution of the system in the modal coordinate for first mode. Plot the steady state solution using the computational tools. 0 −2], [k] = = 2
Q5:- in the fig M= 20 kg, c-7 N.s/m, k=10 N/M, the excitation is 10 sin5t, find natural frequency, excition frequency Excitation force, is the device in the resonse Frequency, Is the device under damping? Find the equation of motion A typical accelerometer Schematic of an accelerometer
Given the vibrating system below: K4 Y(t) =Ysin30t where for = 30 and Y=20mm Find the following K1 K2 m C3 H C2 C1 C5 C4 1. Frequency Ratio 2. Displacement Transmissibility Ratio 3. Absolute displacement of the mass 4. Type of Damping 5. Equation of motion x(t). Assume Initial conditions for displacement and velocity 6. Graph 2 cycles of the vibrating system. You can use third party app for this. M = 10 kg K1=100 N/m K2= 80 N/m K3=75 N/m K4= 120 N/m C1 = 20Ns/m C2=40 Ns/m C3= 35Ns/m C4= 15 Ns/m C5= 10 Ns/m
1. Find: Vs, wa/c, and wa/A Use relative motion analysis OR Instantaneous center of rotation Given: 0= 58° @=39° BC=3m AB=9m V₁ = 12 m/s your choice mak 437 B
A force of 20 newton stretches a spring 1 meter. A 5 kg mass is attached to the spring, and the system is then immersed in a medium that offers a damping force numerically equal to 10 times the instantaneous velocity. 1) Let x denote the downward displacement of the mass from its equilibrium position. [Note that x>0 when the mass is below the equilibrium position. ] Assume the mass is initially released from rest from a point 3 meters above the equilibrium position. Write the differential equation and the initial conditions for the function x(t) 2) Solve the initial value problem that you wrote above. 3)Find the exact time at which the mass passes through the equilibrium position for the first time heading downward. (Do not approximate.) 4)Find the exact time at which the mass reaches the lowest position. The "lowest position" means the largest value of x