i need the answer quickly Q.24: 380V, 3-0. 4-wire ABC system loaded with: 1st load is balanced Y-connected (15Z30°Q) for each phase, 2nd load is(ZAN=15Z30°Q. ZBN=15Z-30°Q, & ZCN=15Z0°Q), and 3rd load is 3-0induction motor A-connected with 50HP, 75% efficiency, &. 0.75 p.f., thenY-connectedcalculate the total line currents.

In this question, 3 loads are connected in the parallel to the 380V, We need to calculate the line…

Q.24: 380V, 3-0. 4-wire ABC system loaded with: 1st load is balanced Y- connected (15Z30°Q) for each phase, 2nd load is Y-connected (ZAN=15230°Q. ZBN=15Z-30°Q, & ZCN=15Z0°Q), and 3rd load is 3-0 induction motor A-connected with 50HP, 75% efficiency, &. 0.75 p.f., then calculate the total line currents.

Q.24: 380V, 3-0. 4-wire ABC system loaded with: 1st load is balanced Y- connected (15Z30°Q) for each phase, 2nd load is Y-connected (ZAN=15230°Q. ZBN=15Z-30°Q, & ZCN=15Z0°Q), and 3rd load is 3-0 induction motor A-connected with 50HP, 75% efficiency, &. 0.75 p.f., then calculate the total line currents.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
Problem- Basics of Chopper & Types Calculate the R.M.S value of the fundamental component of current in a single phase Half bridge having a resistive load of 109 and supplied by an input DC voltage of 50V?
Q2) Three shunt generators operate in parallel and supply a load current of 12000 A, connected across the bus-bars. Details of the generators are given below, Generator A Generator B Generator C Eg4 = 450 V EgB = 460 V = 410 V 0.02 N Raa = Ras = 0.025 A Rac = 0.01 %3D Egc a) Calculate the load voltage (bus bar voltage). b) Find the current supplied by each generator. c) Determine the output power (in Kw) for each machine
4 Q₁/ A 3-phase, 11 kv, 1.2 MVA, S.G its star connected- armature winding has effective resistance of 9% from Syn. impedance and syn. reactance of 50 52. Find VR% at half load (U.P.f and 0.8 lagging P.f.) of Raz0109 Zi 2₁²= R + X5² Z₁ = (010923) + X² 1 50 Zs: v Ra=01092₁ €54.9
two synchronous generators are connected in parallel, feeding a load together. the frequency of the first generator in the no-load State is 52 Hz and the slope of the characteristic is 1 MW/Hz. the total power of the load fed by these two generators is 2.5 MW and the power coefficient is 0.6 inductive. by drawing the characteristic curve of the system;a) what is the frequency of the system when the load in question is fed, and how do the two generators share the load between themselvesb) if a load of 0.5 MW is added to the system, find the operating frequency of the new system and the powers given by each generatorc) if a second load of 0.5 MW is connected to the system, the idle operating frequency of the second generator is increased by 0.5 Hz, what happens to the operating frequency of the system and the power values given by the generators
50KVA, 380V, 3 phase, 50HZ, wye connected, 4 pole round rotor synchronous generator have 0.60 synchronous reactance. The internal resistance can be neglected. a. Sketch the equivalent circuit b. Calculate the nominal current c. Calculate the excitation voltage at full load for cos p =0.86 (lagging). d. Sketch the phasor diagram and mark relevant angles (4, 6, 4) e. Calculate the induced power in the machine. f. Calculate the induced torque in the machine.
A 381 V, 50 Hz, Y-connected, eight poles synchronous generator has the OCC given in tabular form below (Phase Voltage versus the field current). The generator has a per-phase synchronous reactance of 2.0 0, and an armature resistance of 0.2 Q. The machine supplies a 30.36 KVA load, at 0.8 PF lagging. How much field current must be supplied to the generator to keep the terminal voltage at 381 V? EA. (V) 65 125 260 290 320 350 380 420 450 470 IF. (A) 0.00 0.5 1.0 2.0 2.25 2.55 2.7 3.0 3.7 4.1 4.25 Select one: O a. Ip = 3.0 A O b. Ip = 3.2 A O c. Ip = 2.25 A O d. None
Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be 270 V O 267.5 V O 265 V O 257.4 V O
Two generators are supplying a load. Both the generators have a no-load frequency of61.5 Hz and the slope sp of 1 MW/HZ. If they are supplying a real load of 2.0 MW at 0.8 pflagging, what would be the system frequency and power sharing between two generators?What measures can be taken to make the frequency 60 HZ. If an additional 1.0 MW load isconnected to the existing one what would the system frequency be.
2. A synchronous generator is connected to an inductive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage across the load. If the same generator is connected to a capacitive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage cross the load again. Explain the difference of the terminal voltage responses at these two types of loads.
A 3-phase 60 Hz I.M. has a rated speed = 1650 R.P.M., its speed at slip = -0.15 is equal to:
In a single-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. [7,898 V; 19.7%] (Elect. Machines-II, Indore Univ. Dec. 1977) A 500-V, 50-kVA, single-phase alternator has an effective resistance of 0.2 N. A field current of 10 A produces an armature current of 200 A on short-circuit and e.m.f. of 450 V on open circuit. Calculate (a) the synchronous impedance and reactance and (b) the full-load regulation with 0.8 p.f. lagging. [(a) 2.25 N, 2.24 2, (b) 34.4%] (Elect. Technology, Mysore Univ. 1979)