Juggles the clown stands on one end of a teeter-totter at rest on the ground. Bangles the clown jumps off a platform 2.7 m above the ground and lands on the other end of the teeter-totter, launching Juggles into the air. Juggles rises to a height of 3.4 m above the ground, at which point he has the same amount of gravitational potential energy as Bangles had before he jumped, assuming both potential energies are measured using the ground as the reference level. Bangles' mass is 96 kg. What is Juggles' mass? hB hs

Juggles the clown stands on one end of a teeter-totter at rest on the ground. Bangles the clown jumps off a platform 2.7 m above the ground and lands on the other end of the teeter-totter, launching Juggles into the air. Juggles rises to a height of 3.4 m above the ground, at which point he has the same amount of gravitational potential energy as Bangles had before he jumped, assuming both potential energies are measured using the ground as the reference level. Bangles' mass is 96 kg. What is Juggles' mass? hB hs

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

4G 0:09 EV K/s Quiz 2.pdf > Q1: Determine the moments about point ( A) due to the forces applied on the cantilevered beam. 4 kN 30 130° 2 m 6 kN 2 m 2 m
Determine the Centroidal Moment of Inertia of the body shown.
Engineering Mechanics, Statics Chapter 3: Equilibrium of a Particle EXAMPLE 3.2.2-10 If the tension developed in each of the four wires is not allowed to exceed 600N, determine the maximum mass of the chandelier that can be supported. B. 450 FIGURE OF EXAMPLE 3.2.2-10
A long, straight wire lies along the x-axis and carries current I=55.0 A in the +x-direction. A small particle with mass 4.00 x 10-6 kg and charge 8.00 x 10-3 C is traveling in the vicinity of the wire. At an instant when the particle is on the y-axis at y = 9.00 cm, its acceleration has components a = -5.00 x 103 m/s² and ay = +9.00 x 103 m/s² Part A ۵ At that instant what are the x- and y-components of the velocity of the particle? Express your answer in kilometers per second. Enter your answers numerically separated by a comma. ΜΕ ΑΣΦ Uz. Vy= - 23.6, 41.7 - Submit Previous Answers Request Answer ? km/s
125 mm 125 mm mm 12 mm 100 mm 12 mm 75 mm 5 mm 75 in 12 mm Find the moment of inertia about the y-axis
A popular amusement park ride, called The Graviton, has you spinning at a constant rate while the whole ride is tilting left and right. Is there an equilibrium present?
Of the following statements below, which attributes regarding the interaction between the book and the table (typical of objects in uniform contact) is not true? magnitude - both forces have the same unknown magnitude labeled NBT direction - both of these forces act in the direction normal to the contacting surfaces, in this case vertical sense - the table exerts a downward force on the book (toward the book); the book exerts an upward force on the table (toward the table) point of application - at the center of the area of contact: the force on the book is at its bottom; the force of the table is on its upper surface
A sphere is placed over the three closely packed identical spheres on a horizontal plane. All the spheres are identical both in weight and size. If one sphere weighs 100-N, determine the contact reaction between the upper and bottom spheres in N. A 80.24 B 24.80 42.08 16.80 18.42 (F) 28.04 163.30 H. 40.82
98% ?. l3Ī 7 I 16:58 Month 1.pdf Q1:- The coplanar force system shown in Figure below is subjected to a couple moment (M) and three forces. Two forces are known in magnitude and direction and shown in the Figure (150 N and 60 N). The third force is passing through the center of the semi-circle (point C). The resultant of all these forces is a single couple (750 N.m) counterclockwise. a) Determine the magnitude and direction of the third force. b) Determine the magnitude of moment (M). Replace the couple (M) by two vertical equal forces acting at D and E. d) Replace the force (150 N) by and single force at D and a couple. Radius = 5 m 150 N E В M 60 N 4 A F. Q2:- Determine all forces acting on member DEF of the frame shown in Figure below:- 150 Ib/ft F3.0 m -3.0 m
Calculate all the reactions of the three- dimensional frame and for the node in red the translation about the y-axis, and the rotation about the x-axis. Consider that all the beams are the same, square cross section of 10cm side, E=200GPa and v=0.3 USE THE UNITARY VIRTUAL CHARGING METHOD/ FLEXIBILITIES 15 m 10 kN/m y 30 X KN 6m 6 m 74 5 kN/m 12 m
The beam AB in the Figure supports a load which varies an intensity of 220 N/m to 890 N/m. Calculate the magnitude of the resultant load.
The board rests on the surface of two drums. At the instant shown, it has an acceleration of 0.44 m/s? to the right, while at the same instant points on the outer rim of each drum have an acceleration with a magnitude of 4.7 m/s². If the board does not slip on the drums, determine its speed in m/s due to the motion. r = 11.3 in a r