18. Fit the data in the table below into the Greenshields' model and determine;(i) The maximum flow (Qmax)? [1849 veh/h](ii) The speed at which flow is maximum (Ucap)? [31.3 km/h](iii) The density at which flow is maximum (Keap)? [59 veh/h]Speed (us)(km/h)Density (k)(veh/km)53.22048.12744.83540.14437.35235.25834.16027.26420.47017.57514.68213.19011.21008.0115

I) The maximum flow, qmax=1852.416 veh/hr ii) Speed at which flow is maximum, u = 31.3 km/hr iii)…

Answered: 18. Fit the data in the table below…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1.) total head loss from A to D equal to 9m. The flow rate of the pipe system shown in the figure shown is 50 Liters/sec under a PIPES Length (m) Diameter (mm) Нazen, C A 400 200 130 366 160 130 290 ? 130 D 610 250 130 B) A) Determine the Following: d. Head loss of pipeline B. e. Discharge of pipeline C. f. Diameter of pipeline C.
2) A simple water distribution system is shown in the diagram below. Determine the flowrate (cfs) and direction of flow in each pipe and the pressure (psi) at each node. Node Demand (cfs) Elevation (ft) A 1.7 610 В 2.4 625 C 0.9 597 1.2 588 Pipe Diameter (in) Length (ft) f 0.017 1 16 200 2 14 2100 0.014 3 14 2100 0.014 4 14 2100 0.014 16 200 0.017 Pump (flow is from reservoir R to node D): hp = -0.625×Q² -1.25×Q+30 [ft] and [Q] cfs. Z = 727 ft ZR = 701 ft 1 3 В D
Q2: For a certain river, the following data were obtained for the cross section at a selected station: Station 0 1 2 3 4 5 6 X(m) 14 18 21 Y(m) 3 0 Velocity at 0.6 of the depth (m/sec) 0.4 0 0 0 3 6 2 0.5 0.7 4 10 6 0.6 For this cross section, estimate the discharge in cubic meter per second 5 0.5 0
PROBLEM 7 Water from a pipeline is diverted into a weigh tank for exactly 15 min. The increased weight in the tank is 4765 Ib. What is the average flow rate in (a) gpm? (b) ft³/s?
Explain the relationship for parameters in both the diagram. Uncongested flow Congested flow Kam 4 man Density (k) Flow Space Mean Speed (b) MOl
1.5h Q6: The figure represents a homogeneous earth dam with a horizontal filter. The construction cost per certain possible height (H) of this dam at a given site has been estimated and tabulated below. The storage capacity for all these heights is also given. Dam height (H) (m) 5 15 20 25 30 Construction cost (Million ID) 500 10 800 1100 1500 2200 3100 210 340 440 550 590 Storage capacity (Million m3) 100 The characteristics related to the reservoir upstream of the earth dam are: - - The wind velocity (V) = 50 Km/hr - A straight length of water expanse (F) = 35 Km Find the coordinates of the top seepage line (Phreatic surface). 2.5 2.5m 35 4100 680
At the confluence of two streams (A and B), TSS and flow measurements are made in stream A, one of the inflowing streams, with the results giving 238 mg/L TSS at a flow of 144 ft^/s. The same measurements are made in the river, D, below the confluence of the streams, giving 286 mg/L TSS at 212 ft3/s. Find the flow rate and TSS concentration in stream B.
Question: A sewage treatment plant for a town with 120000 population and water average temperature of 20 °C should be designed. You are asked to design a coagulation/rapid mixer and a flocculation tank with horizontal shaft paddle. The jar tests suggest average G-value of 30 (m/s)/m, minimum water residence time of 1500 seconds and GT value from 55000 to 90000. The flocculation tank should include 3 compartments with similar compartments' geometry aspects separated using baffles partitions. The width of each flocculation tank should not exceed 7 meters due to some constraints highlighted by the project's mechanical engineers about the maximum length of each shaft. Determine: 1- The volume and dimension and power requirement of the cylindrical rapid mixer 2- The flocculation tank dimension 3- Required power for each flocculation mixer 4- The paddle wheel dimension 5- Rotational speed of each mixers (Check if the speeds are acceptable) 6- Baffle size and distribution 7- Write about any…
Q2: The following macroscopic model (Q = 850 D-0.77 D2) has been obtained based on field measurement and using the Greenshield's method. Compute: (1) Density at maximum flow, (2) jam density, and (3) Flow at 50 veh./km ww density.
From the given three reservoirs shown. The elevation A is 346 m., B is at elevation 301 m and C is at elevation 241 m. Rate of flow at 1 is 200 liters/sec. PIPE LENGTH (M) DIAMETER HAZENS, C (MM) 450 600 120 3600 300 100 3 1200 D3 110 Determine the diameter of pipeline 3. 175 mm 177 mm O 180 mmm O 184 mm None of the above
Compare the cost of pumping a fluid "A" between two points at the same volumetric rate in 10 cm and 15 cm diameter pipes having the same absolute roughness magnitude of 0.2 mm. The flow can be assumed to be in fully developed rough- turbulent regime. [Assume the pipes to be horizontal]
2.In a water treatment unit, the flow through a trapezoidal cross-sectional tapping channel, is connected by a pipe-carrying channel to a flocculation pond with the dimensions shown in Figure 1. If it is known that the bottom slope of the channel is 0.0013 and the n-Manning coefficient is 0.045, what is the diameter pipe in the conveyance to meet the speed requirement of 1 m/s ? 70 cm 1 50 cm

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS