An e.m.f. given by 326 sin 418 t is ap- plied to a certain circuit and the current is 2 sin (418t - T/3). The impedance of the circuit is (i) 100 2 (ii) 73·2 Q (iii) 163 Q (iv) 112-6 Q

Q: Determine the sinusoidal steady state current, i(t), for the circuit shown assuming the voltage…

A:

Q: Electrical Engineering Using AC steady state nodal analysis, find lo 42 V1 V2 V3 10 2V 12/0° V

A:

Q: 3. Use phasor analysis techniques to determine the steady-state current i (expressed in time…

A: In this question, we need to determine the load current in the RL as shown in the circuit.…

Q: The expressions for the steady-state voltage and current at the terminals of the circuit seen in the…

A: Given ,Vg=350 cos 5000πt+84°Vg=350∠84°ig=6 Sin 5000+127°ig=6 Sin 90+5000πt+37°ig=6 cos 5000πt+37°…

Q: Prove the following expression by using phasors: 10 cos(@t)+10sin(@t) = 14.14 cos(@t – 45°)…

A: The solution is given below

Q: t= 0 i(t) R 20 t= 20ms L Vbat 10V v(1) 400mH

A:

Q: The current source in the circuit shown in in Figure 1 is iş(t) = 30 cos(314t) A a) Constrict the…

A:

Q: 4. Use the node voltage method to find the steady state expression v.(t) in the circuit below if Vg1…

A:

Q: Use phasor analysis techniques to determine the steady-state current i (expressed in time domain),…

A: In this question, we need to determine the current in the inductive load AB.  Replace the circuit in…

Q: Using the information below; V, lags V, by: V,(t) = 120 cos(113t – 40) V½ (t) = 120 cos(113t + 40)…

A: Let's consider two time varying signals.  The time varying signals are denoted as x1t and x2t.…

Q: Consider the circuit below, which is in steady state. The source current, is(t) is given by is(t) =…

A:

Q: 8.3.9 For the RLC circuit shown in the image below, if R1 = 2 S2 and R2 = 10 S2, c = 0.10 F, and the…

A: We need to find voltage across resistor in given circuit.

Q: 10. A. Find the impedance between terminals a and b in the circuit below if it operates at steady…

A: Given data: Angular frequency = 2000 rad/s L=5 mH R2=20 Ω R1=5 Ω C=25 μF v(t)=10cos2000t (a)…

Q: A circuit has a large motor connected to AC power line (w-100 r/s). The motor model is a resistor in…

A: The impedance of the motor model will be  R2+(wL)2∠tan-1wLRputting the value we…

Q: 2. [Impedance] Given @ = 5 rad/s , determine the equivalent impedance, Z, for the circuit shown.…

A:

Q: QUESTION 4 The voltage and current at the input of a circuit are given by the expression 1) v(t) = 3…

A: Given: Voltage, vt=3 cos100t V Current, it=4 cos100t-45° A

Q: The current source in the circuit is given by v, (t) = 10 sin(2t + 30)V. Apply the phasor-domain…

A: In this question we will find voltage across inductor using phasor domain analysis technique...

Q: Use the node-voltage method to find the steady- state expression for v(t) in the circuit shown. The…

A:

Q: Q.1 The expressions for the steady-state voltage and current at the terminals of the circuit seen in…

A: Need to impedance and time.for current is out of phase with voltage

Q: 18 cos(800 t) V 140 mH 125 mH v(t) 120 2 5 µF 80 Ω

A:

Q: he zero-state scaled network shown in Figure 134 is driven by the sinusoidal current purce Jg(t)…

A:

Q: The device  is represented in the frequency domain bya Norton equivalent. When a resistor having an…

A: Given: The device  is represented in the frequency domain by a Norton equivalent. When a resistor…

Q: 5. Calculate the source current, real and reactive power and power factor seen by the source for the…

A: Given: Source Voltage Vs=150sin2π50t+30°R=100 ΩL=150 mHC=100 μF

Q: v0- 100 sin(10) at tKO v(0F 200 sin(100) att>0 A coil has been connected to an AC source for a long…

A:

Q: 2. Find i,(t) if v,(t) = -20 sin(25t – 30°) V %3D

A: It is given that: Vst=-20sin25t-30° V

Q: Find the steady-state is (a) w = 400rad/s, 100 cos (wt) mA 375 mH 12 cos (400 t) V 100 S2 ww vo(t) +…

A:

Q: The circuit below is operating in ac steady-state. The source voltage is Vz = 25/2 sin (4000t) v.…

A:

Q: Find the steady-state solution, VOUT Ss(t), for the network below if VIN(t) = 5 cos( 5t ) volts.…

A: As the given angular frequency be 5 rad/sec. find the different reactance,     Now, find the…

Q: An AC circuit has a source that has an angular frequency of 100 rad/s. The Thevenin impedance of the…

A: In this answer we will try to find which components are used to realize the Thevenin impedance and…

Q: Problem 2: Use the node-voltage method to find the steady state expression for v,(t) in the circuit…

A: Use the node-voltage method to find the steady state expression for v (t) in the circuit shown if gl…

Q: 12.26 In the circuit shown in Fig. 12.16, the dc current source is replaced with a sinusoidal source…

A:

Q: For the circuit shown in the Figure, if w = 10 rad/s, the thevenin impedance as seen by the…

A:

Q: Consider the circuit diagram where Vs = 2300 20 V 2 Z₂ Z₁₂ $ Z₂ 2 Find: 1. The apparent power…

A: In this question we need to find a apparent power delivered by source and input current of the given…

Q: Given that the AC sources in the circuit are operating at a frequency w = 5 rad/s, find the…

A:

Q: 1. If P= 12*R, that's mean the power exist on R

A:

Q: Let а — b + a +b a L{sin at cos bt} 2 s2 + (a + b)² s2 + (a – b)2 where a, b are constants. Find

A:

Q: For the circuit shown, what is the complex power, S, average power, P,av, and reactive power, Q,…

A:

Q: B: Find the waveform of the voltage V(t) in the circuit shown below given that: e(t)-2.5 sin(500t)…

A: The circuit is as shown below, Given, e(t) = 2.5sin(500t), i(t) = 1.414cos(1000t),

Q: 60 cos 3t V, what is the steady-state expression for vo? If vg %3D

A:

Q: Question 4. 20 2 Find steady-state expression for v, by using mesh-current method in the phasor…

A:

Q: R1 3 kN L1 3 mH ww C1 R3 1 kN v(t) 6 μF R2 2 kN ww

A:

Q: A) Consider the following characteristic equation: Q(s) = s5 + 254 + 2s3 + 4s2 +11s + 10 Discuss the…

A:

Q: Use Routh-Hurwitz method, how many roots are on the jw axis by the polynomial equation: 53 + 2s? +…

A: Construct routh Hurwitz table and than find no .of roots on the jw axis.

Q: The circuit given below is operating in the sinusoidal steady state. Find the value of w if i, =…

A: Given: A circuit operating in sinusoidal steady state. According to question: ∵io=40sinωt+21.870mAIn…

Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…

A:

Q: V=20/150° -302-60° V. Represent V in single phasor and find the time domain expression v(t) when the…

A:

Q: An LTI system is described by the following linear constant-coefficient differential equation. Its…

A:

Q: The zero-state scaled network shown in Figure 131 is driven by the sinusoidal voltage source Eg(t)…

A: The current in the loop can be calculated by using mesh analysis after finding the impedance of the…

Q: 763 Model a RL series circuit and find out the current expression through the system. Assume R=1;…

A:

Q: The phasor current I, is 5445° A. 1. Find Ia. Ies and Vg. 2. If w = 800 rads/s, write the…

A:

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.