Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms

Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…

A: Given data, Frequency f = 50 Hz

Q: The power received by the receiving antenna is 10-4 W. Transmitting and receiving antennas have gain…

Q: 7. One in which more than two specific devices share a single link a. Point-to-point connection c.…

A: We need to select correct option for given statement

Q: Two identical 20 MW alternators operate in parallel. The governor of first machine is such that the…

Q: A particular pn junction at T = 300 K is doped with impurity concentrations of Na = 1.2 x 10¹4 cm³…

A: Given,T=300 KNd=1.2×1014 cm-3Na=2×1014 cm-3po=1.1×1014 cm-3Vt=25 mV∈s=13.1 ∈0

Q: Using current divider for the below circuit 5 mA R₁ 2 kn V₁ R₂ 3 ΚΩ

A: Given data, Circuit diagram is given as,

Q: Given V₂ = -5.37 V, use Kirchhoff's Laws to find the current I, (in Amps). 5 V + I www Vx + Ix + 5…

A: The given circuit is,

Q: What is the effect on the signal-to-noise ratio of a system (in dB) if the bandwidth is doubled,…

A: Given If we double the Bandwidth then what will be S/N

Q: [H-W3:] show that V. (1)= [R²2 V₁ (4) + [CR₂ + 1 ] dvi (4) Ri at + Lc d²vict) dt² for the circuit…

Q: Paralleling of two generator step by step

Q: 2. Find the math model for the following system. Assume: R₁ = R₂=R3=R4 =1√² X(t) AM RI m R2 R3 + R4…

Q: Q2) Tick the correct answer for the following statements 1. An ideal transformer is connected to a…

A: Given: Ideal transformer is connected to a 50 V battery, while the load is 100 Ω. the turn ratio is…

Q: In a series circuit, you measure 9 volts across a 300 ohm resistor. How much current is flowing…

A: Given: A series circuit with, Measured voltage, V=9 volts. Resistance, R=300 Ω.

Q: The pathway for a binary electrical signal between gates in an integrated circuit can be modeled as…

A: I am answering only question no 8 which is related to electrical engineering and other is related to…

Q: 12 V + 0.2 A 12 V Calculate the power associated with the Device. Device

A: The given circuit is,

Q: Two identical 20 MW alternators operate in parallel. The governor of first machine is such that the…

A: Condition of parallel operation of the alternator Common terminal voltage The phase sequence of…

Q: I. Problem solving. Solve the following problems. 1. A 36-pole alternator is operated at 20 rps.…

Q: apply AF voltage to the plates of an electrostatic transducer, the electric field between the plates…

A: SOLUTION Part-1 ANSWER- (b) Regulate…

Q: Q1: Find the electric potential at the axis of a uniformly charged disc ?

A: Electric potential: It is the amount of work done that is required to move a particular or given…

Q: Referring to figure shown below, determine the following: a. Total Resistance (R₁) b. Current Ix c.…

Q: What does this open circuit mean? and how do I find the voltage across it in general? 30 A 1 402 892…

A: Given data, Circuit diagram is given as,

Q: The current is in the 30 mH inductor is 10cos (10 000t +30°) m A. Calculate; i. The inductive…

A: Given data, Equation of current is given is=10cos10000t+300 mA

Q: What is a fuse? Discuss the advantages and disadvantages of a fuse in your own words. With respect…

Q: 16. What is 2/5 multiplied by 2/3? B. 4/10 A. 4/8 17. What is N in 3/6 x 1/4 = N. B. 4/12 A. 4/10 C.…

A: We need to find select correct option for given multiplication

Q: 436. A 230 V DC motor takes a current of 40 A and runs at 1100 r.p.m. If armature and shunt field…

A: Given a dc motor with, Terminal voltage, V=230 V. Load current, IL=40 A. Speed, N=1100 rpm. Armature…

Q: 3 A 4 Ω 2 Ω 2Ω www 4 Α 10 Ω www 10 Ω 1746

A: We need to find out total resistance and total current for given circuit

Q: op-Amp circuit that produce output given by V₂ = -(4√₁ + √₂ +0:1√₂) if v₁ = 2 sin wt ; V₂ = 5V, and…

A: Design of a op-amp circuit that produce the given output waveform:

Q: If a MOSFET is to be used in the making of logic gates application then it must work in a.…

A: We need to select correct option for given statement

Q: Draw the logic circuit represented by each expression: (C) ABC (d) AB+CD

A: Given: Boolean expression, ⇒AB+CD

Q: 21) Answer two only A- Sketch the single-sided and double-sided spectra for phase and amplitude of…

Q: Describe the operation of a transparent latch and possible applications for it.

A: Latch represents a level-triggered device. it is an electronic device whose output is dependent on…

Q: 3. Determine the transfer function of the following circuits. (a) Voltage Divider Vi R1 100 L=0.1H…

Q: [H-W3:] show that Vo (1) = [R³² V₁ (t) + [CR₂ + £ ] dvi (1) d'Vich] dt² for the circuit shown below?…

Q: Question 28 Not yet answered In a series circuit, you measure 9 volts across a 300 ohm resistor. How…

A: We need to find out the current for given voltage and resistance .

Q: a) Given that the circuit in the figure makes io= A(v2-v1)-(1/Ro)VL, find expressions for A and Ro,…

A: According to the question, for the given circuit as shown below, We need to find the expression of…

Q: Problem #1 Consider the following waveform: Forstoff 0.3m -0.3m -1.5m -8.9m x(t) 0.9m 1.5m (a) Find…

Q: .. Find Inverse Z-Transform for the following function: H(z) = 1+2z 1-52-2+62-3 1-32-1+22-2 -, |z|>2

Q: The voltage across R₁ resistor in the circuit shown below is? V1 10 R1 60 www 29

A: Given circuit,

Q: 2. W 3:] show that V₂ (t) = [ R²2 vi(+) + [CR₂ + £ ] dvi(t) d+ for the circuit shown below? RI…

Q: The top of the tower signal at B 2000 m away from A was sighted through a transit with a recorded…

A: According to the question. Tower signal at B 2000m away from A. Vertical angle = 3 30’. The height…

Q: A 4 amp current passes through 5 ohm resistor what will be potential difference across the resistor

A: Given: I= 4a R=5 ohm V=?

Q: I. Fill in the blanks. Write your answer in the space provided. 1. What is the numerical equivalent…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: When discussing electronic devices, the acronym LCD refers to a Liquid Crystal Display. Just what…

A: A LCD is a type of display technology that uses liquid crystals that open and close when excited by…

Q: Write the logic equation for the variable F in the circuit below, as implemented. AB CD B' C' F

Q: If the circuit has a dependent current source, RN is obtained by Vth/IN. A True B False

Q: Two identical 20 MW alternators operate in parallel. The governor of first machine is such that the…

Q: SV 1+ + ܘ ни V3 + V₁ + вы 452 м V₂ Find V₁, V₂ V, к к Vs. ЭIOV

A: In this question, We need to determine the voltage V1 , V2 and V3 as shown the circuit. We are…

Q: Need it fast A 2 kHz audio signal modulates a 50 MHz carrier causing a frequency deviation of 2.5…

Q: If the clock period is 25 ns, what is the clock period in MHz?

A: Given: Clock period, T=25 ns=25×10-9 s.

Q: Q1- Find Fourier series coeficients Ck for the signal below. *.(0 0 4 7 H

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
In the following figure find sa Asa turns ratio is A.O-7E A.07001
assume that the voltage drop across the resistor ER is 78 v the voltage drop across the capacitor EC is 104 v and the circuit has a total impedance z of 20 ohms the frequency of the ac voltage is 60 hz find the missing values. fine the missing vaules
5 The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? %3D C R eee V2 V3 23 V None of them 8.5 V 4.5V 37.5 V O 14.5 V
Q4. Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH Figure Q4 reee L3 6.6 mH L4 2.8 mH rele L5 7 mH
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
Charging: A 0.2 F capacitor and a 80092 resistor are connected in series with a battery of voltage 10 volts as shown in the figure. E Answer questions 1-5 www R Tim Atte ON
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
Find the value of C in microfarads and L in henries. 1, = 3 sin(377r+ 60°) R120X₁20 X 50