A vehicle of total weight 49050 N is held at rest on a slope of 10°. It has a wheel base of 2.25 m and its centre of gravity is 1.0 m in front of rear axle and 1.5 m above the ground level. Find What are the normal reactions at wheels assuming that sliding does not occur first, what will be the angle of sloe so that the vehicle will overturn? Assuming all the wheels are to be braked what will be the angle

A vehicle of total weight 49050 N is held at rest on a slope of 10°. It has a wheel base of 2.25 m and its centre of gravity is 1.0 m in front of rear axle and 1.5 m above the ground level. Find What are the normal reactions at wheels assuming that sliding does not occur first, what will be the angle of sloe so that the vehicle will overturn? Assuming all the wheels are to be braked what will be the angle

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The mass of the unbalanced disk is m, and its center of gravity is located at G. If the coefficient of static friction is 0.2 between the cylinder and the inclined surface, determine whether the cylinder can be at rest in the position shown. Note that the string AB is parallel to the incline.
The coeffient of static friction between the uniform bar AB of weight W and the ground is 0.45. Find the smallest angle and the corresponding force P that would initiate simultaneous tipping and sliding of the bar.
The 320-lb homogeneous spool is placed on the inclined surface. Determine the vertical force P that is required to keep the spool in the position shown. Assume that there is enough friction to prevent slipping at A.
The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
A vehicle of total weight 40000 + 250*19 Newton is held at rest on a slope of 10 degree during downhill. It has a wheel base of 2.25 m and its center of gravity is 1.0 m in front of the rear axle and 1.5 m above the ground level. Find (a) what are the normal reactions at the wheels? (6) Assuming that sliding does not occur first, what will be the angle of slope so that the vehicle will overturn?
The uniform cylindrical drum weighs 250 lbs and is supported by a frictionless roller at A and the frame at C. The coefficients of friction between the frame and the drum at C are as follows, static coefficient u: = 0.3 and kinetic coefficient uk = 0.25. If the drum is at rest, find M required to start the drum moving? For full credit show a labeled free-body diagram. 2' 30°
200 mm300 mm 600 mm 200mm 30 Find the value of Pmax if the the mass of a disk with 200mm radius is 35-kg without causing to slip at C. Static friction equivalent between the surfaces at disc is 0.2.
An amusement park ride consists of a large vertical cylinder that spins about its axis fast enough that any person inside is held up against the wall even when the floor is removed. The coefficient of static friction between the person and the wall is u, = 0.3 and the radius of the drum is R = 2m. (a) Find wmin. the minimum angular speed at which the drum should rotate such that the person is held up even if the floor is removed. (hint: when the floor is removed, the person is held up by the static frictional force). (b) Find the linear speed of the person when the drum is rotating at the minimum angular speed you found in (a) (c) Suppose that the drum started from rest and reached the speed you found in (a) in 120 seconds. During this time the drum had constant angular acceleration. Find the number of rotations made by the person within this time.
A forklift and its driver have a total weight of 50000 and the center of mass in at G. What is the reaction force on each of the wheels when the 8000 weight load is pulled up with an acceleration of 1.5 m/s^2? (a= 1.2 meter, b= 0.9 meter, c= 1.7 meter, h= 3.5 meter)
The mass of the unbalanced disk is m, and its center of gravity is located at G. If the coefficient of static friction is 0.2 between the cylinder and the inclined surface, determine whether the cylinder can be at rest in the position shown. Note that the string AB is parallel to the incline. 30 20° Dimensions in mm
Compute the total reaction at the axle of the compound cylinder having a weight of 120N and radius of gyration of 0.45m. The coefficient of friction under 400N block is 0.30
6. The mass of the unbalanced disk is m, and its center of gravity is located at G. If the coefficient of static friction is 0.2 between the cylinder and the inclined surface, determine whether the cylinder can be at rest in the position shown. Note that the string AB is parallel to the incline. rt 18 we 20 Dimensions in mm