A TLC plate showed two spots A and B with Rf 0.20 and 0.30, respectively. Sketch a TLC chromatogram with the above Rf values. (Hint: Start with a 10-cm TLC plate and allow 1 cm each for the start and end solvent fronts.) Determine the distances travelled from the start of the solvent front. ___?____ A ____?___ B Determine the distances left to the end of the solvent front. ___?____ A ____?___ B

A TLC plate showed two spots A and B with Rf 0.20 and 0.30, respectively. Sketch a TLC chromatogram with the above Rf values. (Hint: Start with a 10-cm TLC plate and allow 1 cm each for the start and end solvent fronts.) Determine the distances travelled from the start of the solvent front. _? A ?_ B Determine the distances left to the end of the solvent front. _? A ?_ B

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter14: Chromatography

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

During Size exclusion chromatography, if VT = 30 mL, Vs = 15 cm3 , and VL = 15 mL, Vo is 8 mL 15 mL Not enough information 7 mL A bead resin with functional group R-CH2-SO3- will have highest relative capacity at pH ___. 8 2 10 7
In a normal phase chromatography set up, the component that yields the highest Rf value is likely to be _____. Group of answer choices Both polarity Cannot be determined Polar Non-polar
As solvent polarity increases, the Retention Factor (Rf) of compounds on the TLC plate increases. Group of answer choices True False
Why Rf value is important in Chromatography? Please shortly answer at your own words. Answer should be the point (specific 4-5 lines).
Running an HPLC assay using a column heated to approximately 60 °C can have what benefits over running the assay room temperature? Select all that are true. ✔increased column life decreased run time greatly enhanced peak shape ✔ more precise quantitation O flucuating retention times O increased back pressure more precise retention times Submit Answer Incorrect. Tries 1/4 Previous Tries
Answer sections C, D and E in the same answer book. Section D (Chromatography) Question 8 The following data were obtained for the analysis of a mixture of compounds (A-D) by HPLC: Peak Retention time (min) | Width of peak base (min) non-retained 2.1 A 6.4 10.51 B 11.3 1.03 C 13.1 1.25 D 21.6 1.62 a) Using peak C. calculate the number of plates (N) in this column. b) For peak D, calculate the capacity factor (k'). c) For peak B and C, calculate the resolution (R).
Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave chromatographic peak areas of 306 for X and 511 for S. A second solution containing an unknown quantity of X plus 55.5 mM S had peak areas of 251 for X and 563 for S. Find [X] in the second solution.
6. Say you are trying to separate two compounds by column chromatography. You run a column and collect the eluent in five fractions. You analyze each fraction by TLC on the same plate (shown below). Based on the TLC plate, how effective was your separation? -------1--- 1 2 3 4 5
Internal standard. A solution containing 3.47 mM X (analyte) and 1.72 mM S (standard) gave peak areas of 3 473 and 10 222, respectively, in a chromatographic analysis. Then 1.00 mL of 8.47 mM S was added to 5.00 mL of unknown X, and the mixed solution was diluted to 10.0 mL. This solution gave peak areas of 5 428 and 4 431 for X and S, respectively. (a) Find the response factor for X relative to S in Equation 5-9. (b) Find [S] (mM) in the 10.0 mL of mixed solution. (c) Find [X] (mM) in the 10.0 mL of mixed solution.(d) Find [X] in the original unknown.
Qno1: why there is a need of chromatography and chromatography thecniqs. B) when and where we should use normal and reverse phase chromatography
HPLC VFA analysis - why do I get so different peaks for very similar samples?
The figure below shows a typical separation of several fat-soluble vitamins by HPLC. The x-axis is retention time in minutes. From the graph try to estimate retention times for peaks 2 and 3. Retention time peak 2 = Retention time peak 3 = Assume that w1/2 is 0.15 minutes for peak 2 and 0.16 minutes for peak 3. Assume that tm is 2.00 minutes. How much time does gamma-tocopherol spend in the stationary phase? From tr and w1/2 find N for the peak that elutes first. From tr and w1/2 find the resolution of peaks 2 and 3 Calculate α for these peaks. If the flow rate for the column is 1.2 mL/minute what is the retention volume for peak 4?