Answered: A shunt generator has a load of 5.9kw…

A shunt generator has a load of 5.9kw at 143V and it is supplied by a pair of feeder conductor with resistance of 0.09ohm each. Ra=0.12, Rsh=69 ohms. The generated emf is?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Related questions

Q: Find lo using loop analysis +) σν 1Ω 1Ω 1Ω To 1Ω Μ D) 24

Q: Problem-3, Find the characteristic impedance of a quarter wave transformer connected in between a…

A: Given- Quarter wave transformer- Load R2=100 ohm, Transmission line characteristic impedance Zo=225…

Q: RB VBE 0.7 V Rc Vc Vcc lc = Bla lc = le VcclcRc- laRa - VBE = 0 Vccle Rc (le/B) Ra - VBE = 0 - Vcc -…

A: Given- For a BJT circuit values are given as- Beta VCC RC RB 100 25 1k 1k 150 20 1.2k 500…

Q: VBE 0.7 V Re www Rc 2 25 20 15 10 5 Vcc +11+ Ves - IsRs - VBE = 0 Rc 1k VBB - VBE = la Ra Base-bias…

Q: πι Determine the equivalent resistance: Rab. Rbc. Rcd. Rde. Rbd and Rae. Ε 6Ω 38 www Μ 38 32 452 www…

Q: Q.6) Voltage and current waveforms at the output side of a converter are shown in the below figure.…

A: Given: Voltage is a square wave. Current is a sinusoidal wave.

Q: (f) Draw a logic diagram that implements the XNOR function using only NOR gates. Again you must…

A: Given: The logic gate to be used is NOR.

Q: When a resistor R is connected to a current source, it consumes a power of 18 W. When the same R is…

A: Given, When resistor R connected to a current source, Power consume, P1=18 W. Current through…

Q: 10) 130 120 110 100 90 80 70 60 50 40 30 20 10 0 10 The core shown below is made of cast iron. Find…

Q: In your own words, explain why a good linearity is desired in most of the sensors and. Please be…

A: The following question is based on sensors. A sensor is a device that converts a signal from one…

Q: At t = 0, a charged capacitor with capacitance C = 500μF is connected in series to an inductor with…

Q: (0 0 350-0 0 (a) Complete the following truth tables by simulating the 3-input circuits implemented…

Q: 7. Low cut off frequency for C1 8. Low cut off frequency for C2 9. Low cut off frequency of the…

A: Since you have asked multiple questions in a single request, we will be answering only the three…

Q: If J-²-cosā, +sin 0 A/m², find the current (I) passing through (a) A hemispherical shell of radius…

Q: *2. Find the convolution of the following two signals manually (using graphical sketch and…

Q: 3.2.1. Find the Fourier series of the following functions: (c) 3x - 1, (d) x², (e) sin³ x, (f) sin a…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 1. From the circuit below, solve for the equivalent resistance Rab if all the resistors have an…

A: In this question, We need to determine the equivalent resistance Rab if all resistors are equal R=…

Q: Problem Solving #3: Calculate the equivdent resistance Rab and the power dissipated by the circuit.…

Q: For the Common emitter amplifier below the following are given: VCC = 15V hfe=150; R1 = 100k R2 = 20…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: [Q3] Let m(t) be a baseband signal whose spectrum is described in the figure below. This signal is…

Q: The current in the circuit shown is 20 Ω 100 V 50 Hz O 5 A O 10 A O 15 A O 25 A +200 V- 200 V

A: Given: The input voltage is 100 V The voltage across capacitor is 200 V The voltage across the…

Q: E₁ = 4.5V mA R₂ = 330 La V + R₁ = 100 R₂ = 220 V 2

A: Given a series circuit. Asked to find I1,I2,I3, and IT

Q: 2. Determine the equivalent resistance (Req) of the circuit and total current, Ir in circuit below.…

Q: (a) (b) (c) Answer the following questions Evaluate: Find and plot z(t) if z(2t - 1) = Find the…

Q: Find the power factor 4Ω Μ -j2Ω j5Ω -j2Ω Ans : pf = 0.555 (leading)

Q: Which of the following will give me a total of 3 Ohms? Which of the following will give me a total…

Q: 2. Determine i using superposition theorem. Show all the responses.

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: If the total apparent power of a balanced delta load is 4.8 kVA. What will be the total apparent…

A: Apparent power =3× per phase voltage × per phase current . First relation between KVA in both the…

Q: RG - 워 +Vcc R₁

A: . SOLUTION Given Gate triggering current = IGT ==> IGT = 9…

Q: The Boolean expression (Ā + B) · (A + C) · (B + C) simplifies to A) (A + B) C B (A+B)C C (A + B)C D…

A: Given Boolean expression, A+B.A+C.B+C.

Q: A 4-pole DC generator has 1,000 turns on its rotor. It is being turned by a prime mover at 4,000 RPM…

Q: i 3.2 A CE transistor is to be used in the amplifier of Fig. 3.72 with a source resistance Rs and…

Q: "1 The intrinsic impedance of a medium is given by impedance in free space is: Hint: -8.854x10 and…

A: Given data, Permittivity of free space, ε0=8.85×10-12 F/m. Permeability of free space, μ0=4π×10-7…

Q: Obtain the transfer function between R and C for the following system by using Mason's rule. R(s) G₁…

Q: QUESTION 1 What are the different types of output cards? O Relay O Sourcing O Sinking O All the…

Q: Question: 1 Ali has just received an intrinsic silicon wafer from Global Wafers Co. Assist Ali in…

Q: If an amplifier’s impedance (AC Resistance) is 8 ohms, why should a speaker of 8 ohms be chosen to…

Q: dv(t) The capacitor in the circuit below is initially uncharged and the switch SW is closed at time…

A: We need to prove the given equation for given circuit .

Q: A motor draws 576 W at 143 Vrms 60Hz. The motor is operating at a lagging power factor, with a power…

A: Given data: The active power, P1=576 W The angle, ϕ1=45°. The frequency, f=60 Hz The angle, ϕ2=15°.

Q: Find the even and odd parts of these functions: 1) g(t) = 2t²3t+6 2t²-3t+6 2) g(t) = 1-t 3) g(t) =…

Q: 7. Consider the control system given below, in which a PID controller is used to control the system.…

A: Given: G(s)=1s(s+3)(s+7) To find: we have to find the values of Kp , Ti and Td and obtain the…

Q: Problem 1: Let VTRUE be 9 V and let VFALSE be -3 V. Let TPWM be 0.5 second. What is TOFF to get an…

Q: a Determine the equivalent resistance: Rab. Rbs, Rad, Rde Rbd and Rae. M 3Q 6Q ww 3Q b 3Q 4Q WA 3Q…

A: Equivalent Resistance:

Q: 1. Determine the currents using mesh analysis. 17V (+ Iy 2 -+ 6V Iz 42 Ix Q 24

Q: We want to digitalize an analog signal. The RMS- value of the signal is 0.2V. Our ADC (Analog to…

A: Given data, RMS value of signal vr=0.2 V. Dynamic range is given -1 V to +1 V. Number of bits n = 8.

Q: I U +0.0 ~~ 0.0352 20002 451 1-50 A 500 V

Q: 2. Determine the equivalent resistance (Req) of the circuit and total current, Ir in circuit below.…

Q: Determine the equivalent resistance: Rab. Rbs. Red. Rds. Rbd and Rae. Ε ກ 38 Μ 6Ω Μ 38 b 352 Μ Ω ΜΑ…

Q: 3) Using the current divider rule, find the current through each impedance of Fig given below 1-20 A…

A: Given data, Circuit diagram is given as,

Q: 1. Consider the network of Fig. P1.1. (a) Label all node voltages and loop currents. (b) Use Nodal…

A: As per guidelines i have to answer first three subparts only.please ask remaining again

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

A shunt generator has a load of 5.9kw at 143V and it is supplied by a pair of feeder conductor with resistance of 0.09ohm each. Ra=0.12, Rsh=69 ohms. The generated emf is?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10 and 15 amperes. Assuming IA to be the reference phasor, IB leads IA by 30°, and IC lags IA by 65°, calculate the total current and the angle it makes with the reference.
The regulation of an alternator is likely to be negative in case of resistive load O True O False
A shunt generator has a no load terminal voltage of 270V and a voltage of 240V when it delivers 180A. Determine the voltage when the load current is 120A
The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
In transformers, the flux lost in the air is called nd as SKW. If th
A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
With a D.C. generator which of the following regulation is preferred ? None of these 100% 50% 1%
Note: You are attempting question 3 out of 12 For the same alternator, the ratio of rated KVA, when connected as 3-phase winding alternator to when connected as single phase alternator (by utilizing all the coils) is, (a) 1.33 (b) 0.50 (c) 0.67 (d) 1.50 Answer A D Submit 27°C realme Shot by Gowthamnag 2021/10/30 11:55 O O O O
Copper losses in a generator vary with load Select one: O True O False
The distribution factor for 90 slots, 10-pole, 3-phase winding is A 0.90 B 0.895 C 0.959 D 0.978