In your own words, explain why a good linearity is desired in most of the sensors and. Please be specific in your answer instead of saying it can increase the accuracy, etc.

Q: Question 01: Simplify the following Boolean expressions to the minimum number of literals. Draw the…

A:

Q: 6.. The phase voltage of a 3-phase voltage source is 120 V. It is supplied to a star connected load…

A: Given data, Phase voltage VP=120 V. Load impedance connected Z=36+j48 Ω.

Q: Determine ICQ= RB www 100 ΚΩ Vcc +20 V Rc 4,7 ΚΩ RE 10 ΚΩ VEE -20 V and VCEQ= of the circuit. Assume…

A: In this question,  We need to determine the collector current and voltage between collector and…

Q: 1. if a signal s(t) has the following specification s(t) = 13 sin (2000πt + π) for binary 1 s(t) = 5…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: 3. Solve Ix and all the mesh currents using mesh analysis. lov ( + 15V (+ 252 1₁ 65 13 Me 75 =102 8…

A:

Q: Find the Thévenin equivalent with respect to the terminals a, b for the circuit in (Figure 1) if v,…

A:

Q: 6. A 4.6-kV, three-phase transmission line is 100 km long. This line has a per-phase series…

A: In this question,  We need to determine the sending end voltage using the short line approximately.…

Q: Write out the node-voltage equations and solve for the node voltages.

A: The given circuit diagram is shown below:

Q: 2. Table 1 gives the types and size of various loads that will be connected to a three-phase…

A: given that there are 20 lamps, 10 1phase motors, 5 3phase motors connected as loads to a 3phase…

Q: We are given the power received P1, P2, P3 and the voltage v1. Find the power received P4. + V1 2A…

A:

Q: x(t)=2cos(2π150at) 1) What is the frequency of the signal? 2) What is the period of the signal? 3)…

A: Given data, Function is given as, xt=2cos2π150at.

Q: RG Vinº VDD=1.8 V HEM₁ Rs Given: VDD = 1.8 V, RG = 100 KQ, RS = 3 KQ, RL = 3 KQ, W/L = 5, VTO=0.60…

A: We need to find out the drain current for given circuit , we will use drain current equation for…

Q: Question 1: What is the hole quasi-Fermi level w.r.t. intrinsic level for silicon crystal at 300K…

A:

Q: 1. Determine the total resistance using delta- wye transformation. RT W N M M N M M Each R is 202

A:

Q: The capacitor in the circuit below has an initial voltage of 10 V across it, i.e., v(0)=10V. The…

A: Given- Voltage = 5 V Resistance = 1 k-ohm Capacitance = 1μF Initial voltage of capacitor v(0)= 10…

Q: =E₁ 2=E2 Vb 4.7k-2 Vab IRY E₁ lov V₂ V₂ 19 22kn b (12) R4 Parameter / Computed Va lok Eskrrr 33k-2…

A:

Q: Draw or create functional analysis for a screw pump design

A:

Q: What is the voltage across it in volt if a diode with an ideality factor of 1 has a reverse…

A: here we have to find the voltage across the idode.

Q: A phase-locked loop has a VCO with free-running frequency of 10 MHz. As the frequency of the…

A: .                            SOLUTION  GIVEN-->                    Free running frequency = fo…

Q: What is the equivalent resistance of a two 10 Ohms resistor in series then parallel to a 15 Ohm and…

A: Given: Two 10 Ohms resistor in series then parallel to a 15 Ohm and 12 Ohm resistor. To find:…

Q: The sum of the following two e.m.fs will be e1 = 10 sin wt and e2 = 10 cos wt O 10 O 20 sin wt O…

A: We need to find out the resultant of two sinusoidal signal

Q: Determine V₁ and V₂ in the circuit shown using voltage division and calculate 1₁ and 1₂ using…

A: Given: The circuit diagram with resistances and voltage source.

Q: Suppose a 0.3 m long solenoid with cross-sectional area of 12 cm 2, N 1 = 1400 turns and N 2 = 20…

A: Given: Length of solenoid L=0.3 m, Cross-sectional area A=12 cm2, N1=1400 turns, N2=20 turns. L1=0.1…

Q: Problem 2 Find the Thevening and Norton equivalent circuits for the network shown below. 3Ω 50 V Μ +…

A:

Q: Given the following circuit, 28 V 8 Ω www + 6Ω www 12 Ω Find the equivalent resistance, current i1 &…

A:

Q: 100 micron 75 micron- 2 micron 1 micron C 3 micron 50 micron b) If a voltage of 5V is applied across…

A:

Q: 2. Draw the modulated signal for the following digital signal if we apply a phase shift keying using…

A:

Q: 3. Solve I using source conversion. 5 65V I 4 (± 50V 5 (F) 20V

A:

Q: A capacitor has a charge of 2 coulombs at 24 V stored on it Calculate the capacitance in uF

A:

Q: Over what band of frequencies will a 100 MHz carrier modulated at 5 kHz extend?

A: Given data- Carrier wave frequency=100 MHz, Modulated frequency=5 kHz, To Find- The band frequencies…

Q: Let I, = 75230° A, V, = 702 – 20°V, Z1 = 80 + j352, R2 = 25, R3 = 250, X2 = –700, Ni = 1, and N2 =…

A:

Q: For the circuit shown below. Find ib 9V 1 ΚΩ ww 3 ΚΩ • 2 ΚΩ +1 Ava

A:

Q: What is the value of critical frequency (MHz) if a signal radiated from transmitting antenna has an…

A: Given here MUF=10 MHz and angle of elevation = 33° we need to find the critical frequencyin MHz.

Q: A uniform n-type silicon bar has length 2 μm and cross-sectional area 0.25 x 10-¹2 m. A potential of…

A:

Q: 2.56 Find the equivalent resistance between terminals a and b in the circuit of Figure P2.56. www…

A: We need to find out equivalent resistance for given circuit by using of series and parallel…

Q: 15-mA current flows into four parallel resistors having resistances of 4, 6, 8, and 12 k-ohm. Find…

A:

Q: R4 390 Hii VS1.7.5 A R1 910 ww AM1 V VM1 VS2 3+ V VM2 R2 750 A AM2 ww R5 47k V VM3 R3 2.7k A AM3 VS3…

A:

Q: 48V T 8Q w FIND THE VALUE OF RESISTANCE 15 Q www R 15 Ω ww 9V 5Q

A:

Q: QUESTION 5 Which one of the following represents the Laplace inverse of Y(s) = 4 5² ○ y(t) = 4u(t)…

A: Given: Transfer function, Ys=4s2;

Q: 3.23 An LTI system is characterized by the system function H(2) (a) Determine the impulse response…

A:

Q: If a diode has a current-voltage relation of /= 10-14(e40V - 1), what is the diode voltage when the…

A: Given: A diode has voltage current relation as, I=10-14e40V-1. The current is I=150 mA.

Q: Solve for the value of the current in square form. Given frequency is 60Hz. 133mH 360 μF 1502 www…

A:

Q: In the given figure, use the principle of superposition to determine the component of the…

A: Given:

Q: Measured Voltage 9 V. Computed Current Measured Current -W- 1.0KQ R3 1.0KQ R1 R2 >1.0kQ Figure 1…

A:

Q: As shown in the figure, a 1 resistance is connected across a source that has a load line v + i =…

A: Given circuit, Load resistance, RL=1 Ω. v+i=100.

Q: Given: feedback closed-loop control system G(s)=35/s(s+5) Find: Unit step response ASAP. PLS

A: This is a problem of control system. The detailed solution is given in the next step

Q: 4. Solve for the Mesh Currents.

A:

Q: A B C D w1 w3 w2 w4 X Y a) Determine Boolean functions for intermediate outputs w1,w2,w3, and w4 as…

A:

Q: Q6. Determine the total amount of power in the series circuit in Fig. 5Ω ww 50 V 2Ω www 192

A: Given data, Circuit diagram is given as,

Q: Y= 7. Perform the following for the schematic below. A B C D V D a) Generate the logic function b)…

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.