You do 10,000 J of work on a system of 3.00kg water by stirring it with a paddle wheel. During this time, 10,000 calories of heat is added. What is change in the internal energy of the system? (1 calorie = 4.18 Joules)

You do 10,000 J of work on a system of 3.00kg water by stirring it with a paddle wheel. During this time, 10,000 calories of heat is added. What is change in the internal energy of the system? (1 calorie = 4.18 Joules)

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 6RQ: One British thermal unit will raise the temperature of _____ 1b of water _____F.

See similar textbooks

Related questions

Q: A closed system undergoes an adiabatic process. During the process, the system operates at the same…

Q: A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure…

Q: Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: The fluid 1 in a tank is pressurized by air, and the pressure is measured by a multifluid manometer…

Q: While the pressure remains constant at 689.2 kPa, the volume of a system of air changes from 0.567…

A: Given question belongs to the subject Engineering Thermodyanamics and can be solved using concepts…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

A: Given : The density of the water = 1000 kg/m3 The density of oil = 850 kg/m3 The density of mercury…

Q: Why is the product of P(pressure) and V(specific volume) not zero when P approaches 0?

Q: A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 lb/cu ft…

Q: A swimming pool full of water is in the form of a rectangular parallelepiped 5 ft deep, 15 ft wide,…

Q: An airplane weighing 20,896.36 lb, at ground is flying at an altitude of 31,529 44 ft at 524 miles…

Q: is partially Dll, water, and air. Determine the pressures at A, B, and C. Take = 830 kg/m³. Pw 1000…

Q: Q3: Calculate the applied force to move the process Envierment w 100 lb Process W 100 lb u=0.2…

Q: 5. Determine the density of the balloon just before it bursts.

Q: An elastic air balloon having a diameter of 30 cm is attached to the base of a container partially…

A: Given data: Note: the value of n should be -2 but in the question, it is given 22. If the given…

Q: A man of weight 600 N is standing on the bottom of a building of height 10 m, the energy possessed…

A: Weight of man, W=600N Height of building, H=10m

Q: A glass tube is attached to a water pipe, as shown in Fig. P1–107. If the water pressure at the…

A: Given: The water pressure at the bottom of the tube is PW=107 kPa. The local atmospheric pressure is…

Q: Q1. In a piston-cylinder assembly attached with spring load is filled with 60 kg of water at…

Q: The pressure in an automobile tire depends on the temperature of the air in the tire. When the air…

A: To solve this problem, we have used ideal gas equation. we calculated mass of air for condition 1…

Q: 2. Consider a wind turbine that is situated in an area that has steady winds. The turbine rotates at…

A: Given: Speed of the turbine→N=16 RPM Hence rotational speed of the turbine: →ω=2πN60=2×π×1660=1.67…

Q: The potential energy of water in a cylindrical tank located on top of a building 15m high, is 150…

A: To find out the weight of the tank P.E=mgh 150000=W(15) W=10,000N

Q: Q3: Calculate the applied force to move the process Envierment w 100 lb -0.2 Process W 100 lb μ0.2…

Q: 10 Ibm/min of Steam at 4.5 MPa with a moisture content of 7% undergoes a constant volume process…

Q: A piston-cylinder contains 2 lbm of water. The initial volume is 0.1 ft3. The piston rises, causing…

Q: A 75 kg diver climbs up a 6.5 m high diving board in 50 s, how much work is done by the diver and…

A: M=75kg x = 6.5 m t = 50s g=9.80m/s2 To find 1.Work Done 2.Power

Q: The pressure (p2) of water in the pipe is equal to: (Assume a = az = 1) Elevation = 100 m P2 =…

Q: 1. The volume of a 7x 13-ft tank contains air at 225 psig and 90°F. How many 1 cu-ft drums can be…

A: Solution: Given Data: P1=225+14.7 = 239.7 psiaT1=90+460 = 550 RP2=60+14.7=74.7 psiaT2=90+460=550…

Q: 500 J/(Kg.°C), is The quantity of heat required to raise the temperature of 500 g of iron by 2C…

A: From the given data, Mass of iron = m = 500 g = 0.5 kg Change in temperature = ΔT = 2 oC Specific…

Q: An insulated piston-cylinder device initially contains 1.8 kg of Argon at 100 kPa and 300 K. Now an…

A: Given Data m=1.8 kg P1=100 kPa T1=300 K V2=2.3V1

Q: A vertically arranged piston-cylinder assembly is filled with 6.3 kg of steam. The mass of the…

Q: Air is expanded in a frictionless piston cylinder arrangement at a constant pressure of 200 kPa from…

A: Given:- For constant pressure P= 200 kPa V1=0.1 m3 V2=0.3 m3 For constant temperature V1=0.3 m3…

Q: The water pressure at the base of the water tower shown in the figure is 3.2 bar. The water level is…

A: Given:- Pressure at base of tower (P) = 3.2 bar = 320000 Pa Density of water (ρ) = 1000 kg/m3 g =…

Q: A vertically arranged piston-cylinder assembly is filled with 6.3 kg of steam. The mass of the…

A: As per our guidelines we are supposed to do one question, kindly post the othe question separately.…

Q: A glass tube is attached to a water pipe. If the water pressure at the bottom of the tube is 110 kPa…

A: Given data the pressure at the bottom of the tube (P) = 110 kPa local atmospheric pressure (Patm) =…

Q: Helium gas initially has a volume of 50 liters, a pressure of 2 x 10⁵ N/m², and a temperature of 300…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

Q: A PISTON-CYLINDER SYSTEM CONTAINS A GAS WHICH EXPANDS UNDER A CONSTANT PRESSURE OF 1200 LB/FT². IF…

Q: Consider the following : 1. When a gas is heated at constant pressure, its temperature and volume…

Q: Q3: The top part of a water tank is divided into two compartments. Now a fluid with an unknown…

A: Hydrostatics Law: It state that the pressure in a vertically downward direction in a static fluid is…

Q: A high altitude chamber chamber , the volume of which is 30m3 , is put into operation by reducing…

Q: A fluid flowing in a pipe 1000 ft above the reference line at a pressure of 200 psia, specific…

Q: 2.) A bicycle tire is inflated at sea level, where the atmospheric pressure is 101.3 KPaa and the…

A: Given data: P1g=327 KPaT1=290 KV1=0.1 m3P2g=170 KPaV2=0.2 m3 Need to determine the tem0.1perature at…

Q: 6... What will be the water potential (in MPa) of 1000 litres of pure water in an open tank that is…

A: To find: The water potential in MPa. Given: The volume of water is V=1000 lt. The height of the…

Q: A 25 kW automobile engine consumes 1.25 kg of gasoline when it runs for 10 minutes. What is the…

A: We have to determine efficiency

Q: (1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: In a piston-cylinder setup, 2 kg of water undergoes a constant temperature expansion at T=200°C from…

A: According to the first law of thermodynamics - Q1-2 =W1-2 + ∆U Since the expansion takes place at…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How many Btu/h would be produced in a 12-kW electricheater?
Four pounds of a gas occupy 10 ft3. What would be itsdensity and specific gravity?
1.) While the pressure remains constant at 100 psia the volume of a system of air changes from 20 ft' to 10 ft'. What are (a) AU in Btu, (b) Q in Btu, (c) Wn, Btu
A 5-m3 container is filled with 900 kg of granite (density of 2400 kg/m3). The rest of the volume is air, with density equal to 1.15 kg/m3. Find the mass of air and the overall (average) specific volume.
The mass of a fluid system is 0.311 slug, its density is 30 lb/ft3 and g is 31.90 fps2. Find (a) the specific volume, (b) the specific weight, and (c) the total volume.
Suppose that a person eats 2387 Calories per day. Convert this amount of energy into unit kWh.
Thermodynamics (Ideal Gas) In a certain non-flow process, the internal energy decreases 20 Btu/lb and 77800 ft-lb/lb of work done on the substance. Find the heat added or abstracted in Btu/lb
The fuel consumption of an automobile is 14 km/ L.The fuel consumption, in miles per gallon, is?
6. If 8 lbs of a substance receives 240 Btu of heat at constant volume and undergo a temperature change of 150oF. What is the average specific heat of the substance during the process? (3 DECIMALS IN FINAL ANSWER PLS)
A tank contains 5,810 lbs of water at room temperature. How many hours would it take to empty the tank if a pump removes 1 gallons of water from the tank every minute.
35 kg of certain gas is contained within the piston- cylinder assembly. THE GAS undergoes a process which is pv=constant.The given conditions as follows; p1=6bars,v1=0.2cubic meters,v2=0.4 cubits meters,the change of internal energy=10.5kj/kg.(hints:kE=PE=0) A)Find P2 in bars B) Find the work in kj for n=1.0 C) Find the net heat transfer Q for the process in kj
Q2/ hydraulic cylinder has a piston cross-sectional area of 15 cm2 and a fluid pressure of 2 MPa. If the piston is moved 0.25 m, how much work is done in kj.