Answered: Write in rectangular and polar…

Write in rectangular and polar notations, the impedance of each of the following circuits at a frequency of 50Hz. That have a, 2.1 A resistor of 2002 in series with an inductor of 0.1H.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: A single-phase 400 kVA transformer has an efficiency of 99.13% at half load unity power factor where...

A: It is given that: S=400 KVAη=99.13 % at half load unity power factorη=98.77 % at full load 0.8 power...

Q: Problem 4. Let the components of the vector x = [r1,., Ta]' be binary-valued (0 or 1), with d odd, a...

Q: Calculate the power density at 420watts transmitted through an antenna with a gain of 45 if the surf...

Q: 1. Find all the current that act at b. 150 50 a b 150 202 A В 102 30V 15V f d.

A: Given circuit

Q: calculate the valye of each Ise/ Reni Ven 1nthe following electrical cincuit Riz 1o Rg=10 R2=10

Q: Find the time constant for the RC circuit in Fig.

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit....

Q: The frequency of an ac generator is when running at 600 rpm is 50 Hz. What is the number of poles?

Q: 2. A voltage waveform, v(t) = 200 V sin ( 250 rad/s t ), is connected across a series combination co...

Q: Given the inputs A,B,C and D please make a truth table for the outputs at points F,G and H (а) U8 A:...

A: Since you have posted the multiple questions so we are supposed to answer the 1st question. a)

Q: Using node-voltage analysis, mesh-current analysis, or superposition, find the current i across the ...

A: The nodal analysis and mesh analysis can be obtained by using kirchhoff's voltage and current law in...

Q: 6-16 The discrete-spectrum signal of Problem 6-4, having components at 1.2 kHz, 3.6 kHz, and 6 kHz, ...

A: If a physical quantity takes only distinct values with gaps between them, it is said to have a discr...

Q: 12 i, 0.2 H 1. The order of the circuit is: 2. The impedance of the inductor is bs. What is b? 3. Th...

Q: The regulation of a 250 volt shunt generator is 6 percent. Calculate the no load voltage.

A: GivenFull load volatge=250 vPercentage of regulation=6%

Q: 1Ω is 0.2 H 1. The order of the circuit is: 2. The impedance of the inductor is bs. What is b? 3. Th...

A: Order of circuit is equal to no. Of storage elements. S domain representation of inductor is SL And...

Q: A coil with resistance of 100 and an inductance of 15 mH is connected in series to the paralle combi...

A: Solve the problem

Q: A transformer is connected as shown bellow: R1 3:1 RL Source voltage Vsupply=120V, R1=20 RL=20 Trans...

Q: Ask user to enter vector x to evaluate and plot the following two functions in two different figures...

A: clc;clear all;format compactx=input('Enter a vector x to evaluate and plot f1(x) and f2(x): '); %Ask...

Q: Design a differentiator to have a time constant of 10s and an input capacitance of 0.05µF. What is t...

A: "As per our guidelines, we are supposed to answer only one question. Kindly repost the other questio...

Q: EE223 Week 8 Progress Check. 1. Make sketches showing how 18 1.5 dry cells may be interconnected usi...

A: Here is your answer! I hope this will help you. As you requested I am providing answers for b&c....

Q: What quantity electricity is carried by 6.24×10^21 electrons

A: Here, we have given the information about the no. of electrons. And, we have to determine how much ...

Q: For the following circuit, determine the angle of the source current. ll 100 mH 5Z0° V R= 146N, the ...

A: In this question , we will find total current I angle in series RL circuit....

Q: 17. For the self-bias configuration of Fig. 6.81, determine: (a) Ipo and VGsg (b) VDs and Vp. * 18. ...

Q: Show that the transfer function of feed back connection is Y(S)/X(S) = G(S)/1-H(S)G(S) Using Math...

A: In this question we will find transfer function of positive feedback control system.....

Q: Example 2: Determine the Per Unit Impedances by taking 150 MVA and 11 KV in generator side as base v...

A: Per unit, the method is very important for the calculation of a large power network. As we use diffe...

Q: A shunt motor has lap-wound armature with 100 slots with 2 turns per coil. It is rotating at 100rpm....

Q: 5 mH 60 is = 50 Cos (314 t+30) A 1 mF 40

Q: A 600 MW PWR nuclear plant uses 4% enriched uranium fuel has a thermal efficiency of 36%. The burn u...

A: Nuclear reactors produce roughly 20% of the electricity consumed in the United States. Uranium is th...

Q: Design a differentiator to have a time constant of 10-2s and an input capacitance of 0.01µF. What is...

A: Given,Time constant τ=RC=10-2sand C=0.01μFSo,R=τC=10-20.01×10-6R=1MΩ

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with po...

A: The solution is given below

Q: (a) State two differences in the features of a general-purpose computer application compared to an e...

A: Since you have posted multiple different questions. we will solve the first question for you. To get...

Q: Even after the huge technological advancements in power electronics, why direct current is not acti...

A: Direct-current transmission A constant electric voltage is applied, from which devices will draw a c...

Q: In the figure shown, the voltage at y is equal to

Q: Two (2) ideal voltage sources, V1 and V2 are connected together by a line impedance, Z. (i) Draw the...

Q: culate the real power P, reactive power Q and apparent power S, inclu Xc R A .07S XC = 35, R= 150N; ...

Q: what are the draw back of using DTOC relays for the protection of long feeders?

A: Relay: The main work of relay is used to detect the fault and send the signal to the circuit breaker...

Q: (a) Find the content of R20 after each of the following instruction is executed. Show your working s...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: ductance 1 henry and resistance 10 ohms is connected in series with an e.m.f of Eo sin 10 t volts. W...

Q: Electroscope Chart Object Electroscope's Reaction Balloon Probable Charge = Pen Probable Charge =

A: Electroscope is an early stage device which is used to detect the electrostatic charge and its magni...

Q: 3. For the following problems there is no need to consider the position vector. Simply find the magn...

Q: Q1 (a) Differentiate between digital and analog multimeters in terms of their construction and measu...

A: Multimeter- Multimeter is an electronic device which is used for the measurement of different parame...

Q: An eight poles ac generator is running at 750 rpm. a. What is the frequency? b. At what speed must t...

Q: 3 Ohm 6 Ohm Y + V. Ia La Vs 12 V 2 Ohm 2V.

Q: Draw the time domain representation of amplitude modulated signal with proper scale and modulation i...

A: Brief description: Modulation is one of the important technique in the communication system where on...

Q: 11. A 12V battery source with 1 point equivalent power of 20 watts can move 8 coulombs of charge at ...

Q: 12 2Ω 0.2 H 1. The order of the circuit is: 2. The impedance of the inductor is bs. What is b? 3. Th...

Q: For a single-tone modulating signal of 5 kHz and a carrier frequency of 600 kHz, list the frequencie...

Q: Find I: j2 Ω I | 32 33.8/0° V 0.75VX I2 j5 Q I Vx I, A. 43.5 V C. 48.58 V 5 D. 43.3 V B. 34.8 V Find...

Q: R13 3300 R11 5602 R 14 V3 5602 R12 12V 220Ω 10

Q: Q1. The system impulse response is given as u[-n-3]. Check if the system is i. with or without memor...

A: Causal System: If the output of the system is independent of the future value of the input then the ...

Q: Draw the waveform of the given clipper circuit and determine the following: a.) At 0V, what is the ...

A: In this question we will find output voltage of given clipper....

Question

Write in rectangular and polar notations, the impedance of each of the following circuits at a frequency of 50Hz. That have a, 2.1 A resistor of 2002 in series with an inductor of 0.1H.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50 Hz. Thecurrent is then 1A and the p.d. across the capacitor is 500 V. Calculate (i) the resistance (ii) theinductance and (iii) the capacitance Answer:
An A.C Bridge as shown in the figure is used to measure unknown inductance L1. in companion with capacitance What would be the quality factor if the frequency is 1500 Hz & the various parameter are as below- 120V
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
Capacitance by AC- Bridge: The impedance of the capacitor of capacitance C is: Select one: a. Directly proportional to 1/C b. Directly proportional to 1/C2 C. Directly proportional to C2 d. Inversely proportional to 1/C
Please
Solve for the total capacitance of the circuit. Select one: a. 5.28 micro Farads b. 6.64 micro Farads c. 8.42 micro Farads d. 5.92 micro Farads
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
For a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac voltage source of 60 V, 2500 Hz, then the magnitude of current through the circuit is Select one: a. 5.45A b. 3.45A c. 0.915A d. None of these