Which of the following sentences reflects the main function of the network tap installed between two networks? a. To monitor and estimate how many switch ports are in use at a specific time O b. To redirect the network traffic passing between the two networks. O c. To send ARP messages and update the CAM table of the switch O d. To collect the network traffic that indicates a malicious behavior

Which of the following sentences reflects the main function of the network tap installed between two networks? a. To monitor and estimate how many switch ports are in use at a specific time O b. To redirect the network traffic passing between the two networks. O c. To send ARP messages and update the CAM table of the switch O d. To collect the network traffic that indicates a malicious behavior

Management Of Information Security

6th Edition

ISBN:9781337405713

Author:WHITMAN, Michael.

Publisher:WHITMAN, Michael.

Chapter12: Protection Mechanisms

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Similar questions

There is a chance that MAC addresses will be used by more than one network interface. Why are you making the decision not to do it? Does utilizing several network interfaces make it more likely that IP address disputes may occur? Is this action justified in some way?
DISCUSSION 1. Which utility or command do you feel was the most useful for network troubleshooting? 2. What is the possibility if the ping command did not give a reply from destination?
Which of the following sentences reflect the main function of the mirror port on some of the network switches? a. To collect the network traffic that indicates a malicious behaviour O b. To send ARP messages and update the CAM table of the switch O c. To monitor and estimate how many switch ports are in use at a specific time O d. To redirect the network traffic passing the switch to a special monitoring port. es Jump to...
ISPs are responsible for the transmission and reception of data packets. Source and destination information for the transmission is included in these packets. When a malicious user intercepts a packet, they may utilize the source address to establish a connection with the target computer. Use the scenario to respond to the following questions:To begin, name TWO issues with this kind of network assault.
What does a router do when it gets a packet with a destination network address that is unknown to the router is described below. The distinction between system security vulnerabilities and network security vulnerabilities is as follows: System security vulnerabilities are those that can be exploited by an attacker. Please provide specific instances of each.
Address the following: DHCP is a very promiscuous service, and this can cause unplanned service interruptions if not configured properly. Explain. DHCP can also be used as a malicious attack tool. Explain. For your corporation, would you recommend that DHCP be handled at the router/switch level, or from a Server? Explain your recommendations.
The diversion of malicious traffic from one VLAN to another is one method for infiltrating a network. Determine the pattern of attack used by the attacker. Can anything be done to prevent this from occurring?
Silicone Printers has raised a ticket claiming that it was unable to view websites from its workstations, because with every attempted access, the system displayed an error message that read "there is another device using the same IP address." What would you, as a network engineer, check for in such a scenario? Incorrect gateway Duplicate IP addresses Incorrect subnet mask DHCP scope exhaustion
Set up firewall rule that would allow incoming external traffic, TCP source port to internal network and 25 destination port.
When comparing a packet-filtering router with a stateful inspection router, what is the primary difference? firewall?
It is imperative to remember the FTP port numbers. Is it accurate to assert that FTP transmits control data "out of band," despite the prevailing notion to the contrary?
Internet service providers send and receive packets. The source and destination of the communication are included in these packets. A malicious user intercepts the packet and contacts the target machine using the source address. Using the example, respond to the following questions:1. Describe TWO negative aspects of such a network assault.