What of the following is true about liquid dielectric?O a.O b.O C.d.In practice, the choice is made mainly on the basis of its Thermal stability100 times denser than gasesAdding 0.01% water to dry oil will reduce the dielectric strength by halfCastor oil is used for HV capacitorsDلمندسة الكهاE Committee

Answered: Image /qna-images/answer/6d9ce112-541c-4bf9-8754-75e67091db1a.jpg

What of the following is true about liquid dielectric? O a. O b. 100 times denser than gases O c. In practice, the choice is made mainly on the basis of its Thermal stability d. Adding 0.01% water to dry oil will reduce the dielectric strength by half Castor oil is used for HV capacitors wai mittee

What of the following is true about liquid dielectric? O a. O b. 100 times denser than gases O c. In practice, the choice is made mainly on the basis of its Thermal stability d. Adding 0.01% water to dry oil will reduce the dielectric strength by half Castor oil is used for HV capacitors wai mittee

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: 2 and 7₂ and =205 reflection coefficient =?

A: We need to find out the reflection coefficient for given impedance .

Q: b) For the following two square-shaped signals, how would the frequency spectrum look like after…

A: Solution is shown below in detail in the attachment below

Q: Problem 3: A system is described by the following differential equation: d'y d'y d³x d²x dx dy +3.…

A: The transfer function for the given system represented in differential equation can be obtained by…

Q: In the circuit shown in Fig.5, the magnitude circuit impedance is 15/0° V 1₁=2mA R I=1.5mA www

A: Given data, Circuit diagram is given as,

Q: Q2: Determine the maximum output voltage and 50% voltage and its time for 16-stage impulse generator…

Q: Find the z transform and its ROC of the following: a. x(n) [1, 2, 3, 4, 5}

Q: Q³: For the convolutional encoder shown below, draw the sate diagram and the table, if you know that…

A: Given: A convolution encoder as shown in figure, Where constraint length, N=4, m2 , m1 and m0 are…

Q: 9) Coherent binary FSK modulation is used to transmit two equiprobable symbol waveforms s₁ (t) = A…

A: We have to calculate probability of bit error, so by apply the standard formula we can calculate

Q: A 40-KVA, 3,300/240-V, 50 Hz, 1-phase transformer has 660 turns on the primary. Determine (a) the…

A: In this question We need to determine the unknown parameters. We know V1 /V2 = N1 /N2 Apparent…

Q: Consider the circuit shown. 6V D₂ Ri R₂ ww D₂ -8V Dy R3 -12V R1 = 20k2, R2 = 15k02, and R3 = 2k02.…

A: It is given that: R1=20 kΩR2=15 kΩR3=2 kΩ

Q: Question No.63 The hexadecimal representation of (657), is

A: Given- Octal number, 6578. To find- The hexadecimal representation for a given octal number.

Q: for the given waveforms, the power factor is: V 0 O a. 0 Ob. unity langing 1-0 an p=VanR İs P

A: Given data:- Van : Voltage waveform iR : Current waveform

Q: I1 492 ww 292 12 6Ω V1 a For the circuit shown above, find the Norton current as seen from the a-b…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: In Fig., the potential difference between points P and Q is P 10V 2A 292 8Ω + 4Ω ww ww 6Ω Q

A: Given circuit- To find- The potential difference between point P and Q.

Q: What is the rectification efficiency if an applied input ac power to a half wave rectifier is 150…

A: Given- Input AC power Pi=150 W, Output DC power Po=50 W, To Find- The value of the rectification…

Q: An electromagnetic wave with w = 200m rad/sec transmitted by Antenna (a) and received by Antenna (b)…

Q: 8) Equiprobable binary symbols at a rate of 10 Mbits/sec are transmitted over AWGN with noise PSD N…

Q: 8.12/ Sketch the impulse responses of the filters matched to the pulses shown in Figure P-8.12. Also…

A: Sketch Impulse response

Q: Determine VR1 R₁ 1.5 ΚΩ ww D₁ Vs 10 V R₂ 1.8 ΚΩ D₂ How about VR2?

Q: Figure 2.36 depicts the current-voltage characteristic of three different resistive elements.…

A: Resistance R = VoltageCurrent Ohms . From the figure , at some point on the graph , observe the…

Q: What should be the RL to obtain the maximum power transfer for the given circuit?

Q: A1. (a) What is a nonlinear load? By illustrating the relationship between voltage and current,…

A: Voltage: The difference in electric potential between two places is known as voltage, often referred…

Q: Find the current

Q: Q4. The electric field intensity of a plane wave propagating in a medium is given by: E = 10e ax…

Q: E=36 V I=1.3 mA+ 3. P= mW R=1kQ 5. P= /= 360 mA W R = 100 £2 E=24 V E=6V I= 4 mA 4. 1=__A P = 36 W…

Q: A charged capacitor stores 10 C at 40 V. Its stored energy is:

Q: A.) A 120V shunt motor takes 75A at full load. Armature resistance of 0.2Ω and brush contact drop of…

Q: Bandpass limiter in FM receiver is used to: Select one: O a. approximate the differentiator O b.…

A: We need to explain the function of band pass limiter in FM receiver.

Q: Distributed Solar (PV) is preferred in on-grid system as it: a. Has negligible environmental impact…

A: Introduction Solar panel in on-grid system Solar panels in an on-grid system will continue to…

Q: = Find RAB in the circuit shown given that R₁ = 3kn, R₂ = 5kN, R3 = 3kN, R4 = 7kN and R5 RAB= ΚΩ

A: Given: In this question, the given details are, The given values are, R1=3kΩ , R2=5kΩ , R3=3kΩ ,…

Q: A series motor having an armature resistance of 0.1Ω and a field resistance of 0.15Ω, takes 48A at…

A: We need to find out the find out speed at given current for given DC series motor .

Q: = 1. In the circuit shown below, V1 = 9.0V, R1 = 3kQ2, R2 = 1k0, R3 = 2kQ, R4 24ΚΩ, R5 15kQ, and R,…

A: Given data: The voltage is V1=9.0 V The resistance is R1=3 kΩR2=1 kΩR3=2 kΩ The given circuit is…

Q: A network with 12 branches and 8 independent loops has a number of nodes equals

A: Given data, Number of branches b = 12. Number of loops L = 8.

Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…

Q: Rewrite the following complex numbers in z = x+jy format. (a) z = (2 − j3)(−1+j2) - (b) z = = (-²) ¹…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: 2. The permittivity of the Earth's ionosphere can be described by an unmagnetized cold plasma model:…

Q: It turns out that the depth in the ocean to which airborne electromagnetic signals can be detected…

Q: 10. Fig. 9 shows a circuit which contains two independent sources and one dependent source. Find the…

Q: 2.11 Determine v, through v4 in the circuit in Fig. 2.75. 4 12 V

A: Given data, Circuit diagram is given as,

Q: Q3/ a) Find the admittance Y parameters for the network shown below 125 Q ww V₁ 16 T 500 75 V₂

Q: Design the transistor inverter of Fig. 11-4 to operate with a saturation current of 8 mA using a…

Q: A 50A, 230V meter on full load test, makes 61 revolutions in 37 sec normal disc speed is 520…

A: Given- 50 A, 230 V meter on full load test- 61 revolutions in 37 sec, Speed = 520 rev/kWhr, To Find-…

Q: 11) A binary receiver system receives a bit rate of 1 Mbits/sec. The wavefoem amplitude is 5 mV and…

Q: A short-shunt compound wound generator has a shunt field resistance of 77 ohms, a series field…

A: In this question We need to determine the output delivered power of the short shunt compound…

Q: V1 R1 Assume the following: V1 = 58 V V2 = 94 V 11 = 24 A R1 93 Ohms R2 = 23 Ohms R3 = 41 Ohms V2 R2…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: A series RLC circuit is excited by a 100 volts 79.6 Hz source. Resistance R is 100 ohms, Inductance…

Q: Find the Vth of the given circuit that is external to R2

Q: I1 m 40 Ω- 10 Ω M + Vo - 20 Ω M 4 io V1 If we would like to use Superposition to solve for Vo in the…

A: We need to find out the voltage across resistor due to individual sources .

Q: n₁-2 ve n₂-20 2 ise transmission coefficient = ?

A: We need to find transmission coefficient for given impedance.

Q: A 250V dc short-shunt motor takes a current of 5A. The shunt, armature, and series field resistances…

A: The question is about dc short shunt motor.

Question

What of the following is true about liquid dielectric?
O a.
O b.
O C.
d.
In practice, the choice is made mainly on the basis of its Thermal stability
100 times denser than gases
Adding 0.01% water to dry oil will reduce the dielectric strength by half
Castor oil is used for HV capacitors
D
لمندسة الكها
E Committee

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
1. What is the dielectric?
In a pure capacitive circuit, does the current lead or lag the voltage?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
r cut 1oum 20gm 1ocm 个 //// wax poper/ A capacitur is mad by sandwiching a sheet of wax psper between two sheebs of aluminum fail, as shoumm What is the figue. capacitance! I the capacitoris aut into twopieces, alme the hme, what oil be the expacitenel of each Diece ? wiggly What lo be the capactnce
8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
M EXPERIMENT 01 V(n002) V(n001) 10V- 8V- 6V- 4V- 2V- OV- -2V- 4V- -6V- -8V- -10V- 0.00ms 30.00ms 60.00ms 90.00ms 120.00ms 150.00ms 180.00ms K EXPERIMENT 01 X Diode 1N914 V Resistor SINE(0 10 60000 100) 10K .tran 2
In a capacitor which of the following is used to separate the two parallel plates? O Dielectric material Conductor O Semi conductor diamagnetic material
What are the types of semicondoctors available
Inductance
Each of the conductor in a parallel-plate capacitor is calleda. dielectricb. insulatorc. platesd. terminal