What is the steady-state value of the voltage across the capacitor in the figure shown below when the switch S₁ closed. Given that R₁ = 6.4 Q2, R₂ = 4.50, R3 = 3.202 C₁ = 12.6 μF and V₁ = 8 V S₁ H R3 R₁ R₂ Fig. 1. Switched circuit to charge and discharge a capacitor.

What is the steady-state value of the voltage across the capacitor in the figure shown below when the switch S₁ closed. Given that R₁ = 6.4 Q2, R₂ = 4.50, R3 = 3.202 C₁ = 12.6 μF and V₁ = 8 V S₁ H R3 R₁ R₂ Fig. 1. Switched circuit to charge and discharge a capacitor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Two systems are cascaded as shown below: x(t) hi(t) z(t) h₂(t) y(t) h(t) The impulse responses of…

A: For the first Question solution will be as

Q: (a) Calculate the average power absorbed by an impedance Z = 30 - 170 2 when a voltage V = 120 200…

A: We need to find out power absorbed by given impedance load .

Q: With R₁ =652, R₂ =9N, R3 =8N, R4 =32, R5 =100, R6 = 62, in the circuit below, calculate the voltage…

Q: 1. M = W X Y Z + W Y Z + X Z W X Y Z M

A: Techniques used to analyze k Map SOP ( sum of product) : it is used for min terms POS ( Product of…

Q: 4. Solve GOV the currents and find the voltage drop for each resistor. R₁ = 102 R3 57 R5 1522 the…

Q: Given the frequency f = 42 GHz, find the period in seconds. Provide your answer in seconds to the…

A: Given: The value of the frequency, f=45GHz

Q: 1 cm square 500 turns 20 cm 10 cm

Q: A six pole three phase induction motor runs with a synchronous speed of 1500 rpm. What is its…

A: Given: A three phase induction motor has, Number of poles, P=6. Synchronous speed, Ns=1500 rpm.

Q: V(t) t=0.04sec mu Vmax = 20 volt

A: We need to find out RMS Value and DC value and value of given voltage at given time instant

Q: The four main advantages of discrete event simulation should be discussed.

A: According to the question, we need to discuss the advantages of the discrete event simulation.

Q: Given the period T = 861 microsecond, find the frequency in rad/sec. Provide your answer in rad/sec…

Q: A 250V series motor in which the total armature and field resistance is 0.150 is working with…

A: In DC series motor Back EMF is directly proportional to product of Flux ( field current) and speed…

Q: * Assuming vin(t)=2sin(1000ft) volts and using simplified (2nd) diode approximation, the waveforms…

Q: A 100 KVA transformer with 4% impedance is connected in parallel with a 75 KVA with 3% impedance.…

Q: 40 W fluorescent lamp produces 3,200 lumens of light on a room having general dimensions of 8 ft x 6…

Q: Write an expression for F and simplify.

Q: A steel har needs 2000 AT to magnetise it. The voltage required for the magnetising coil of i00…

A: Given, Magnetomotive force, MMF=2000 AT. Number of turns, N = 100 turns. Resistance, R=20 Ω.

Q: What does it mean for a steady-state to be unstable (a.k.a, a source)? Explain..........

A: Generally for a control system, the output will be bounded for a bounded input. This is called a…

Q: The Thevenin voltage for the circuit is A) 5.0 V B) 10 V C) 6.67 V D) 8.33 V

A: Given data, Circuit diagram is given as,

Q: B-3-7. Obtain the transfer function E(s)/E;(s) of the elec- trical circuit shown in Figure 3–36. R₁…

A: The question is about transfer function of the given second order circuit.

Q: Determine and 2 in the given circuit. Assume =-6 A, 1/2=4 A, and 3 = 1 A. I 13. The unknown currents…

Q: 12 V 30 Ω R3 M a 50 R₂ Branch ab W 15 Ո R₁ ac bc cd ad bd 300 R₂ W 80 R₂ 18 V 2002 R₂ W C Vab Vac…

A: Given that: The circuit is shown below. Find KVL in given loop, substitute the voltage avariable,…

Q: The voltage at the terminals of a 0.6 μF capacitor is OV for t 0. Find (a) i(t = 0) TT msec; (b)…

A: Given, voltage at t<0,V=0 V Voltage at t>0 ,V=40-40e-15000t

Q: Problem 2: Determine the following: (d) Current gain (e) Power gain (f) Output resistance

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: A factory space 33 m x 13 m is to be illuminated with an average illumination of 72 lux by 200 W…

Q: 5. The current flowing through a heating element is 5 A when a p.d. of 35 V is applied across it.…

A: The heating element here is resistance. The circuit diagram will be as: According to ohm's law:…

Q: 1) Determine the transfer function Ra www Hılılı e(s) Vin(s) motor inartia In mater bearing for the…

Q: A coil of negligible resistance and inductance 100 mH is connected in series with a capacitance of…

Q: 1. Compute the equivalent capacitance and inductance between points a and b for the circuits below.

A: Given data, here the given circuits are including the series and parallel combination of inductor…

Q: Apply KVL to determine the current across resistor R₁ (bottom to top) in the following circuit where…

Q: Derive the equation, where, given the circuit VCoswt -VCoswt Vo R

Q: Determine the mathematical model of: a parallel RC circuit with an input voltage of Vs.

Q: Describe the state-of-charge (SOC) of a battery, and a method of estimating SOC.

A: We need to discuss the state-of-charge (SOC) of a battery, and a method of estimating SOC.

Q: 4. Find a) R₁ for Maximum Power Transfer, and b) Pmax 1852

Q: Determine the mathematical model of: . a series RL circuit with an input voltage of Vs.

Q: 5. Use source transformation to find the value of lo in the circuit. 6 ΚΩ 36 ΚΩ ww 3 ΚΩ 34 ΚΩ 6V 12V…

Q: 1. Use the block diagram algebra to reduce the multiple subsystems shown below and determine the…

Q: 2. Determine measures of performance in time-domain specifications such as percent overshoot,…

Q: Vs CH R₁ A Fig. 1. Simple resistor circuit. This is easy to solve using Ohm's law, V=IR. At any…

Q: Q3) Complete the table entries at the top of this page for transistors (a) through (g), under the…

A: Note : As per our company guidelines we are supposed to answer only first three sub-parts. Kindly…

Q: JOIN 3 circuits below(1,2 and 3) in a carry-ripple adder configuration and demonstrate binary…

A: According to the question, we need to design a circuit by joining 3 circuits, Circuit 1: a…

Q: If y = 4 sin (wt+25%) and i = 6 sin (wt-10%) v leads i by 35° v lags i by 35° y leads i by 15° v…

A: Given, Voltage, v=4 sinωt+25° V. Current, i=6 sin ωt-10° A.

Q: 1. Consider the circuit element shown below, where u(t)=√8 cos(3t-45°) and i(t) = 6 cos(3t). (d)…

A: Given data, Voltage is given vt=8cos3t-450 Current is given it=6cos3t

Q: Solve the following using the Laplace definition only, do not use shortcuts/given properties 1.…

A: By Laplace's definition we have: Lft=Fs=∫0∞e-st ftdt where f(t) is the given function in terms of…

Q: a. Calculate the total capacitance of the follow capacitors connected in series: C₁ -2.5 µF, C₂-2.5…

A: It is given that: C1=2.5 μFC2=2.5 μFC3=2.5 μF

Q: 1₁ V₂ (+) X1 = x2 = 2R R www y √x + Consider the network above, with R = 502, 1₁ = 3A, V₂=40V, and…

Q: V₁ ΤΩ ww 2 Ω 9 V 3 A V₂ 8 Ω www 4 A 10 V3 D 26 Figure (5) Use nodal analysis to determine the node…

Q: In this PNP transistor, what happens to the encircled part?

Q: A RL circuit has an emf of 5 volts, a resistance of 50 ohms, an inductance of 1 henry, and no…

Q: Vo + R ww 4R 3R www Io6A, Vo=340V, and R = 22. 2R www 2R a bo 3R www Vab R What is the voltage at a…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

SOLVE CAREFULLY!! Please Write Clearly and Box the final Answer

What is the steady-state value of the voltage across the capacitor in the figure shown below when the switch S₁ closed. Given that R₁ = 6.4 02, R₂ = 4.502, R3 = 3.202 C₁ = 12.6 μF and V₁ = 8 V
S₁
G
H
R3
'C₁
R₁
D
w
R₂
+V₂
Fig. 1. Switched circuit to charge and discharge a capacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
a. As capacitor charges, describe the behavior of: i.current with time ii. the voltage across the resistor with time iii. capacitor voltage withtime Explain the reason for each behavior.
An inductor is "charged" to some value, then connected in series with a 1002 resistor and allowed to "discharge". A measurement of the potential difference across the resistor is shown in the figure below. Compute the time constant of the circuit, the inductance of the inductor, and the initial current through the inductor. 12 10 8 6 Potential across resistor (V) 2 0 0 0.0001 0.0002 0.0003 0.0004 0.0005 0.0006 0.0007 time (s)
For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the voltage across the capacitor and the current delivered by the source. Find the time it takes for the capacitor to reach its final voltage and what value it is.
Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
When the switch is in position 2, the circuit will discharge the capacitor. Draw the circuit for the discharge phase. (without any of the charge phase components). and determine the time constant for the discharge phase and the equations for v(t) and i(t) for the discharge phase.
1. Find the voltages across the following components (a and b) after 1 second. The Capacitor is initially charged at 10V while the voltage source is 1V. Resistor R is 103 ohm while capacitor C is 1mF. a. Capacitor C b. Resistor R c. What is the best 1st order DE Method applicable to this problem?
What do you think will happen to the current if the frequency is adjusted higher in the pure inductance experiment? and what will happen to the current if the frequency is adjusted lower in pure inductance experiment? explain why please