What is the lighting and receptacle demand load for an 1000 sq. m office space with one hundred ten, 15 A, 250 V receptacles. [Office General Lighting Receptacle]
Q: b. 3.2 11) The following statements are the restrictions for VCO's proper operation, except for a.…
A: A Voltage Controlled Oscillator is used to control the output frequency of the system by controlling…
Q: G(s) = 2 12 (5+1) S² (5+6)
A:
Q: 4) Given the logic functions below: F=ПАВСР (1, 2, 6, 8, 10, 12, 14) Provide a K-Map of the function…
A: To find the minimum sum of product for the given Boolean equations using Karnaugh map:
Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…
A: Resistance = 0.25 ΩΩ Voltage = 300 V As a generator Ia = 100 As a motor Ia = 80
Q: 1. An N-type semiconductor bar is 2 cm long, has a cross-sectional area of 0.1 cm², an electron…
A: As question 1 is asked, i have answered it.
Q: d) Find z for 2z²-j5z-3=0 e) Find V in the AC circuit given in Figure 2.1. Calculate the modulus and…
A:
Q: 3) G(s) = 30* s(s-0.1) (s+0.25) (s+0.5) (s+2)3
A:
Q: I Consider the causal discrete-time LTI system described by the following constant coefficient…
A:
Q: A sequential circuit has two inputs, w₁ and wê, and an output, z. Its function is to compare the…
A: Given, A sequential circuit having Inputs are w1, w2. Output is z. If w1 = w2 for four consecutive…
Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…
A:
Q: Part B - Calculate the power transferred to the load in scheme A. PLA= Submit Request Answer Pline,…
A: Given that, Vs=120 V(rms),N=9,ZLoad=40+j20 Ω=44.72∠26.57 Ω ,RLine=0.7*19 Ω=13.3Ω. Here we have to…
Q: Problem 23.12 The electric field 4.50 cm from a very long charged wire is (2000 N/C, toward the wire…
A: It is given that:- Formula, E = 2kλr where, E = electric intensity λ = linear charge density r =…
Q: A coil with impedance 8+j6 Ω is connected in series with a capacitive reactance X. The series…
A: We need to find out the unknown resistor and reactance for given equivalent impedance.
Q: 5. At w = 10³ rad/s, find the input admittance of each of the circuits. www 2002 Yin www 2002 60 mH…
A: We need to find out the admittance for given circuit .
Q: In the circuit shown in Fig 12, at time t=0 switch S1 closes and switch S2 closes 8 s later. Find…
A:
Q: Consider the circuit shown below. Determine the maximum power that can be transferred to the…
A:
Q: Example S Find the F.T of the triangular pulse f(t) = A Tri (1)
A: Triangular Function Definition f(t)= Tri(t)=1-t, t<10, Otherwisef(t)= Tri(tT)=1-tT, tT<10,…
Q: Armature resistance of a 230V shunt motor is 0.6 0 and no load current is 5A. When the rotor is…
A: back emf of motor = terminal voltage - voltage drop in armature resistance. back EMF directly…
Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…
A:
Q: The resistance of a conducting material depends upon O The area of cross section and the length of…
A: We need to determine the parameters on which the resistance of conducting material depends.
Q: Given the closed-loop system in the figure with C(s) = K and G(s) = (s+2)(s+5) interval of the…
A: A mechanical or electrical device known as a closed-loop control system automatically adjusts a…
Q: What is the difference between single-phase and three-phase unification control circuits?
A: The differences between the single-phase unification control circuit and the three-phase unification…
Q: 2.) 34 ៩ IN 852 31052 DIA 2A 16 852 742 √₂ 1252 Det hade equations Find hode voltages by Gauss-…
A:
Q: With frequency f= 500 cycles/sec, what is the pure element in series with the R=25 ohms which causes…
A:
Q: What is the induced voltage in the inductor if it has an inductance of 100 mH and the instantaneous…
A: The given problem is from circuits. The detailed solution is given in the next step
Q: A 1 km long microwave link uses two antennas each having 30 dB gain. If the power transmitted by one…
A: Given,For the transmited and recieved antenna,Gain, Gt=Gr=30 dBOrGt=Gr=1×103 mAt frequency, f=3…
Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…
A:
Q: Q3: find the current through the 48ohm resistor in the circuit and assume the diode is silicon diode…
A:
Q: A conductor carries an instantaneous current i = 3 cos377t amperes. What is the average current over…
A: Given data Instantaneous current i = 3 cos (377*t) Amp Time t1=0 t2= 6 T = t2-t1= 6-0 T = 6
Q: BNC feed-thru 125 mm I 35 solder -30 mm 2mm copper wire 2 mm brass sheet 9 mm I groove A 1 2 Perspex…
A: A substance known as Poly-methyl Methacrylate (PMMA), an acrylic, is used by the company Perspex.…
Q: What happens when the resistance is measured, by plugging the resistor this way?
A: in bread board all horizontal nodes are connected to each other and vertical nodes are not connected…
Q: 2. At T = 300 K, the intrinsic carrier density of a GaAs sample is 1.8x106 cm³, Hn Р = 8500, and p =…
A:
Q: 3Ω + Vx 4Α t=0 18 Ω For the circuit, Determine the value of VouT(t) for t > 0. 12 Ω 0.5.Vx + + VOUT…
A:
Q: Given a Silicon PUT used in a relaxation oscillator with the following parameters: VBB-10 V. R-18k,…
A:
Q: Calculate maximums and minimums for Vs and Vo given the following circuit if Vin-110VRMS@60HZ,…
A: Given: A circuit of full wave rectifier along with a capacitor in parallel of load resistance.…
Q: Companies designs, creates, and sells Integrated Circuits (chips). What do your buyers use to…
A: Integrated circuits An integrated circuit is an advanced (more updated) version of the electric…
Q: Write the simplified output of the transfer function of the following block diagram. R(s), G₁ G₂ H₁…
A:
Q: A very lossy, long, 50 Q transmission line is open circuited at the load end. Find the input…
A:
Q: Q5 If you perform a Fourier transform of a signal that contains 200 time points sampled at 100 Hz,…
A: Given data, Sample frequency = 100 Hz for 200 times point. fs=100×200=20 kHz.
Q: Superposition Theorem,
A: Given diagram: By using superposition theorem: Case(1): When Current source (0.5A) is in an Active…
Q: b) The capacity factor for a plant capacity of 2850 c) The reserved load. d) The reserved factor. e)…
A: The Capacity factor for a given plant capacity is defined as the ration between the average annual…
Q: The power transmitted to the external load resistance of 10 ohms by the battery is maximum only if…
A: External Load = 10 Ω
Q: Suppose we know the system function H(z) of a discrete-time LTI system has a pair , double poles at…
A: For causal system, ROC must be outermost side of the outer most pole. For, anti causal system, ROC…
Q: Consider the following two discrete-time systems: (a) y(n) = x(n) + nx(n + 1) (b) y(n) = nx(-n) Fo…
A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…
Q: The skin depth at 10 MHz for a conductor is 1cm. Find the phase velocity of an electromagnetic wave…
A: Frequency (f1) = 10 MHz Frequency (f2) = 1000 MHz Skin depth (δ) = 1 cm = 10-2 m
Q: The current entering the positive terminal of a device is i(t) = 6e−2t mA and the voltage across the…
A:
Q: Problem 9. An alternating voltage is given by 282.8 sin 314t volts. Find (a) the rms voltage, (b)…
A: Given data:-v=282.8sin314t voltFind:-a. rms voltageb. frequencyc. instantaneous value of voltage…
Q: In three-dimensional (3D) space, divided into region 1 (x 0), where the conductivities for regions…
A:
Q: A 1 km long microwave link uses two antennas each having 30 dB gain. If the power transmitted by one…
A:
Q: 4. Consider the following circuit as a fun puzzle³. Each resistor has 40 of resistance and each…
A: 4.
Step by step
Solved in 4 steps with 4 images
- what is the receptacle load (after demand factors) for an office building with 250 receptacle outletsa) Determine total admittance and impedance. b) Draw admittance diagram and impedance diagram. c) Determine the values of C and L. d) Determine the voltage ?? ⃗ and the currents ?? (Se image ! last task)A company is producing a certain type of circuit breaker. The fixed cost is (450 000$), and the variable cost is (33$) per unit. The number of units that need to be sold to break even is 37500 units. Find the selling price (b) .per unit
- A homeowner wants to add 12 general-purpose receptacle outlets to the electrical drawings before the house is built, what additional load, in volt-amperes will they add to the service load calculation?What's the general lighting and general-use receptacle demand load for a 24-room motel where each unit is 700 sq ft?What are the steps for plotting points on microstation uisng offset, station, side and elevation?
- What spaces are not included in floor area when calculating the load in volt amperes per square foot.List and describe the different types of lighting classes available on the market. Discuss the different types of lights available for these classifications, say 5 key types of light bulb/ fitting per class. In addition, what types of lighting would be used in long car tunnels in comparison to a set of offices, or even streetlights? What factors would dictate the type of light used in each scenario? For the lights you think are most suitable for a tunnel and streetlight, discuss the construction of such lights and what materials need to be considered to make them suitable for their intended use.Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD. Lightning Arrester SD. Expulsion Tube SD. O All of the above.
- Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm. The turbine that has been selected by the local contractor is an Enercon wind turbine. The specifications of all the available Enercon wind turbine is shown in the attached datasheet. 1. Decide on the required number of wind turbines needed. 2. In your own words, explain what the Betz limit for wind turbines means.Can you finish the Background including a synopsis of the relevant information of this this example "electrical maintenance and repair" And please cite an article or paraphrase of author. Thank you! The electrical wiring and electrical devices in the houses that are installed may have failure so the inspection is designed to definitely perform the clear capabilities. These electrical devices are...A stand-alone pedestrian crossing sign is located in Miami, FL. The sign is lit 24/7 with tiny LED lights located on the perimeter of the sign, which are powered by PV. During the day the PV panel supplies its power to the lights and at the same time it charges the battery. During the night the power for the lights comes from the battery. The lights are ON for 1 sec. and OFF for 2 sec. The designers have recommended the following equipment for lighting the sign:• 1-15W PV panel (17”x14”), Operating voltage: 6V • 1- 6V, 12Ah battery, 75% eff. & maximum depth of discharge 80%.• 8- LED lights operate @ 6V and draw a combined current of 1 amp. Determine if the designers provided the right type of equipment for the sign to perform as required. Assume the winter peak sun hours for Miami are 4. Also, assume 4 days of sunshine and 2 days of no sun, therefore the battery has to store power for 2 days.