0.10.09AWholly turbu lent flow0.08-0.07-0.050.040.06-0.030.05-0.020.0150.040.010.0080.0060.03 -0.004D0.025-0.0020.02-0.0010.00080.0006Laminarflow0.00040.015-Smooth0.0002Transition range0.00010.000050.010.009-0.0080.000012(10)4 6 82(10)4 6 82(10)4 68.2(10)46 82(10')46 81010410510107Re = e VD Wetair outWater inA^^^Air inAir inWater outAn cooling tower (see the figure above) is used to cool water from 110 to 80°F. Water enters the tower at a rate of117639 kg/h. Dry air (no water vapor) flows into the tower at a rate of 66674 kg/h. If the rate of wet airflow out of thetower is 74424 kg/h, determine the rate of cooled water flow in kg/h.Answer:

The given values are as follows,The water enterat rate of=117639kg/hThe dry air flows at rate…

Wet air out Water in Air in Air in Water out An cooling tower (see the figure above) is used to cool water from 110 to 80°F. Water enters the tower at a rate of 117639 kg/h. Dry air (no water vapor) flows into the tower at a rate of 66674 kg/h. If the rate of wet airflow out of the tower is 74424 kg/h, determine the rate of cooled water flow in kg/h.

Wet air out Water in Air in Air in Water out An cooling tower (see the figure above) is used to cool water from 110 to 80°F. Water enters the tower at a rate of 117639 kg/h. Dry air (no water vapor) flows into the tower at a rate of 66674 kg/h. If the rate of wet airflow out of the tower is 74424 kg/h, determine the rate of cooled water flow in kg/h.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 7-72 What is the Air at 1500 kPa absolute flows in a 25-mm-diameter tube. maximum laminar flow rate. Use density of air = 14.04 kg/m³ and μ = 0.0000217 Pa-s. Ans: 0.061 L/s
Water in a 35-cm dia. has 62°F temperature and the discharge is measured as 0.3 m/s and the pressure of 200 Pa. The elevation of the center of the pipe is at 10.5 m a.m.s.l. What is the total energy of the flow? Is the flow laminar or turbulent? Viscosities of Water and Air
Air with a mass flow rate of 5 kg/s enters a horizontal nozzle operating at steady state at 450 K, 350 kPa, and velocity of 3 m/s. The nozzle is well insulated. At the exit, pressure is 300 kPa and temperature is 390 K. Using the ideal gas model for air, the area at the inlet is m², and the velocity at the outlet is Are potential effects negligible? Why? m/s. Is heat transfer negligible? Why? Note that you may choose to model the specific heat as constant.
Question 22 A flow of 125 gpm of chilled water at 45°F is to be transported from a chiller to a set of cooling coils located 120 ft away. Determine the chilled water velocity in ft/s that satisfies the requisite criteria. Assume turbulent flow and the sum of the loss coefficients effectively doubles the length of the piping. 6.32 5.52 C. 3.92 4.72
4. An ideal vapor-compression heat pump cycle with Refrigerant 134a as the working fluid provides 15 kw to maintain a building at 200°C when the outside temperature is 50°C. Saturated vapor at 2.4 bar leaves the evaporator, and saturated liquid at 8 bar leaves the condenser. Calculate (a) The power input to the compressor, in kW (b) The coefficient of performance. (c) The coefficient of performance of a reversible heat pump cycle operating between thermal reservoirs at 20 and 50°C. (h, = 244.09kJ/kg, s, = 0.9222 kl/kg – K; h2 = 268.97 kJ/ kg; h, = 93.42 kJ/ kg) %3D
Air flows from a 10 cm pipe in which the temperature and pressure are 4-C and 280 kPa, respectively, into a 5 cm pipe in which the pressure is 147 kPa gage. Calculate the velocity and discharge in each pipe, assuming isothermal conditions, standard atmospheric pressure and no losses. The gas constant for air is 287 N-m/kg-K.
A flow of 125 gpm of chilled water at 45°F is to be transported from a chiller to a set of cooling colls located 120 ft away. Determine the chilled water velocity in ft/s that satisfies the requisite criteria. Assume turbulent flow and the sum of the loss coefficients effectively doubles the length of the piping. I A) 6.32 5.52 3.92 4.72
10. A mixture of high pressure water and steam at a rate of 0.5 kgs-¹ flows up a vertical tube with an inside diameter of 25.4 mm at a pres- sure 22 bar. Determine the type of flow if the mass quality is 1%. The density of the water is 845 kgm 3, the density of steam is 10.8 kgm ³, and the viscosity of the water is 1.24 x 104 Nsm 2. Answer: Slug flow
The air in a certain room 150’ x 50’ x 12’ tested 0.2% CO2. Fresh air containing 0.05% CO2 was then admitted by ventilators at the rate of 9000 ft3/min. Find the % of CO2 after 20 min.
A closed container contains 3m high of kerosene (SG = 0.85), water, and 0.7m high of an unknown liquid (SG = 2.2). The air pressure above these mixture is 20 KPa while the pressure at the bottom of the tank is 88 KPa. Determine the height of water. A 2.53 m B 2.84 m C) 2.08 m D No answer among the choices E 3.26 m
Q/In Figure No. (4) the value of pressure of compressed air pa in pipe No.(1) is 3.8 (Bar). Find the value of pressure of water pg in pipe No. (2). B Pipe No.(2) water comressed Air Pipe No.(1) 4.5m water xA 2.7m 1.2m Air (2) (1) Fig.(4) Mercury
... ... Example 5: The water level in a tank is 15 m above the ground. A hose is connected to the bottom of the tank, and the nozzle at the end of the hose is pointed straight up. The tank cover is airtight, and the air pressure above the water surface is 3 atm gage. The system is at sea level. Determine the maximum height to which the water stream could rise 3 atm 15 m h