Weights of a certain product follow Normal Distribution with unknown parameters. Based on the past experience, we knew that 7.5% of all the products weigh less than 11.188 gr and 6% of all products weigh more than 18.0765 gr. Subject to the experience, calculate parameter values of the distribution.

Weights of a certain product follow Normal Distribution with unknown parameters. Based on the past experience, we knew that 7.5% of all the products weigh less than 11.188 gr and 6% of all products weigh more than 18.0765 gr. Subject to the experience, calculate parameter values of the distribution.

College Algebra (MindTap Course List)

12th Edition

ISBN:9781305652231

Author:R. David Gustafson, Jeff Hughes

Publisher:R. David Gustafson, Jeff Hughes

Chapter4: Polynomial And Rational Functions

Section4.6: Rational Functions

Problem 11SC: Find the mean hourly cost when the cell phone described above is used for 240 minutes.

See similar textbooks

Similar questions

Find the mean hourly cost when the cell phone described above is used for 240 minutes.
The owner of a used car dealership is trying to determine if there is a relationship between the price of a used car and the number of miles it has been driven. The owner collects data for 25 cars of the same model with different mileage and determines each car's price using a used car website. The analysis is given in the computer output. Predicto Coef 24157.2 -0.181 SE Coef t-ratio Constant 2164.1 2.965 0.046 0.000 Mileage 0.024 5.377 S = 3860.7 R-Sq = 68.0% R-Sq (Adj) = 69.5% Using the computer output, what is the value of the coefficient of determination? 0.46 0.68 0.70 0.82
Q1 (а) і. 10,000 vehicle speed traffic data were collected during the weekday on route FT050 at Batu Pahat, Johor. Suggest how to quantify and describe the basic characteristic of this data. Then explain how the method you suggested can help others to understand the data.
Shortleaf Pines. The ability to estimate the volume of a tree based on a simple measurement, such as the diameter of the tree, is important to the lumber industry, ecologists, and conservationists. Data on volume, in cubic feet, and diameter at breast height, in inches, for 70 shortleaf pines was reported in C. Bruce and F. X. Schumacher’s Forest Mensuration (New York: McGraw-Hill, 1935) and analyzed by A. C. Akinson in the article “Transforming Both Sides of a Tree” (The American Statistician, Vol. 48, pp. 307–312). The data are provided on the WeissStats site. a. obtain and interpret the standard error of the estimate. b. obtain a residual plot and a normal probability plot of the residuals. c. decide whether you can reasonably consider Assumptions 1–3 for regression inferences met by the two variables under consideration.
I want to examine the relationship between gas mileage of cars and the engine size (displacement in cubic inches). Which explanatory variable is Engine size Gas mileage Relationship between the two Both engine size and gas mileage Neither engine size nor gas mileage
Give an example of a variable that can be used asinstrumentfor the following endogeneity problems. In eachcase,explain why you think this is a good instrument.i.Y = Demand for Ethanol& X =EthanolPriceii.Y = Earnings & X = Leisure Time
Given the “data” determined by y = x^3 + (x-1)^2 with x = 0.1, 1.2, 2.3, and 2.9, calculate SSTO, SSR, and R^2. Then recalculate these using x = 0.3, 1, 2.45, and 2.8. Does where you collect your data (i.e., which values of x) appear to impact your interpretation of how good the linear model fits?.
Before every flight the pilot must verify that the total weight of the load is mess than the max allowable load for the aircraft. The aircraft can carry 43 passages, and a flight has fuel and baggage that allows for a total passenger load of 7,095 lbs. The pilot sees that the plane is full and all the passengers are men. The aircraft will be overloaded if the mean weight of the passengers is greater than 7,095/43= 165lbs. What is the probability that the aircraft is overloaded? Should the pilot take any action to correct for an overload aircraft? Assume that the weights of men are normally distributed with a mean of 174.4lbs and a standard deviation of 39.6
A cereal company claims that mean weight of the cereal in its packets Is less than 14oz
A photoconductor film is manufactured at a nominal thickness of 25 mils. The product engineer wishes to increase the mean speed of the film, and believes that this can be achieved by reducing the thickness of the film to 20 mils. Eight samples of each film thickness are manufactured in a pilot production process, and the film speed (in microjoules per square inch) is measured. For the 25-mil film, the sample data result is = 1.15 and 81 = 0.11, while for the 20-mil film, the data yield 2 = 1.06 and 82 = 0.09. Note that an increase in film speed vould lower the value of the observation in microjoules per square inch. (a) Do the data support the claim that reducing the film thickness increases the mean speed of the film? Use a = 0.10 and assume that the two population variances are equal and the underlying population of film speed is normally distributed. What is the P-value for this test? Round your answer to three decimal places (e.g. 98.765). The data the claim that reducing the film…
Before every flight the pilot must verify that the total weight of the load is mess than the max allowable load for the aircraft. The aircraft can carry 42 passages, and a flight has fuel and baggage that allows for a total passenger load of 6,846 lbs. The pilot sees that the plane is full and all the passengers are men. The aircraft will be overloaded if the mean weight of the passengers is greater than 6,846/42= 163lbs. What is the probability that the aircraft is overloaded? Should the pilot take any action to correct for an overload aircraft? Assume that the weights of men are normally distributed with a mean of 181.8 lbs and a standard deviation of 37.3 the probability is approximately?
Which of the two variables, the time spent by male children or the time spent by female children, has a larger dispersion? Explain the answer by using an appropriate measure that can compare dispersions between variables