Using superposition theorem, find the value of output voltage Vo in the circuit shown in Fig.5 4 A www 2 2 6 A(T Vo 6 V www

Q: Q2: Find R for the circuit in Fig. 5Ω Rab 8Ω 2 2

A:

Q: Q: Use the superposition theorem to find v 12 2 8 V 10Ω 2 A +,

A: Problem We have to find v.

Q: A linear network has a current input 4cos (@ t+ 120°)A and a voltage output 10 cos(@ t+110°) V. What…

A:

Q: Analyze the circuit given below. 850 N 100 N 850 N 1 M2 9 V V 250 2 I mA Rk2 If R= 15 kQ, determine…

A:

Q: V DD M,(20/1) R R M,(10/1) V V ss Fig 6. Amplifier w/ active load

A: The given circuit diagram is shown below:

Q: Q3/ Use nodal analysis to find current i, in the circuit of Fig.5 below if 1,(t) = 6cos(200t + 15°)A…

A: Nodal analysis is a technique used to calculate the currents in all the paths. Kirchoff current law…

Q: Q4: For the network of Figure below, if Vpp = 40 V, V, = 0.8 mV, ra = 40 k2, VGs(Th) = 5 V, and k =…

A:

Q: 3) Obtain the transfer function (s)/V (s) in the network in the network of Fig. 1. 152 www 192 V(s)…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the other question…

Q: Consider the circuit shown below and answer all of the following questions. t = 0 10Ω 40 V, = 20 V…

A: Given circuit shown

Q: Q.1/ For the circuit shown in Fig. (1), what is the region of operation when V; = 0V and 12V. Assume…

A: In the BJT circuit,  What is operation region of BJT for different different input voltage .  Output…

Q: 0,4 VA V. 50 1 5 A Vo 20 2 2s 10 V 10 Y3

A: The superposition theorem states that the current or the voltage in any element is obtained by the…

Q: For the circuit shown in Fig, find the output d.c. voltage. * 10:1 D3. DI Vptin) 115 Vms 60 Hz Vsec…

A:

Q: a 0.5i, 42 3 A

A: KCL (Kirchhoff's Current Law) states that the algebraic sum of current at node or junction is zero.…

Q: For fig.(a) find the values of Id For fig.(b), write the two equati +12 V Rp 3.6kn C, Vout 0.1 uF

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 15. Calculate the output voltages V, and Vz in the circuit of Fig. 25.108. [V2 =-2 V; V3= 4.2 V] 200…

A:

Q: For the circuit shown in fig. Use superposition theorem to find i & v 200 20V 100 200 100 SA 100

A: Superposition theorem: In a linear network consisting of multiple voltage and current sources acting…

Q: Obtain the node voltages in the circuit of Fig. below 1 3 A ) 12 A 2.

A: We will apply KCL at node 1 and 2, solving equations gives node voltages

Q: Calculate the output voltage using the circuit of Fig for resistor components of value R-470Kohm…

A:

Q: Given the circuit below, what is the Thevenin equivalent? 12 Q 16 Q 10Ω 18 V

A: To calculate the Thevenin equivalent we will first find Thevenin voltage. We will name the upper two…

Q: In the circuit below, find the current at the 2-ohm resistor when: (a) w = 1 rad/s (b) w = 5 rad/s…

A:

Q: 7. Use nodal analysis to find vp in the circuit shown in Fig. 4.37. 10 N 40 N 50 N 2 A 10 A 20 2 100…

A: The nodal analysis is a method used to calculate the voltages of the nodes using basic KCL equations…

Q: Calculate the gain (A = //V) for the circuit below. Show the details of your work. Write your…

A:

Q: H.W: Find the impedance at the input port of the circuit in Fig. 3.23. h, =2 k2 h12 10 h2 = 100 h2 =…

A: Given  h11 = 2000 ohm,  h12 = 10^-4 h21 = 100 h22 = 10^-5 S

Q: If V= 11 V, obtain an equation for vc as labeled in the circuit valid for all t>

A:

Q: O Discussion 1- What is the condition under which the superposition theorem can be applied 2-…

A: We need to state that the condition under which superposition theorem can be applied.

Q: 1 μF Vcc = 16V • 39 ΕΩ • 4.7 ΚΩ • 1.2 ΚΩ 10 F In the network shown, what is the current gain? ΤΗ 3.9…

A: Current gain: Current is the rate of the change of the charge. The current gain is denoted by Ai. Ai…

Q: 2. Determine VCC for the network of Fig. 5.155 if Av = -160 and ro = 100 k. oVcc 3.3 k2 82 k2 Vo Cc…

A: We know the gain formula , from gain formula we will calculate transconductance .from…

Q: Vc +10 V R, 3.6 k2 10 kS2 R2 RE 2.2 k2 2 kn

A:

Q: Use MESH ANALYSIS to find the value of vo(t) if the value of is = 10cost(30t+20°) A.

A:

Q: Determine the voltage gain AVL for the network of Fig. 5.173 with RL = 2.2 KQ 16 V *2.2 ΚΩ '68 ΚΩ…

A:

Q: (a) Draw the AC equivalent circuit for the circuit given in Fig. 4. (b) Calculate the overall/total…

A: Dc analysis of Q1theve n equivatent

Q: Q: Use the superposition theorem to find v 12 2 8 V 10 2 2 A

A: The circuit diagram: The response due to the voltage source is calculated as shown below:  vVoltage…

Q: 20 μA '2.7 k Ω RB + VCE =7.3 V %3D o 2.1 V 0.68 kΩ

A:

Q: Iculate the output voltages V, and V, in the circuit of Fig, .

A: There are two types of  OP-AMP on the basis of the applied input. Inverting  Non-inverting

Q: Using node analysis, find the voltage gain Av = V2/ in the circuit shown. 0,25N 1Ω. 0.252 I, V,…

A:

Q: as/ Find the value of R, for maximum power transfer in the circuit of Fig. Find the maximum power.…

A: This question belongs to circuit theory . It is based on the concept of maximum power transfer…

Q: Prob.5. For the network shown in fig. 2.19, determine the equivalent Thevenin's network. bl

A:

Q: +22 V 10 k2 39 k2 Ic 10 μF Vo 10 µF VCE B = 140 %3D 3.9 kQ 1.5 50 µF

A: We need to find current and voltage for given circuit

Q: 2i 10 N a 20 v: Voc OC

A: Given circuit:

Q: Prob.24. Calculate the current I through the 2 Qresistor in the network given below by using…

A: Referring to Fig.1,  The Millman's Voltage, V = V11R1 +V21R21R1+1R2=5115 +6118115+118=…

Q: Find the Norton equivalent with respect to terminals a & b in the circuit shown in Fig. 3. 20 0 1.8…

A:

Q: If v; = 5cos2t V in the circuit shown below, find vo. 0.25 F ww 1 H ll

A:

Q: Employ superposition principles to obtain a value for the current /y as labeled in the given…

A: Given circuit, By superposition theorem, consider 1V source first,

Q: Find the Thevenin voltage and resistance of the circuit shown. 10Ω )15 V 40 Q

A: Thevenin theorem states that any linear network with multiple number of sources and multiple…

Q: 5. Find I in the circuit of Fig.? 20 Ω 15Ω I, 4Ω 15Ω 50 15Ω 48 V 50 24 Ω 8Ω

A: If two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  If two…

Q: For the circuit in Fig. below, find the current i by using Superposition theorem. * 24 V 8 Ω +) 4Ω 4…

A:

Q: R, = 10 n Q#5 (10,5) a) Thevenize the circuit driving terminals A and B in Fig. Show the Thevenin…

A: The given circuit is,

Q: 4 32 a 25 V 20 N3 3 A b

A:

Q: +18 Re 3.3 k R 47 k2 10 uF 10 uF RL 10 kC RE 1.0 k2 C2 '10 uF 12 kΩ

A:

Q: For the circuit in Fig., find i, and i;, where V,=10V, V,= 20V, R,=5Q, R,=62, R;= 82 R1 ww ww R3

A: to find i1 ,i3 given that: V1=10V;  V2=20V R1=5Ω;   R2=6Ω;   R3=8Ω

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.