Use a table to compare the similarities and differences between potentiometry, coulometry, and voltammetry. Consider the following comparisons: (a) The electrical measurement (e.g., current, potential, and charge), (b) The types of cells (galvanic and electrolytic), (c) The fundamental equation employed for quantitative measurement (Nernst, Faraday, and Ohm's), and (d) The ability for qualitative determination.

Use a table to compare the similarities and differences between potentiometry, coulometry, and voltammetry. Consider the following comparisons: (a) The electrical measurement (e.g., current, potential, and charge), (b) The types of cells (galvanic and electrolytic), (c) The fundamental equation employed for quantitative measurement (Nernst, Faraday, and Ohm's), and (d) The ability for qualitative determination.

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter11: Dynamic Electrochemistry

Section: Chapter Questions

Problem 10P

See similar textbooks

Similar questions

A cell was prepared by dipping a Cu wire and a saturated calomel electrode into 0.10 M CUSO4 solution. The Cu wire was attached to the positive terminal of a potentiometer and the calomel electrode was attached to the negative terminal. (a) Write a half-reaction for the Cu electrode. (b) Write the Nernst equation for the Cu electrode. (c) Calculate the cell voltage.
a) Explain how a signal (voltage) is produced by the glass electrode.b) Give the line diagram and the Nernst equation for the glass electrode.
Consider the titration of Fe21 with Ce41. (a) Write a balanced titration reaction. (b) Write two half-reactions for the indicator electrode. (c) Write two Nernst equations for the cell voltage. (d) Calculate E at the following volumes of Ce41: 10.0, 25.0, 49.0, 50.0, 51.0, 60.0, and 100.0 mL.
Discuss design features of Standard Hydrogen Electrode (SHE). Using suitable diagram explain how SHE can be used to measure the standard potential of Magnesium (Mg) electrode.
(Please give clear handwritten answer) 0.1 M HNO3 solution at 298K was electrolyzed in Hittorf cell using platinum electrodes. After electrolysis, 34.2 mg of copper was deposited in coulometer which in series with the Hittorf cell. 50 mL of HNO3 solution was withdrawn from anode compartment after electrolysis and found to have a concentration of 0.0821 M. [Atomic mass Cu = 63]. (i) Find the transference number of H + and NO3 −. (ii) If 50 mL HNO3 solution was run off from cathode compartment, what would its concentration be?
Discuss design features of Standard Hydrogen Electrode (SHE). Using suitable diagram explain how SHE can be used to measure the standard potential of copper (Cu) electrode.
What is the purpose of immersing the electrode in a saturated KCl solution? Is it proper to store the electrode in deionized water? Why or why not? Explain clearly and thoroughly.
A concentration cell was made using a Zn metal electrode in a saturated solution of ZNCO3 for the anode half cell, and a Zn metal electrode in 1.00 M Zn2* for the cathode half cell. E for the cell was 0.148 V at 25°C. Calculate the Ksp for ZnCO3. (Note: For purposes of this exercise, carry out the calculation to three significant figures.)
1.) A sodium sulfate solution was electrolyzed using inert Pt electrodes. The cathode reaction was 2H2O + H2+2OH^-. If a current of 3.0 amp was used for 30 min, what weight of H2O gas would be produced? 2.) What volume of H2 gas at STP would be produced during the passage of 30,000 Coul in the electrolysis of H2O? 3.) Give the notation for the cell that utilizes the reaction: (a) Cl2 (g)+ 2 I^-(aq) to 2 Cl^-(aq)+I2(s), (b) what is the E^o for the cell? (c) which electrode is the cathode? 4.) The standard electrode potential fornthe Fe^2+ to Fe^(3+) + e - half reaction is -0.770V. (a) Using the Nernst equation [E=E^o - (0.059/n) log [Oxid]/[Red]]. Calculate the voltage of this half cell when the [Fe^3+] is 1.0 x 10^-3 and [Fe^2+] is 1.0 x 10 ^ -1. (b) Calculate the approximate equilibrium constant (K) for the half reaction.
Show detailed solution. A cell was prepared by dipping a Cu wire and a saturated calomel electrode into 0.10 M CuSO4 solution. The Cu wire was attached to the positive terminal of a potentiometer and the calomel electrode was attached to the negative terminal.(a) Write a half-reaction for the Cu electrode.(b) Write the Nernst equation for the Cu electrode.(c) Calculate the cell voltage.
(a) Determine the mass of Na,S2O3.5H20 required to prepare 0.1N solution in 50 ml volume. (b) Compare combustion of Anthracene and Xylene in sufficient supply of air. Which one will produce more carbon rich sooty flame and why? (c) Consider electrode potential data given in Question 4 (c). Predict which two electrodes combination will give maximum potential. Provide justification. (d) Explain two industrial applications of acidic buffer solutions. (e) Discuss the importance of Hess law with suitable example.
Complete the following, providing written work for each part in order to receive credit: (a) Use shorthand notation to describe an electrochemical cell that contains gold (Au) and chromium (Cr) electrodes.(b) Determine which electrode will function as the anode and which will function as the cathode when the cell runs under standard conditions.(c) Calculate ΔG° for the cell under standard conditions. Enter your value for ΔG° in kJ below; do not actually enter the units.