TWO SINGLE -PHASE ALTERNATORS'HOSE RESISTANCE AND SYNCHRONOUS REACTANCE ARE,RESPECTIVELY,J.025 AND 0-06 OHM IF THE MACHINES ARE OPERATING WITHOUT LOAD,HAS AN ARMATURE WINDINGCALCUL ATE THE CIRCULATING CURRENT IN THE WINDINGSIF THE ALTER-NATORS AIE PARALLELED: (a) WHEN THE EMFS ARE EQUAL AT 230 VOLTS,BUT ARE DIS PLACED 30° FROM A POSITION OF PHASE 'OPPOSITION; (b) WHENTHE VOLTAGES ARE. IN PHASE OPPOSITION, BUT ONE VOLTAGE IS 230 AND THEOTHEN IS 200 VOLTS ; (c) WHEN THE VOLTAGES ARE 230 AND 200, ANDDISPLACED 30° FROM A POSITION OF PHASE OPPOSITION:

Answered: Image /qna-images/answer/cebef3d1-dd24-482a-8a17-5ba22ebceffc.jpg

TWO SINGLE -PHASE ALTERNATORS HAS AN ARMATURE WINDING 'HOSE RESISTANCE AND SYNCHRONOUS REACTANCE ARE,RESPECTIVELY, J.025 AND 0-06 ONM IF THE MACHINES ARE OPERATING WITHOUT LOAD, CALCULATE THE CIRCULATING CURRENT IN THE WINDINGS IF THE ALTER- NATORS ARE PARALLELED: (a) WHEN THE EMFS ARE EQUAL AT 230 VOLTS, BUT ARE DISPLACED 30 FROM A POSITION OF PHASE 'OPPOSITION; (b) WHEN THE VOLTAGES ARE.. IN PHASE OPPOSITION, BUT ONE VOLTAGE iS 230 AND THE OTHER IS 200 VOLTS ; (c) WHEN THE VOLTAGES ARE 230 AND 200 , AND DISPLACED 30° FROM A POSITION OF PHASE OPPOSITION:

TWO SINGLE -PHASE ALTERNATORS HAS AN ARMATURE WINDING 'HOSE RESISTANCE AND SYNCHRONOUS REACTANCE ARE,RESPECTIVELY, J.025 AND 0-06 ONM IF THE MACHINES ARE OPERATING WITHOUT LOAD, CALCULATE THE CIRCULATING CURRENT IN THE WINDINGS IF THE ALTER- NATORS ARE PARALLELED: (a) WHEN THE EMFS ARE EQUAL AT 230 VOLTS, BUT ARE DISPLACED 30 FROM A POSITION OF PHASE 'OPPOSITION; (b) WHEN THE VOLTAGES ARE.. IN PHASE OPPOSITION, BUT ONE VOLTAGE iS 230 AND THE OTHER IS 200 VOLTS ; (c) WHEN THE VOLTAGES ARE 230 AND 200 , AND DISPLACED 30° FROM A POSITION OF PHASE OPPOSITION:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulation of the alternator at 100 A load at 0.8 leading power factor is ??
1.) A 6-pole, 3-phase, 60-Hz alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 0.025 Wb entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf per phase of the alternator. Subject Electrical machine 2
7. A 3-phase, Y-connected. 2-pole alternator runs at 3,600 r.p.m. If there are 500 conductors per phase in series on the armature winding and the sinusoidal flux per pole is 0.1 Wb. calculate the magnitude and frequency of the generated voltage from first principles. [60 Hz; 11.5 kV]
Two identical three-phase Alternators A and B share equally a load of 10 MVA at 33 KV and 80% lagging power factor. The synchronous reactance of each generator is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry a25 amperes at lagging power factor. What is the current delivered by Alternator B ?
7. A 3-phase, Y-connected, 2-pole alternator runs at 3,600 r.p.m. If there are 500 conductors per phase in series on the armature winding and the sinusoidal flux per pole is 0.1 Wb, calculate the magnitude and frequency of the generated voltage from first principles. 8. One phase of a 3-phase alternator consists of twelve coils in series. Each coil has an r.m.s. voltage of 10 V induced in it and the coils are arranged in slots so that there is a successive phase displacement of 10 electrical degrees between the e.m.f. in each coil and the next. Find graphically or by calculation, the r.m.s. value of the total phase voltage developed by the winding. If the alternator has six pole and is driven at 100 r.p.m., calculate the frequency of the e.m.f. generated. [60 Hz; 11.5 kV] [ 108 V; 50 Hz]
Two similar single phase alternators are operating in parallel. The armature winding resistance of each generator is 0.025 ohm and its synchronous reactance is 0.06 ohm. Calculate the angle between two equal voltages of 230 if the circulating current is 1,000 amperes.
There are 90 slots in the armature of a 3-phase, 50 Hz., 6 pole, star connected alternator. Winding is of double layer type and there are 20 conductors in each slot. Coil span is 2 slots less than the pole pitch. Calculate the flux per pole if the line voltage of 3300 V is required. Assume the emf to be sinusoidal.
b) Explain the conditions of parallel connection of alternators and how these conditions are fulfilled.
Two identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf lagging. The synchronous reactance of each machine is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry 125A lagging current. What is the current supplied by alternator B?
A three-phase alternator connected in delta of 100 KVA and 635 volts is tested for OCC, SCC and winding resistance, giving the following data: Based on the above data, obtain: a) - Equivalent circuit per phase of the alternator b) - Voltage regulation when operating at full load and feeding a load with power factor of 0.8 inductive. c) - Voltage regulation when operating at full load and feeding a load with unity power factor. d) - Voltage regulation when operating at full load and feeding a load with a power factor of 0.8 capacitive.
An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each containing 5 conductors. The winding is distributed and full pitch. All the conductors of each phase are in series and flux per pole is 30 mWb which is sinusoidal distributed.Calculate the number of pole.
A three phase star connected, 1500 kVA, 13 kV alternator has an armature resistance of 0.9 ohm and a synchronous reactance of 8.0 ohms. When carrying rated load voltage, calculate the generated voltage per phase at loads of a. Unity P.F. b. 0.8 lagging P.F. c. 0.8 leading P.F. d. Calculate the voltage regulation for each loads and determine best regulation.