The slit separation in a double slit optical experiment is increased. Which one of the following happens to the interference pattern shown on the screen? A. The minima stay at the same position. B. The minima get closer together. C. The maxima get further apart. D. The maxima stay at the same position.

The slit separation in a double slit optical experiment is increased. Which one of the following happens to the interference pattern shown on the screen? A. The minima stay at the same position. B. The minima get closer together. C. The maxima get further apart. D. The maxima stay at the same position.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Wave Optics

Section: Chapter Questions

Problem 3OQ: Suppose Youngs double-slit experiment is performed in air using red light and then the apparatus is...

See similar textbooks

Similar questions

Blue light of wavelength 450 nm falls on a slit of width 0.25 mm. A converging lens of focal length 20 cm is placed behind the slit and focuses the diffraction pattern on a screen. (a) How far is the screen from the lens? (b) What is the distance between the first and the third minima of the diffraction pattern?
(a) Find the angle of the third diffraction minimum for 633-nm light falling on a slit of width 20.0 m. (b) What slit width would place this minimum at 85.0°? Explicitly show how you follow the steps in Problem-Solving Strategies for Wave Optics
In Figure P27.7 (not to scale), let L = 1.20 m and d = 0.120 mm and assume the slit system is illuminated with monochromatic 500-nm light. Calculate the phase difference between the two wave fronts arriving at P when (a) = 0.500 and (b) y = 5.00 mm. (c) What is the value of for which the phase difference is 0.333 rad? (d) What is the value of for which the path difference is /4?
A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm. (a) If light from this lamp falls on a N slits separated by 0.025 mm, how far from the central maximum are the third maxima when viewed on a screen 2.0 m from the slits? (b) By what distance are the second and third maxima separated for l=486 nm?
Two slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?
What If? Suppose light strikes a single slit of width a at an angle from the perpendicular direction as shown in Figure P37.6. Show that Equation 37.1, the condition for destructive interference, must be modified to read sindark=masinm=1,2,3,
A double-slit experiment is to be set up so that the bright fringes appear 1.27 cm apart on a screen 2.13 m away from the two slits. The light source was wavelength 500 nm. What should be the separation between the two slits?
In Figure 38.4, assume the slit is in a barrier that is opaque to x-rays as well as to visible light. The photograph in Figure 38.4b shows the diffraction pattern produced with visible light. What will happen if the experiment is repeated with x-rays as the incoming wave and with no other changes? (a) The diffraction pattern is similar. (b) There is no noticeable diffraction pattern but rather a projected shadow of high intensity on the screen, having the same width as the slit. (c) The central maximum is much wider, and the minima occur at larger angles than with visible light. (d) No x-rays reach the screen.
A pinhole camera has a small circular aperture of diameter D. Light from distant objects passes through the aperture into an otherwise dark box, falling on a screen at the other end of I lie box. The aperture in a pinhole camera has diameter D = 0.600 mm. Two point sources of light of wavelength 550 mil are at a distance L from the hole. The separation between the sources is 2.80 cm, and they are just resolved by the camera. What is I?
Monochromatic light of wavelength 530 nm passes through a horizontal single slit of width 1.5 m in an opaque plate. A screen of dimensions 2.0m2.0m is 1.2 m away from the slit. (a) Which way is the diffraction pattern spread out on the screen? (b) What are the angles of the minima with respect to the center? (c) What are the angles of the maxima? (d) How wide is the central bright fringe on the screen? (e) How wide is the next bright fringe on the screen?
The Very Large Array (VLA) is a set of 27 radio telescope dishes in Catron and Socorro counties, New Mexico (Fig. P37.37). The antennas can be moved apart on railroad tracks, and their combined signals give the resolving power of a synthetic aperture 36.0 km in diameter. (a) If the detectors are tuned to a frequency of 1.40 GHz, what is the angular resolution of the VLA? (b) Clouds of interstellar hydrogen radiate at the frequency used in part (a). What must be the separation distance of two clouds at the center of the galaxy, 26 000 light-years away, if they are to be resolved? (c) What If? As the telescope looks up, a circling hawk looks down. Assume the hawk is most sensitive to green light having a wavelength of 500 nm and has a pupil of diameter 12.0 mm. Find the angular resolution of the hawks eye. (d) A mouse is on the ground 30.0 m below. By what distance must the mouses whiskers be separated if the hawk can resolve them? Figure P37.37
Optical flats are flat pieces of glass used to determine the flatness of other optical components. They are placed at an angle above the component as shown in Figure P36.49A, and monochromatic light is incident and observed from above, leading to interference fringes. Figure P36.49C shows the results of one of these tests. What is the approximate difference in the gap thickness between the left and right sides of the optical flat and the component? Is it possible to determine from this figure alone which side has the greater gap thickness (left or right)? Figure P36.49 Problems 49 and 50.