The node voltages in the circuit shown are vz = 5 V, v2 = 0 V, v3 = -8 V, v4 = 0 V Determine the values of the resistance R and of the gain A of the dependent current source. R V3 10 N 30 Ωξ 60 ΩΣ A(ix + iy) 10 Ω 10 V v2 V4 50 Ω 200 N 310 Ω 20 Ω ix iy 5Ω vị 10 N

Q: EXAMPLE 8.11 The network of Fig. 8.34 was analyzed as Example 7.7, resulting in Vase = 0.35 V and In...

A: The required parameters can be calculated by using AC analysis of the amplifier circuit.

Q: +13 V 4.5 kQ 1 ko 30 uF 10 uF Vo VI B = 69 10.5 1.5 ka 50 uF ww ww

A: In transistor DC biasing the capacitor becomes open circuit. The given circuit is voltage divider bi...

Q: 12 V 2.22k Rc SV Rb 4.7K GND

A: When the NPN transistor is used as a switch. The base current of the transistor is used to control t...

Q: A common base amplifier that has beta=90 is biased with a collector current of IC=1.2 mA, and connec...

A:

Q: +8V oVo て1 םאר4

A:

Q: circuit has one 10 Ohm resistor and you want to drop the current by a factor of two. Which of the me...

A:

Q: Design a combinational circuit whose input is a 4-bit number and whose output is the 2’s complement ...

A: The input of the circuit is the 4-bit number and the output is 2's complement of the input number. T...

Q: In the Ziegler-Nichols method, the critical gain was found to be 4.2, and the critical period was 2....

A: It is given that: Critical Gain=Ko=4.2Critical period=To=2.21 minDecaying ratio=14

Q: + 15 V Rc 1 k2 Vc 10 kNS Va 2N3904 R2 4.7 kn> VE RE >ikN Figure 11-1 Schematic diagram of circuit 1....

A: The answers are 1- (b) 2- (c) 3- (d) 4- (b) 5- (d) The detailed solution is in below images

Q: Carrier wave of frequency f = 1MHZ with pack voltage of 20V used to modulated a signal of frequency ...

A:

Q: What is the relation between reactance, resistance and impedance? O a. a. R-X O b. R+jX R+X O d. Rj ...

A: The solution is given below

Q: 2. For the network shown in the figure and the applied source: lic + IR i, = 5 x 10-3 sin(377t – 20°...

A: We will apply KCL at upper node and get: iR+iL+iC=iSe3kΩ+ej4kΩ+e-j2kΩ=5∠-20° mAe13-j4+j2=5∠-20°e(0.4...

Q: Evaluate the following: 3. sin - +icos- 6. 6.

A: DE MOIVRE'S THEOREM:De Moivre's Theorem states that the power of a complex number given in polar for...

Q: A Pi B Ci+1

A:

Q: 01 kn vit o Vo い a) Dekrmin Vo for Ct) () uele of vi b) Oraw V,

A: In this question,  Input voltage waveform is given.  Draw the output voltage waveform and output vol...

Q: An altermating voltage is given by V=150 sin(400t +0.55) volts. Find (a) Peak to Peak value, (b) r.m...

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for...

Q: 1. a) Use the mesh-current method to write a complete set of independent equations that could be use...

A: Given the circuit, as shown below: a) We need to use the mesh current method to write a complete se...

Q: A signal s(t) is ideally sampled at a sampling rate (a) 15HZ, (b) 9Hz, (c) 10HZ. If the sampled sign...

A: a f=15 Hzfm=6 Hzfs+fm=21 Hzfs-fm=9 Hz No aliasing

Q: Example 3: Find and sketch y(t)= x(t)*h(t) Where x(1) = 2[u(1-2) – u(1-4)] and h(t) = [u(1) – u(t-1)...

A:

Q: mplify the block diagram shown in following figure and obtain the closed-loop ansfer function C(s)/R...

A: The solution is given below 

Q: Consider the Circuit shown below: Rf Ri Vin Vo Solve for the voltage gain in dB if Rf-11.77kOhms and...

A:

Q: An inductor has an inductance of 1H. It is connected in series with a resistance of 23Ω. It is fed f...

A: This question belongs to circuit theory . It is based on the concept of transient analysis in RL cir...

Q: 3. Two balanced three-phase loads that are connected in parallel are fed by a three-phase line havin...

A: It is given that: Xph=j2 ΩFor load 1:P1=100 KW=100×103 WQ1=50 KVAr=50×103 VArFor load 2:S2=100 KVA c...

Q: Q1. Describe the following related to Current Transformer (CT): Draw the equivalent circuit diagram ...

A: Equivalent circuit diagram of CT in which, n=turns ratiors=resistance of 2° windingxs=reactance of ...

Q: H.W: Use a Karnaugh map to minimize the following POS expression: (B + C + D) (A + B + C + D) (Ā + B...

A:

Q: Calculate the following AC quantities: a. r'e b.rL с. A v d. V out

A: The required parameters can be calculated by using the DC analysis and AC analysis of given circuit.

Q: A signal r(t) is band limited to 5kHz: it is sampled at a very high rate of 100kHz using ideal sampl...

A:

Q: 29.52 What is the equivalent capacitance of the three capacitors in the figure ? 20 μF 13 µF 30 μF

A: Given circuit,

Q: Find the total resistance of the circuit

A:

Q: In the microcomputer-controlled class-A IGBT transistor d.c. chopper shown in Fig.2., the input volt...

A: Given Ra =0.28Ω La =30 mH Full speed n= 2500 rpm Ia  =30 A

Q: Find the equivalent resistance of the circuit a 4 A 4Ω

A: Given circuit:

Q: resistance of each of the given resistor. Use the samples presented in the discussion part as your g...

A: With this table , it is possible to answer only the ideal resistance value so i will answer that onl...

Q: In the circuit shown in Fig. 2.87, determine V, and the power absorbed by the 40-S resistor. 20 Ω 60...

A:

Q: Find the convolution of the following functions x[n] =[ 1 1 1 ] x[n] =[ 1 3 5 ] a. and b. What does ...

A:

Q: Is PABX enough to distribute telephone lines to every floor? Is there no need for a distribution box...

A: PABX: 1.It is a companies business solution that need many line for in-house and outside calls . 2.I...

Q: Q/Derive from Figure (1) the final equation and law (V4,V5) by assuming given data , the equivalent ...

A:

Q: 1. Find the Fourier Transform of the rectangular function

A: Note : According to the guidelines of the company if the questions are of different we supposed to a...

Q: Can a Water Heater and socket-outlets be combined in one circuit? Justify

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A voltage or cu...

Q: v (V)

A: 9

Q: EXAMPLE NO. 3 Find the node voltages in the circuit 3 2 20 V 6Ω 3 1 +. +, 2Ω 10 A 42 1Ω 4)

A:

Q: Draw 1.5 cycles of the analog signal and show the location and the value of each sample. [Q1] A sinu...

A: Given a sinusoidal signal having, Frequency, f = 800 Hz                   T=1f=1800 Hz=1.25 ms Sampl...

Q: Find i, i2, and iz in Fig. 2.73. - 5A 15A i2 IOA A B -6 A 2 A - 1A

A: In this question we will find unknown currents i1, i2 and i3...

Q: Resistance Color Bands 1.58 Q + 2% 6.15 Q + 0.25% 5.2 Q + 10% 7.3 kN + 5% 4.7 kQ + 20% 2.4 MQ + 5% 6...

A:

Q: Three-point charges are located in free space as follows: Q1 = 6 µC at P1(1, 2, 3), Q2 = -10 µC at P...

A:

Q: TRANSISTOR DC BIASING solve for IB, IC, IE and VCE

A:

Q: The 110 W light bulb in Fig. 2.122 is rated at 110 volts. Calculate the value of V, to make the ligh...

A:

Q: Mc エ2 Mc Me Mc トIs FS→-ダー→s→e 一ター>

A:

Q: | 4. Design a 7-tap FIR high pass filter with a cutoff frequency 1000 Hz and a sampling rate 5000 Hz...

A: Given,To design a FIR high pass filter - Order of the filter is,N=7The cut-ogg frequency is,fc=1000 ...

Q: My question is: What's with the aerial and why don't we have them on our phones today? Estimate the ...

A: Wireless Communication- Communication process which occurs wirelessly via transmitter and receiver. ...

Q: A1. Voltage sag is common power frequency disturbance that can last half of a cycle to several secon...

A: Voltage sag is an important consideration while analyzing the power quality. It is always recommende...

Current Division Method

The generalized current divider formula is given by the following relation below,