The masses of benzene and an unknown liquid droplets falling off from the same stalagmometer at 20 ° C were measured as 0.052 g and 0.042 g, respectively. Since the surface tension of benzene at the test temperature is 28.9 dyn / cm, find the surface tension of the other liquid at the same temperature.

Q: Heat is required to melt a solid. The amount of heat, called the heat of fusion, depends on the…

A: Given : Volume of coke = 340 mL  Initial temperature of coke = 20.5 oC Final temperature of coke =…

Q: Given that a 10.0 g sample of ice at 0.0 °C melts and then the resultant water proceeds to warm to…

A:

Q: Choose the substance with the highest viscosity A. water at 40 C B. water at 20 C C. water at 10 C…

A: Viscosity, density, surface tension are some common physical properties which are used to define the…

Q: The surface tension of water is 72 mJ/m–2. Calculate the amount of energy required to disperse one…

A: Surface area of sphere = 4πr2 Surface volume of sphere = 4/3 πr3 Surface tension of water = 72 mJ/m2…

Q: Estimate the molar heat of vaporization (in kJ)of a liquid whose vapor pressure doubles when the…

A:

Q: For water dy/dT=-1.64 x 10 JK-¹m-² From this and surface tension, calculate the specific surface…

A:

Q: Estimate the thermal diffusivity of butter at 20 degrees Celsius

A:

Q: N2 (MW = 28.02 g/mol) Melting point = -210.00 degrees C Boiling point = -196.00 degrees C Heat of…

A:

Q: Identify the true statements about surface tension. Molecules along the surface of a liquid behave…

A: Surface tension is directly proportional intermolecular forces of attraction  Solution is given in…

Q: Distinguish between the terms evaporation and condensation.

A: Distinguish between the terms evaporation and condensation.

Q: The surface tension and viscosity values for diethyl ether, acetone, ethanol, and ethylene glycol…

A: Intermolecular forces are the attraction forces present between the molecules, which is responsible…

Q: As a physicist, you put heat into a 500.0 g solid sample at the rate of 10.0 kJ/min while recording…

A: Before going into the exact solution of this problem, let us try to understand what latent heat and…

Q: Heat is required to melt a solid. The amount of heat, called the heat of fusion, depends on the…

A: Given : Volume of coke = 340 mL Density of coke = density of water = 1.0 g/mL Specific heat capacity…

Q: Water (a) “wets” some surfaces and beads upon others. Mercury (b), in contrast, beads up on almost…

A: The forces that lead to intermolecular attraction between molecules of liquid are defined as…

Q: mass m = 0.056 kg of benzene vapor at its boiling point of 80.1 °C is to be condensed by mixing the…

A:

Q: Using the data below, determine how much heat (in Joules) is required to convert 405.0 g of ice at…

A: we have to calculate the heat needed for the given conversion

Q: Evaporation of sweat requires energy and thus take excess heat away from the body. Some of the water…

A: Convert 20 ounce of water into grams 1 ounce =28.3495 g 20 ounce = 566.99 g

Q: The property of liquids that explains the formation of water droplets on a polished surface is…

A: Given that, The property of liquids that explains the formation of water droplets on a polished…

Q: A sample of water at 23 degrees Celsius required an input of 1.69 times 10 to the fourth power J of…

A:

Q: Suppose four 30-g ice cubes are added to a glass containing 200 cm3 of orange juice at 20,0°C.You…

A:

Q: What is the surface tension of water (i.e. the air--water interface) at a temperature of 25°C? (No,…

A: We need to give the value of surface tension of water (air-water interface) at a temp of 250C, to…

Q: Which property of water allows a razor blade to float on it without sinking? viscosity surface…

A:

Q: The surface tension of the alcohol propanol in air has a value of 23.70 units and the surface…

A: The imbalance of intermolecular cohesive force between molecules gives rise to surface tension.…

Q: You have three substances in front of you at room temperature. One is in solid phase, one is in…

A:

Q: Suppose four 30 g ice cubes are added to a glass containing 200 cm^3 of orange juice at 20,0 degrees…

A: Solution- The mass of juice is taken as 200g. The amount of heat released by water can be calculated…

Q: The evaporation of water is endothermic: H20(1) + 44.01 kJ H20(g) ---->

A: At a particular temperature amount of heat energy released or absorbed when a chemical reaction is…

Q: Would you predict the surface tension of gasoline, composed of molecules containing only carbon and…

A: Surface tension is the ability of liquid that opposes external forces due to the presence of the…

Q: Q.6: In given diagram, explain Tg and Tm for different materials? Liquid Glass Semicrystalline solid…

A: The given plots in the question clearly discusses about the phase change behaviour of several…

Q: How long (in seconds) would it take a 50.0 watt (1 watt = 1 J/s) heater to melt 10.02 g of Au(s)…

A: Given : Mass of gold = 10.02 g Initial temperature of gold = melting point temperature = 1064 oC…

Q: Which answer best describes the redistribution of matter or energy when melting takes place? more…

A: The question can be answered by considering one of the important thermodynamic concept such as…

Q: After performing an experiment to know if the ice cubes will sink or float in two separate jars…

A: An experiment was performed to know wheather the ice cubes will sink or float in two separate jars…

Q: The surface tension of isopropyl alcohol in air has a value of 22.39 units and the surface tension…

A: Substances with strong intermolecular forces will generally have a greater surface tension than…

Q: Calculate the amount of heat needed to melt 134. g of solid acetic acid (HCH,CO,) and bring it to a…

A: Given temperatures are Heat capacity for acetic acid = 2.06 J/g* °C Melting point of acetic acid =…

Q: Viscosity is a measure of a fluid's resistance to flow. So it is a measure of the liquid's ability…

A: Factors affecting on viscosity

Q: If the length of the column of mercury is (6 cm) in the triple point. What is its length at(-125)…

A:

Q: What amount of energy is required to change a spherical drop of water with a diameter of 2.00 mm to…

A: Diameter of big water drop = 2.00 mm. Then its radius = diameter / 2 = 2.00 mm / 2 = 1.00 mm = 1.00*…

Q: Determain the boiling point of water at 672 mm Hg.

A:

Q: 29. Which substance will have the greatest viscosity at 25 °C? A) CH;CH,OH B) HOCH;CH;OH С) НСО,Н D)…

A: STEP 1: The resistance offered between the multiple layers of the fluid during its flow is called as…

Q: A quantity of ice at 0oC is added to 64.3 grams of water in a glass at 55oC. What temperature will…

A: The ice is melting.  Hence it will need energy  And since the temperature of water is  55oC Hence…

Q: A scientist measures the boiling point of saltwater in a lab at an altitude of B00 feet above sea…

A: Both scientists on the basis of the boiling point that when boiling points are equal then heat…

Q: Which of the following observations is best explained by water’s high surface tension?

A: Introduction: Surface tension is the tension of the surface film of a liquid caused by the…

Q: Which of the following observations is NOT caused by the surface tension of water? O Insects can…

A: The tendency of a liquid to shrink into the minimum surface area possible is known as surface…

Q: What is the heat of fusion of a metal if 22.8 g of the metal requires 2935J to  melt?

A: Given that: Mass of metal (m) = 22.8g Heat (q) = 2935 J Heat of fusion ∆Hf =?

Q: It is already known the specific heat of water is 4200 J/kg/°C. The vaporization energy of water is…

A: Solution - According to the question - Given - To perform the conversion we need to do steps- 1)…

Q: 1. What error occurred by using (a) a single large piece of ice? Or (b) very fine shavings of ice?…

A: A). Using a single piece of ice As rate of heat absorption is directly proportional to the surface…