The diagram below Bustrates a NAT-enabled router connecting a LAN to the Internet. The IP addresses of the router's LAN and Internet interfaces are shown(H2)src 192.168.30.10: 2500dst134.210.1.99: 80192.168.30.1140.62.1.8src192.168.30.20: 2500dst 134.210.1.99 80src=dstInternetsrcdst(A)(B)(E)(F): ___(C)_: _(D)__: ____(G)__:The two host computers are each sending a packet to the same web server on the Internet Show the changes made by NAT to the IP addresses and port numbers of eachpacket as they are sent (provide your own sample values in coses where the actual values cannot be defined)AnSave and Sub

Answer is attached in step 2 along with explanation.

The diagram below ustrates a NAT-enabled router connecting a LAN to the Internet. The IP addresses of the router's LAN and Internet interfaces are shown (H1) src 192.168.30.10: 2500 dst 134.210.1.99 80 src dst 192.168.30.1 140.62.1.8 192.168.30.20 2500 134.210.1.99 : 80 The two host computers are noch sending a packet to same web server packet as they are sent (provide your own sample values in cases w src= dst - Internet src dst - (A) (B) (E) (F) : ___(C)_ : _(D)_ :___(G)_ (H) the Internet Show the changes made by NAT to the IP addresses and port numbers of each values cannot be determined)

The diagram below ustrates a NAT-enabled router connecting a LAN to the Internet. The IP addresses of the router's LAN and Internet interfaces are shown (H1) src 192.168.30.10: 2500 dst 134.210.1.99 80 src dst 192.168.30.1 140.62.1.8 192.168.30.20 2500 134.210.1.99 : 80 The two host computers are noch sending a packet to same web server packet as they are sent (provide your own sample values in cases w src= dst - Internet src dst - (A) (B) (E) (F) : ___(C)_ : _(D)_ :___(G)_ (H) the Internet Show the changes made by NAT to the IP addresses and port numbers of each values cannot be determined)

LINUX+ AND LPIC-1 GDE.TO LINUX CERTIF.

5th Edition

ISBN:9781337569798

Author:ECKERT

Publisher:ECKERT

Chapter12: Network Configuration

Section: Chapter Questions

Problem 13RQ

See similar textbooks

Similar questions

An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most signi cant bits are used as a network ID, and the 16 least signi cant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most significant bits are used as a network ID, and the 16 least significant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
NAT translation table LAN side addr WAN side addr 135.122.200.215 10.0.1.15 10,0.1.13 address 135.122.200.215 S: 10,0,1.27 2 D: 1 D: S: S: D: S: 10,0.1.15 D: 135.122,200,215 10.०.1.22
Which of the following instructions falls in the category of data transfer instructions? JUMP LOAD ROTATE AND
A router interconnects a subnet, where all the interfaces of the subnets must have the prefix 164.132.62/24. suppose that the Subnet is required to support up to 60 interfaces, provide a network address that satisfies the above.
SUBNET ADDRESSING Consider the router and the two attached subnets below (A and B). The number of hosts is also shown below. The subnets share the 23 high-order bits of the address space: 144.145.110.0/23 : A 175 hosts QUESTION 2 OF 10 Answer How many hosts can there be in this address space? 144.145.110.0/23 B Assign subnet addresses to each of the subnets (A and B) so that the amount of address space assigned is minimal, and at the same time leaving the largest possible contiguous address space available for assignment if a new subnet were to be added. Then answer the questions below. 84 hosts
A router with IP address 125.45.23.12 and Ethernet physical address 23:45:AB:4F:67:CD has received a packet for a host destination with IP address 125.11.78.10 and Ethernet phys-ical address AA:BB:A2:4F:67:CD. (I) Show the entries (a, b, c, d, e in Figure 1(a)) in the ARP request packet sent by therouter. Assume no subnetting. (II) The packet made in part (I) is encapsulated in a data link frame. Fill in the fields fand g in Figure 1(a). (III) Show the entries (h, i, j, k, l in Figure 1(b)) in the ARP reply packet sent in responseto part (I). (IV) The packet in part (III) is encapsulated in a data link frame. Fill in the fields m andn.
) For the Internerwork shown in Figure Q4 below, Show the base configuration (do not include IP Routing) of RouterA assuming it is a DCE device connected to an El camer Take the IP addresses of the senal interfaces for RoutetA and RouterB to be 192.168.10 21/30 and 192 168.10.22/30 respectively. RouterA RouterB EO 192.168.10.65/26 EO 192.168.10 33/28
Design a classfull network addressing scheme that will supply the minimum number of hosts per subnet, and allow enough extra subnets and hosts for 25% growth in all areas. IP Address 172.16.0.0 FO/0 S/0/1 FO/O Sales Administrative Router A FO/1 SO/0/0 185 Hosts 30 Hosts Marketing 50 Hosts
Given the following topology of a network, the router Node 3 connects the two subnets together: Nodes 1 and 2 are 'inside' of the subnet neta, Nodes 4 and 5 are 'outside' of neta and Node 3 with a firewall is the gateway of neta. The two networks have the prefix 192.168 as the first two octets in their IP addresses, e.g, Node 1 has IP address 192.168.1.11. eth1: 1.11 eth1: 2.21 1 2 eth1: 1.12 neta eth 1: 1.1 3 eth2: 2.1 netb 4 5 eth1: 2.22 (i) Suppose in the firewall on Node 3 the default policy is ACCEPT. Write packet filtering rules for the following goal. Suppose Node 5 hosts a web server supporting both HTTP and HTTPs. Set rules in Node 3 that prevents Node 2 from browsing any web pages at Node 5. Now change in Node3 the default policy as DROP and write packet filtering rules for the following goal. (ii) Allow all nodes in the subnet neta to browsing HTTP pages hosted at Node 5. (iii) Allow hosts in netb to SSH into Nodel.
19. ARP is used for: O packet path determination O finding of a mapping IPV6 → MAC address O finding of a mapping IPV4 → MAC address O finding of a mapping IPV4 → TCP address
A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of the layers, an h-byte header is added. What fraction of the network bandwidth is filled with messages? Select one: a. 5h/(5h+M) b. M/(5h+M) c. M/(4h+M) d. 4h/(4h+M)