tank has one of its side inclined inward at an angle of 30 degrees with horizontal. The free surface of the contained water is at Elev 15.25 m. The orifice located on the inclined side issues a jet, having its vena contracta at Elev 10.70 m. If the highest point in the trajectory of the jet is at Elev. 14.00m, find the actual velocity of the jet

Q: Q1/ For fig shown if water flow rate is 60 lit/s , Find (h) Note that Density: Pwater = 1 kg/m³ Pair…

A:

Q: Find the power of motor needed to pumped the water at a head of 100m at the rate of 400 lps if pump…

A:

Q: A liquid with a specific gravity of 1.26 is being pumped in a pipeline from A to . At A, the pipe…

A: Given dataSpecific gravity SG = 1.26Diameter of the pipe at A D = 60cm = 0.6mPressure PA =…

Q: Water enters and leaves the 6-cm-diameter pipe bend inFig. P3.45 at an average velocity of 8.5 m/s.…

A: Write the given data:

Q: A four-stage centrifugal pump has four identical impellers, keyed to the same shaft. The shaft is…

A: A device which converts mechanical energy into pressure energy with the help of centrifugal force is…

Q: trifugal pump lifts water from a sump to a m is suction lift. The suction and delivery on pipe is…

A:

Q: A nozzle of 50 mm dlameter delivers a stream of water ai 20m/sec perpendicular to a plate that moves…

A:

Q: If a pump discharges 85 gpm of water whose specific weight is 61.5 lb/ft (g = 31.95 fps?), find (a)…

A:

Q: Q1/ For fig shown if water flow rate is 60 lit/s , Find (h) Note that Density: Pwater = 1 kg/m³ Pair…

A:

Q: Aa hydraulic turbine receive water from a reservoir at elevated of 50 m above it. What is the…

A:

Q: Q4 A centrifugal pump deliver (30/sec) of water to a height of (18 m) through a pipe (90 m) long and…

A:

Q: In centrifugal pumps, maximum efficiency is obtained when the blades are (A) Straight (B) Bent forw

A: Given: In centrifugal pumps, maximum efficiency is obtained when the blades are,

Q: Airflow in a Venturi tube with a flow rate of 2.12m³/s is shown in the figure. The density of air is…

A: Bernoulli's theorem  Bernoulli's equation states that the total head of the flow must be constant.…

Q: QI/ For fig shown if water flow rate is 60 lit/s, Find (h) Note that Density: Pwater = 1 kg/m %3D 1…

A: Given:Q=60 L/sρwater=1 kg/m3ρair=1 kg/m3D1=500 mm =0.5 mD2=25 cm =0.025 m

Q: Water at a guage pressure of 4 kPa flows at a rate of 250 l/s in a 135° pipe bend of diameter 300…

A:

Q: Example 3.4 A jet of water 100mm in diameter, moving with a velocity of 25m/s in the direction of…

A: given data:jet diameter (d)=100mm=0.1mwater jet velocity(V)=25m/svane velocity(u)=12.5m/sangle…

Q: 1. A Jet of water 50 mm diameter is discharging under a constant head of 70 meters. Find the force…

A:

Q: Q3: Find the diameter of a circular orifice to discharge (0.015m/sec) under a head of (2.4m). If the…

A:

Q: A hydroelectric plant is supplied with water by a 10 km duct leading from a dam to the turbines. The…

A: Given dataDiameter of duct = 2 mLength of duct = 10 km = 10000 mThe duct inlet is 10 m below the…

Q: A Pelton turbine with a 1.75 m impeller radius has a nozzle with a mouth diameter of 12 cm. Since…

A:

Q: a reservoir. Expr the stream at poir les of the velocitie

A: solution of above problem is below:

Q: siphon draws water fror nospheric pressure. Assur velocity at point P in the

A: introduction: we have to find out velocity at point P

Q: A river discharges into a reservoir at a rate of 400,000 ft'/s (cts), and the outflow rate from the…

A:

Q: A Pelton wheel develops 750 kW under ahead of 200 m. Its nozzie has a diameter of 10 cm and losses…

A: We have given data: P=750 kW Gross head, Hg=200 m, d=10 cm=0.1 m, Cv=0.98hf=90 Q2 , Q is in m3/s

Q: Air 25 kPa Blade Water 3m 659 Jet W

A: As given that air pressure = 25 kPa, The height of water in the tank up to opening = 3 m,  Weight of…

Q: ,2 A tank with a horizontal sectional area constant at 10m² and 4 m high contains water to a depth…

A: Consider the diagram as shown below for the given system.

Q: A centrifugal pump delivers water at a rate of 0.03 m'/sec to a helght of 18 meters through a pipe…

A: We have given data from the question are, Q=30 L/s=301000 m3/s=0.03 m3/sH=18 m,L=90 m

Q: 4. If a pump discharges 75 GPM of water whose specific weight is 61.5 lb/ft3 at local g= 31.9 ft/s?,…

A: Given data : Specific weight γ=61.5 lb/ft3 Acceleration due to gravity=g g=31.9 ft/s2 Flow rate=Q…

Q: Find the power (kW) if the area is 2.5 m2 and the head is 5 meters if water is running at 8 m/s.

A:

Q: 1. Calculate the volumetricflow rate of the siphon (cm³/s), assuming that L= 100cm, Az = 80 cm, and…

A: Siphon: It is a pipe or tube that is used to transfer a fluid in fluid mechanics. It can be to…

Q: constant velocity of 3 m/s?[ Note: Neglect the pressure force effects] DA 7.6 cm jet of water…

A: When jet strikes normally on the plate, then Normal force exerted on the plate and its expressions…

Q: A centrifugal pump is used to raise the water from the river to the reservoir, find: 1) total…

A:

Q: Q3\ Find the outlet area of converging duct of 25 mm inlet diameter and pressure difference between…

A: Givend1=25mm =0.025m∆Pρg=P1-P2ρg=5cm=0.05mQ=5 ltr/min=5×10-360=8.33×10-5 m3/s

Q: h h (а) (b)

A:

Q: For fig shown if water flow rate is 60 lit/s, Find (h) Note that Density: Pwater = 1 kg/m Pair = 1…

A:

Q: Dove the inlet. There is no signifi local acceleration of gravity is 9.5 ess? Explain using…

A:

Q: A four-stage centrifugal pump has four identical impellers, keyed to the same shaft. The shaftis…

A: Given, Number of identical impeller,n=4Number of revolutions, N=400rpmmanometric head,…

Q: With proper and complete answer. Neglecting friction.   Determine the exit velocity in (m/s) ?…

A:

Q: A pump delivers gasoline at 20°C and 12 m3/h. At the inletp1 =100 kPa, z1 = 1 m, and V1 = 2 m/s. At…

A: Given data: The discharge, Q = 12 m3/h. The inlet pressure, p1 = 100 kPa. The inlet velocity, v1 =…

Q: Water flows straight down from a downspout pipe. The cross-sectional area of the downspout pile is…

A: According to principle of continuity, if a fluid is flowing in a pipe then, mass flow rate of fluid…

Q: El. 84 m D EL 22.6 m A 0.30-m Ø El. 2.8m

A:

Q: The hydraulic efficiency of hydro-electric turbine is 85%, find the discharge Q in liters per…

A: Given data: η=85%P=10,500 kWh=320 m Need to determine the discharge in liters per second.

Q: constant velocity of 3 m/s?[ Note: Neglect the pressure force effects] DA 7.6 cm jet of water…

A: When a jet strikes flat plate, then it will apply the force only in normal direction to the plate,…

Q: - Given: Water from a pressurized tank fows out and creates a vertical jet as shown. 2. Total head…

A: Datum is considered as the dotted line in the given Figure. Given, Air pressure inside the tank,…

Q: A water intake at a pump storage reservoir (the figure) has a cross-sectional area of 0.722 m2. The…

A:

Q: Q3. A Pelton wheel has diameter of 3m and develops 800KW when rotating at 200rpm. What is the…

A: The speed of the turbine can be determined as,

Q: The pump in Fig. draws gasoline at 20 ° C from areservoir. Pumps are in big trouble if the liquid…

A: Patm=100 kPa From table  ρ=680 kg/m3Pv=5.51×104 N/m2

Q: Q1: Find the pump efficiency if the pressure difference across the pump is 230 kPa. If the outlet…

A: Given:  P2 - P1 = 230 kPa D2 = 7 cm = 0.07 m D1 = 14 cm = 0.14 m m = 50 kg/s Efficiency of motor =…