Take o = 200 kPa and oy = 680 kPa. Determine the equivalent state of stress on an element at the same point that represents the maximum in-plane shear stress at the point. (Figure 1) Figure 400 kPa 1 of 1 ♥ Part A Find the value of Tmax in-plane- Express your answer to three significant figures and include the appropriate units. Tmax in-plane Submit Part B μA Value Request Answer 5 A Units Find the value of ave Express your answer to three significant figures and include the appropriate units. 1 O Units input for part A ?

Q: Write a symbolic expression for the electric power consumed by a resistor      in terms of v, B, L…

A: The expression of electric power consumed by resistor is,P = Where,ε = EMF of the circuitThe EMF of…

Q: What is the electric force on a 5.0 nC charge placed between two square conducting parallel plates…

A:

Q: Calculate the period of revolution of Jupiter around the sun. The ratio of the radius of Jupiters…

A:

Q: Use the right-hand rule for the motor principle to determine the force on each of the following…

A: The thumb shows the direction of the forceThe index finger shows the direction of the currentThe…

Q: A beam of unpolarized light of intensity 4.04E3 W/m2 passes through a series of ideal polarizing…

A:

Q: What is the peak power consumption rate of a 60-W AC light bulb?

A: Rated power of the light bulb is:

Q: A proton (mp 1.67 x 10-27 kg) is traveling in a vacuum at 0.750 c, where c is the speed of light.…

A: Dear student, Since you have posted a question with multiple subparts, as per company guidelines we…

Q: Figura 3(e) I I 1 1 1.82 m

A:

Q: Problem 11: Consider a loop with 50 square turns that is 14 cm on a side and is in a uniform 0.65 T…

A: Torque, τ = 9 N.mTurns, n = 50Side, a = 14 cm = 0.14 mField, B = 0.65 T

Q: At a fabrication plant, a hot metal forging has a mass of 68.1 kg and a specific heat capacity of…

A: Mass of metal forging material, Specific heat capacity of forging material, Mass of the oil,…

Q: A spherical, convex mirror has a radius of curvature of 0.326 m. What is the focal length of the…

A: radius of curvature = 0.326 mFocal length = ?

Q: Water is flowing through a horizontal pipe in streamline flow at the narrowest part of the pipe: O…

A: In streamline flow, the product of cross section area and velocity remains constant (equation of…

Q: A heating element in a stove is designed to dissipate 2,445 W when connected to 240 V. (a) Assuming…

A: Given Data:Power dissipated at voltage  is Let, current at voltage  is Current and power dissipated…

Q: 3 d ed A merry-go-round is a playground ride that consists of a large disk mounted to that it can…

A:

Q: You have a 10 kg box sitting on a table. A rope connected to the box runs over a fully attached…

A:

Q: What is the result of 2A. (B-3C)? What is the result of A A+B B+C. C? . 3.B+C.C= A (9.71) + (1.12);…

A:

Q: The brass bar and the aluminum bar in the drawing are each attached to an immovable wall. At 20.9 °C…

A: Given data:Length of brass rod is Length of aluminum rod is At temperature , the gap between both…

Q: A beam of unpolarized light of intensity 4.04E3 W/m2 passes through a series of ideal polarizing…

A:

Q: One end of a brass bar is maintained at 303 °C, while the other end is kept at a constant, but…

A: The temperature of one end of the bar is 303oC.The cross-section area of the bar is 2.66x10-4 m2.The…

Q: Part (a)  Express the magnitude of the magnetic force on ab or cd, F1, in terms of the length L1,…

A:

Q: What is the number of quarks in a deuteron (2H) atom? Explain your reasoning and show all  your work

A: A deuteron (2 H) atom is the nucleus of an isotope of hydrogen, specifically known as "heavy…

Q: A capacitor with plate area 0.0440 m² and plate separation 95.0 μm is to be charged to 12.0V and…

A:

Q: tationary horizontal disk of radius R and Mass M is dropped on top of a rotating disk of same radius…

A:

Q: Light consisting of two wavelengths (1 633nm and A2 = 582 nm) is incident on a variable-width double…

A:

Q: (a)  Express the magnitude of the magnetic force F on the rod, in terms of the length L, current I,…

A: Mass of rod, Length, L=0.75 mCurrent, I=4.9 AMagnetic field, B=0.25 T

Q: 1- Mark the correct answer. In the figure, a current-carrying loop lies in an external uniform…

A:

Q: The figure shows an object and its image formed by a thin lens. Assume that d1 = 0.594 m, d2 = 0.317…

A: NOTE: All distances to the left of the lens are taken as negative and all distances to the right as…

Q: A 430 g, 8.5-cm-diameter can is filled with uniform, dense food. It rolls across the floor at 1.5…

A: Mass of the can Diameter of the can Linear speed of the can

Q: ▼ Part A How much work does an elevator motor do to lift a 1400 kg elevator a height of 190 m ?…

A: Given, mass of the elevator M = 1400 kg           height  h = 190 mWe know that the work done to…

Q: Which of the following produces greenhouse gases? a. burning fossil fuel b. digestive processes in…

A: Gases that trap heat in the atmosphere are called greenhouse gases.      eg - Carbon dioxide (Co2)…

Q: 5: A merry-go-round is a playground ride that consists of a large disk mounted to that it can freely…

A:

Q: A ski starts from rest and slides down a 25.00incline 85 m long.            a) If the coefficient of…

A:

Q: Protons having a kinetic energy of 2.50 MeV are moving in the positive x-direction and enter a…

A:

Q: What is the equivalent resistance of this circuit? R₂=3 www R₁=3 Q R₂=6 www Rs=3 52 R₁ =4Q

A: O

Q: The spring shown in (Figure 1) is compressed 60 cm and used to launch a 100 kg physics student. The…

A:

Q: 4: A rectangular loop with L1 = 0.75 m and L₂ = 0.65 m is sitting in a magnetic field B =…

A:

Q: Calculate the range of wavelengths (in m) for ultraviolet given its frequency range is 760 to 30,000…

A: given that , its frequency range is 760 to 30,000 THz .Calculate the range of wavelengths (in m)…

Q: 2: A wire of length L= 0.65 m and mass m = 0.095 kg carries a current of I= 0.75 A. The wire is…

A:

Q: A shopper standing 3.25 m from a convex security mirror sees his image with a magnification of 0.76.…

A:

Q: IP A parallel-plate capacitor filled with air has plates of area 6.6×10-3 m² and a separation of…

A:

Q: he magnetic coils of a tokamak fusion reactor are in the shape of a toroid having an inner radius of…

A:

Q: ure shows an object and its image formed by a thin lens. Assume that d1 = 0.919 m, d2 = 0.861 m, and…

A:

Q: QUESTION 2 For the gear train below, the numbers of teeth for individual gears are 12 (Gear #1), 18…

A: Given that  the output gear #4 has to rotate anti clockwise  @ 1500 rpm .to find out the direction…

Q: A puck of mass m, moving at a speed of v1 collides with an identical mass stationary puck. After the…

A: A puck of mass m, moving at a speed of v1 collides with an identical mass stationary puck. After the…

Q: the final velocity seems to be incorrect - ur supposed to add the intiital velocity and mass not…

A: This problem can be solved using conservation of momentum and kinetic energy in head-on collision.

Q: m/s. An eagle is flying horizontally at a speed of 2.8 m/s when the fish in her talons wiggles loose…

A:

Q: A magnetic needle with magnetic moment μ = 0.015 Am² is placed in a uniform magnetic field B = 0.45…

A:

Q: Figure 1.25 m/ +2.75 με +7.45 μC 1.25 m 1.25 m -1.72 μC Suppose the three charges shown in the…

A:

Q: 1.6x10C #2 a proton moves IN a circular path perpendicular to a magnetic Field of (0.2.35. T.). If…

A: A proton of charge q moving in a magnetic field B. Kinetic energy of electron moving in a circular…

Q: In an amusement park ride called The Roundup, passengers stand inside a 19.0 m-diameter rotating…

A:

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).