Suppose that the resistors in the various circuit diagrams represented the resistances of lightbulbs. When a lightbulb “burns out,” the circuit is open through that particular component, that is, R is infinite. Would the remaining bulbs continue to burn for the following conditions? If so, would the bulbs burn more brightly (draw more current) or burn more dimly (draw less current), if: R2 burned out in the circuit in series? R1 burned out in the circuit in parallel? R3 burned out in the circuit in series-parallel?

Suppose that the resistors in the various circuit diagrams represented the resistances of lightbulbs. When a lightbulb “burns out,” the circuit is open through that particular component, that is, R is infinite. Would the remaining bulbs continue to burn for the following conditions? If so, would the bulbs burn more brightly (draw more current) or burn more dimly (draw less current), if: R2 burned out in the circuit in series? R1 burned out in the circuit in parallel? R3 burned out in the circuit in series-parallel?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 53PE: A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit...

See similar textbooks

Similar questions

A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Find the current I through the circuit.I= (mA). Find the voltage across each resistor. Give your answer as a comma-separated list in unit of volt, as an absolute value. potential drops across R1, R2, R3, R4, and R5 (in volt, in order): What is the power supplied by the batteries—that is, the power dissipated or consumed by the circuit?P= (W).
In the circuit shown, two identical 1.5 V batteries (with the positive or high potential ends colored orange) are connected to three identical bulbs, A, B, and C. The current in bulb A is I0.A. What is the current in bulb B? Express your answer as a number multiplied by I0, and enter that number here: _____ × I0B. What is the current in bulb C? Express your answer as a number multiplied by I0, and enter that number here: _____× I0Suppose that each of the bulbs has a resistance of 50 Ω.C. Calculate I0, the current in bulb A.I0 = _______ amps
V1 1] Consider the circuit in the diagram with an unknown resistor R. The known resistor is R₁ = 1k, the power supply voltage is V, 12 Volts, and the measured output voltage is Vx8 Volts. Multisim insists on values, so I put -10 for the 12V unknown. I'll try to take this approach consistently in the homework diagrams, if possible. A) Determine the value of R. B) Determine the current i through the resistors. C) Determine the total power P supplied by the power supply. Hilt R1 ww 1kQ www Rx -122 XMM1 to is
In the circuit below, if the battery in the circuit below is 3V, resistor R1=2772, and resistor R2=4122, what is the total or net current in the circuit units of mA? High potential I R1 R2 + 12 I Low potential Note: It is understood that the unit of your answer is in milli-Amps (mA), however do not explicitly include units in your answer. Enter only a number. If you do enter a unit, your answer will be counted wrong.
Part A and B please. Each combination of capacitors between points a and b in the figure (Figure 1) is first connected across a 120-V battery, charging the combination to 120 V. These combinations are then connected to make the circuits shown. When the switch S is thrown, a surge of charge for the discharging capacitors flows to trigger the signal device. Part A How much charge flows through the signal device in the figure (a)? Part B How much charge flows through the signal device in the figure (b)?
In a Row Math Worksheet Draw a circuit diagram for a circuit that has one battery and two light bulbs connected in series. For the above circuit, one bulb has a resistance of 2 Q and a second bulb has a resistance of 3 Q. The total resistance for two bulbs in series is equal to the sum of their resistances. Use this equation to find the total resistance of the circuit: Rtotal = R1 + R2 For a circuit that has one battery and two light bulbs connected in series, one bulb has a
Question A5 State which of the following statements are true and which are false. Give reasons for your answers. a) A simple circuit consists of a battery connected across a resistor and a capacitor of equal values in series. In this circuit, the battery voltage is divided equally between the resistor and the capacitor. b) An ideal voltmeter has infinite resistance. After two half-lives, all of a radioactive specimen will have decayed. d) An electron can be in two places at once. e) When you travel at nearly the speed of light, your time slows down.
Item 6 The placement of resistors in a circuit is one factor that can determine the current passing through the resistor. You will be given three circuits, and for each circuit you will be asked to compare the current through the various resistors. In each of the circuits, all resistors are identical. Figure B A -www C 1 of 1 Part A Rank below the three identical resistors (A, B, and C) in (Figure 1) on the basis of the current that flows through them. Rank from largest to smallest. To rank items as equivalent, overlap them. ► View Available Hint(s) largest O The correct ranking cannot be determined. Submit Part B Complete previous part(s) Part C Complete previous part(s) B Provide Feedback Reset Help smallest
Find the expression for the equivalent resistance of 3 resistors (R1.R2.R3) connected in parallel. Sol. In a parallel connection, voltage drops across the resistors so: Using, Ohm's Law V=1 we derive, that 2 = V2/ I3=V3/ Since, the voltage is the same on all resistors, then V= V = Substituting to the, first equation above, we get the following |= V1/ + V2/ + V3/ So: 1 1 1 + + R2 1. Rea R1 R3
Three resistors, R1=20, R2-40n, R3-50 are connected to a battery as shown in the figure below. If the battery voltage is 35Volts, determine the power dissipated by R1. Express your answer in units of Watts, using zero decimal places. R2 R1 R3 V
Consider the circuit shown in the figure. Take R,=R, R2=2R and Ra3=R. Find the magnitude of the current passing through the resistor R3 in terms of V/R. Expre your answer using one decimal place. 3V R1 4V R2 R3