Answered: Solve for the value of the capacitance…

Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc - 2316 ohms. Round your answer to 2 decimal places. Add your answer

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A: Solution !!

Q: Given the function displayed below, create a block diagram. a. F = A B + C b. F = X Y + X’ Y + Y’…

A: This is a basic problem of logic gate function. The solution is given in the next step.

Q: Apply DeMorgan's theorems to each expression:

A: It is given that: a. X=AB'C+D''b.Y=A+B'+C+D''+ABCD''

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

Q: FOR THE CIRCUIT DETERMINE THE CURRENT LABELED L ву FIRST COMBINING THE FOUR SOURCES INTO A SINGLE…

Q: Two-three phase ac generators 1 and 2 are connected in parallel. The first generator has a per phase…

A: When two or more power generating or consuming unit connected in parallel then sum of active active…

Q: A 250V series motor draws a current of 40A. The armature resistance is 0.15 ohm and the field…

Q: 3. A bode plot of (1+jWT) has a) Slope of 20dB/decade and phase angle of tan¹ b) Slope of…

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A: We need to find out the current through load for given circuit .

Q: B- Consider the differential amplifier in Fig. 1. Where, Ir=1mA, Rc-10 KM2, VBE = 0.7 V (1). For Var…

Q: A corridor is lighted by 4 lamps spaced 15 m apart and suspended at a height of 5 m above the centre…

Q: 6. A 8 bit ADC has generated a digital representation of 11001100 using the successive approximation…

A: Given : Input digital bit : 11001100 Vref=VFS=10Vn=8

Q: Point charges q1 and q2 are held in place at the (x,y) coordinates specified below. Point P is a…

Q: For the circuit shown in Figure 2.54, use nodal analy- sis to find the current delivered by the 24 V…

Q: For each of the values of no given below, sketch the signal g[n] defined as g[n] = x[no - n]h[n],…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total Power Pt = 2500 W Side band power PSB = 400 W We have to determine the modulation percentage μ…

Q: 5. Minimize the following Boolean functions into sum-of products and product-of-sums forms using a…

Q: A single-phase source delivers power to three loads that are connected in parallel: (i) a resistive…

Q: 2. Determine the current I in each of the circuits given in Figure B. 1.5 V 7A (a) 3 A (b) Figure B.…

A: We need to find out current for given circuit .

Q: What is the equivalent resistance between the points A and B of the network. 202 Aww 492 g 1002 www…

A: We simplify above circuit to calculate equivalent resistance, as one can see in digaram:

Q: 4. Find v₁ and v₂ in the circuit below. Show all your calculations. 355 8 V €2000 €3,000 100 +…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total power of an AM wave Pt = 2500 W Sideband power PSB = 400 W We have to find the modulation…

Q: 2. Find Ix.

A: Given- Source current= IS1 = 2A IS2 = 4A Voltage source- V1 = 4 V To find- Current Ix =?

Q: Draw a block diagram given the function shown below: F = A B + C F = X Y + X’ Y + Y’ Z ( A + B’)…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: We need to find out modulation index for given AM signal .

Q: Write a function using the block diagram shown below: X у x' N D f

Q: A 500 lossless line has load voltage V₁ = 10 e/25° V and load impedance 50 e/³0⁰ 9. Find the value…

Q: H (jw) = Y(jw) X (jw) = 105(10 + jw) (1000 + jw) (1 + jw)(100 + jw)(10000 + jw)

Q: Consider continuous standard telephone channel, with bandwidth 3100 Hz perturbed by bandlimited…

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: Note: We have considered Half wave electric dipole antenna. According to the question, if power of…

Q: From the curcuit given below, determine the total amount of power in the series circuit. 50 V 5Ω 292…

Q: A unity feedback system, having an open loop gain G(s)H(s) = K(1-s) (1+s) becomes stable when A IKI…

A: Given- Unity feedback system , open loop gain, G(s)H(s)=K(1-s)1+s , To find- It is needed to find…

Q: Find the rank of the followng matrix For z1, find the rank of matrix A. A = 1 2 1 1 00 Find z such…

Q: consider two buses connected by an impedance of (0 + 5j) Q. The bus '1' voltage is 100 230° V, and…

A: Given- P=Line impedance angle, δ=30o,α=0o,A=D=1.0,β=5∠90o, To Find- The real and reactive power…

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: Introduction: A two-terminal passive electrical device used to limit or regulate the flow of current…

Q: A switch that can conduct positive on-state current, and can block positive or negative off-state…

Q: A gain of 11 is required from a noninverting constant- multiplier op-amp circuit. If the input…

A: Given Gain = 11 and R = 10k ohm Rf = ?

Q: Draw a block diagram of a detector for AM signal and show, using necessary processes and the…

A: The wave signal is shown in three separate sections, AM input wave, Rectified wave, and output wave.…

Q: If the current i flowing in the straight conducting wire as shown in the figure decreases, find out…

A: Solution !! Solution From right hand rule, the magnetic field by the straight wire is directed into…

Q: The frequency of the supply to the stator of an 8-pole induction motor is 50 Hz and the rotor…

Q: Use the Laplace transform to solve the initial value problem. Obtain Y (s) and y (t) 1.-y + 4y = e…

Q: A synchronous motor capable of operating with a leading power factor draws 15 kW from a distribution…

A: Synchronous motors revolve with a constant (synchronous) speed, as the name suggests. This type of…

Q: 4. Determine the power in the spectral components.

A: Given signal, VFM=100sin204.6π×106t+3sin30π×103t V

Q: Describe how the Medical Uses of Magnetic Fields.

A: Application of magnetic field in medical : There are various uses of magnet and magnetic field in…

Q: A self-inductance of 10 mH and its resistance 50 connect to AC source of voltage 200 V, and…

Q: The numbers are placed in the memory locations 2501 to 2504H. The sum is to be stored in the memory…

A: Solution !!

Q: use a P-N junction ideal diode to simulate a circuit measure and plot its I-V characteristics as…

A: According to the question, we need to show the theoretical calculation for the large signal piece…

Q: Use mesh analysis to obtain io in the circuit given below. Use Vv=80 V. www 2023 50 Vy 610 402 45 A…

A: We need to find out current for given circuit , we will find out it by using of mesh analysis

Q: For the circuit shown below. Find ib 9V 1 ΚΩ + www 3 ΚΩ ww • 2 ΚΩ + Ava

A: In this question, We need to determine the current ib as shown the circuit. We are solving this…

Q: A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Solve for the value of the capacitance (in nF unit) if R2 = 1017 ohms and Xc-2316 ohms.
Round your answer to 2 decimal places.
Add your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
Determine the total inductance in the below figure. L1 L3=6 mH, and L2 = L 4 = 2 mH. The result should be in mH Calculate Answers to 2 decimal points m m ell L2 illl LA
Two 10 uF capacitors have been connected in parallel across a 230 V 50 Hz AC supply. The current drawn from the supply will be approximately: Select one: a. 1.44 A b. 0.36 A c. 11.5 A O d. 23.0 A
(c) The capacitors are connected as shown in Figure 3 and charged by a 100 V battery. Find: The equivalent capacitance of the circuit ii. The total charge ii. The voltage drop across C3 iv. The charge on C1 C2 C3 2.00uF C1 6.00uF Vs 1µF 100v C4 4.00uF Figure 3
A 100uf capacitor and a3.6kohm are connected in series. How long will it take for the capacitor to change its charge completely?
(c) The capacitors are connected as shown in Figure 3 and charged by a 100 V battery. Find: i. The equivalent capacitance of the circuit ii. The total charge i. The voltage drop across C3 iv. The charge on C, 2.00uF C1 6.00uF HH Vs 1UF 100v C4 4.00uF Figure 3
MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR CAPACITANCE IN SERIES CONNECTION NO UPVOTE IF NOT ORIGINAL AND NO DIAGRAMS ONLY UPVOTE IF FOLLOWED INSTRUCTIONS SHOW COMPLETE SOLUTIONS
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.