Answered: Six forces, each of magnitude F or 2F…

Six forces, each of magnitude F or 2F are applied to a door. Rank the torques exhibited by each force from largest to smallest about the hinge. LIA * LIA F T₁+F T₂2F LI4 * LIA 2F T5 F 76

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter12: Rotation I: Kinematics And Dynamics

Section: Chapter Questions

Problem 45PQ

See similar textbooks

Related questions

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

Q: A proton travel inside of a velocity selector, it goes straight with a speed of 6.9 × 103 m/s…

Q: At what rate does the sun lose energy by radiation? The temperature of the sun is about 6000 K and…

Q: Find the total charge delivered by the battery in the capacitor network diagrammed below.

Q: orium sition -3 -2 -1 4 period of the motion T? (s) 3 2 0 -1 -2 -3 -4 acceleration (ms2)…

Q: Diagram below shows three types of wave phenomena, reflection,diffraction and refraction. Which in…

A: Light is a form of energy. When light rays are incident on any object then they are reflected and…

Q: An estimated force–time curve for a baseball struck by a bat is shown in the figure below. Let Fmax…

Q: A projectile is launched from the origin with an initial speed of 26.4 m/s at an angle 23.00 above…

Q: The length of the object is properly reported as ______ Ⓒ214m +0.05 dm Ⓒ210dm ±0.05 dm 210 dm +0.050…

A: The Greatest possible error of a measurement is considered to be one-half of the measuring unit in…

Q: A single ionized atom, that is deficient one electron, is traveling at in a straight line when it…

A: Given: The mass of the object is 6.68x10-27 kg. The strength of the magnetic field is 0.75 T. The…

Q: What is the electric and potential field at the surface of a balloon of radius "2r"?

Q: 3. What is the distance of separation between objects of masses 5.6 x 105kg and 8.8 x 106 kg if the…

Q: Water travels through a pipe at 4 m/s. The pipe changes from a radius of 0.75 m to a radius of 1.25…

Q: Hg. A 25° BWB

A: Draw the free-body diagram of block A.

Q: What is the electric potential at point P in the diagram below? a. 4kq/r b.3kq/r O c. kq/r d.2kg/d…

A: Given data: Two point charges at two corners of the triangle q1 = +7q and q2 = -3q The charges have…

Q: A nozzle with an area of 0.3 cm2 is attached to a garden hose with an area of 1.5 cm2. The flow rate…

A: area of nozzle = An= 0.3 cm2 area of hose = Ah= 1.5 cm2 volume flow rate = Q = 0.12 L/s

Q: A circular wire of radius R carries a current I. What is the magnetic field along the axis of the…

Q: A man is riding a skateboard; he is moving at a constant speed when he threw the ball into the air.…

A: Introduction of Laws of Motion: 1) Newton First Law states that "An object at rest stays at rest or…

Q: A rectangular loop with L₁ = 0.25 m and L₂ = 0.53 m is sitting in a magnetic field B = 0.35 T as…

A: 1. The force on ab (or cd) is given by F1=IL1B

Q: A hollow cylinder 1 m in diameter and 2 m high weighs 3825 N. a.) how many kN of lead weighing 110…

A: a) Let a volume V meter cubed of lead be fastened outside the cylinder. Now the total volume of…

Q: a 10 kg fish is swimming at 2 m/s swallows a 2 kg fish swimming toward it at a speed 4 m/s. what is…

A: Given data: Mass of bigger fish (m1) = 10 kg Initial velocity of bigger fish (u1) = +2 m/s Mass of…

Q: schoolboy is trying to pump up a bicycle tire so that its pressure is 0.6 × 105 Pa above that of…

A: Given Pressure (P) = 0.6 × 105 Pa Diameter of circular piston (d) = 0.025 m Area of circular…

Q: 4. In the following figure, a box of m₂=2.0 kg appears on an inclined plane with a coefficient of…

Q: A converging lens has a focal length of 20.0 cm. What is the magnification of the image when the…

A: Introduction of magnification of a lens: It is the ratio of image distance to that of object…

Q: Problem 1 The figure shows two concentric conducting thin spherical shells: • Sphere-A of radius R₁…

Q: Three polarizing filters are stacked, with the polarizing axis of the second and third filters at…

Q: Magnetic field is parallel to the plane of a current coil, then torque will be maximum Select one: O…

A: Given data: Magnetic field is parallel to the plane of the current coil Required: The torque will…

Q: A disk of mass 3.8 kg and radius 0.17 m starts at the bottom of a 25 degree incline. It's…

Q: A large metallic cylindrical barrel with a diameter of 4 m lies 25.0 m below the surface of Lake…

A: The pressure on circular top = Atmospheric pressure + pressure due to water=PA+hρg

Q: Let's try a few more examples that relate power and energy. A certain high-efficiency LED light bulb…

A: GIVEN power of bulb = P = 9.2 W Time for which it is left = 7.5 hrs

Q: The hydrogen spectrum is complex. When a hydrogen atom absorbs a photon, it causes the electron to…

A: Below I have provided the solution of the given question

Q: A merry-go-round (treat as uniform disk) with mass of 65 kg and outer radius of 3.1 meters, is…

A: Given:- A merry-go-round (treated as a uniform disk) with a mass of M= 65 kg The radius in which…

Q: A translational bowling ball of mass M and radius R = 20.0 cm is released with an initial velocity…

Q: Q6 / IF A, B, C are vectors from the origin to the points a, b, c show that (AXB) +(BXC) + (CXA) is…

A: As per question A, B, and C are vectors from the origin to the points a, b, c then we have to…

Q: - The elastic limit for steel is 2.48 x 108 Pa. What is the maximum weight that can be supported…

A: We know that Area from the figure A= 3.14*10-6 m2 and stress=FA F=Stress* areaF=…

Q: An insulated piston-cylinder device contains 0.05 m³ of saturated frigerant-134a at 32°C. The…

Q: Which of the following factors affect the strength of force experience by a current carrying conduct…

A: Below I have provided the solution of the given question

Q: When an object is dropped, the distance it falls in t seconds, assuming that air resistance is…

A: Given data: Initial velocity (u) = 0 The distance fallen by the object as function of time s(t) =…

Q: Problem 5 Two positive charges, 91 = 4x 10-⁹ [C] and q2 = 6x109⁹ [C], are separated by a distance of…

Q: A 0.40 kg block can slide up and down a rough 10-m-high, 30-m-long slope. At the bottom, a stiff…

Q: (9) A nonconducting infinite sheet of positive charge is located vertically, as shown in Figure. The…

Q: Consider the circuit below. If the voltage across the battery is 16.0 V, and R = 6.0 Ω, what is the…

Q: Two parallel wires carry a current I in the same direction. Midway between these wire is a third…

A: According to the given question, The following diagram can be drawn,

Q: An electric lamp whose resistance is 402 and conductor of 82 resistance are connected in series to…

A: Given data: Resistance of the electric lamp (R1) = 402 Ω Resistance of the conductor (R2) = 82 Ω…

Q: Problem: with their central axes along the x-axis I • Ring 1 has a radius R, 5 cm and a charge Q, =…

Q: radioactive isotope decays by emersion of a beta particle. Which of the following about beta…

A: Beta particles are the fast-moving electrons with high energy emitted by the radioactive decay of…

Q: The following figure shows four bars of equal mass rotating about their center. Rank their…

A: Rotational Kinetic Energy (KE) is given by: KE=Iω22 Here, I=Moment of inertiaω=Angular Velocity

Q: 12.0 N 30.0% b 10.0 N 9.00 N The figure shows one cylinder inside another. The inner cylinder has a…

Q: The dumbbells below are the all same size and the forces all have the same magnitude. Rank them in…

A: Torque is the product of force and distance. Tau = r x F = rF sin th

Q: When heat is transferred by molecular collision, it is referred to as heat transfer by O radiation…

A: Below I have provided the solution of the given question

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Six forces, each of magnitude F or 2F are applied to a door. Rank the torques exhibited
by each force from largest to smallest about the hinge.
L/4
*
L14
F
T₁+F
T₂2F
L14
*
LI4
2F T5
F
76

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Find the net torque on the wheel in Figure P10.23 about the axle through O, taking a = 10.0 cm and b = 25.0 cm. Figure P10.23
(a) When opening a door, you push on it perpendicularly with a force of 55.0 N at a distance of 0.850m from the hinges. What torque are you exerting relative to the hinges? (b) Does it matter if you push at the same height as the hinges?
The fishing pole in Figure P10.22 makes an angle of 20.0 with the horizontal. What is the torque exerted by the fish about an axis perpendicular to the page and passing through the anglers hand if the fish pulls on the fishing line with a force F=100N at an angle 37.0 below the horizontal? The force is applied at a point 2.00 m from the anglers hands. Figure P10.22
What are the necessary conditions for equilibrium of the object shown in Figure P12.1? Calculate torques about an axis through point O.
The fishing pole in Figure P10.28 makes an angle of 20.0 with the horizontal. What is the torque exerted by the fish about an axis perpendicular to the page and passing through the anglers hand if the fish pulls on the fishing line with a force F = 100 N at an angle 37.0 below the horizontal? The force is applied at a point 2.00 in from the anglers hands.
A uniform beam resting on two pivots has a length L = 6.00 m and mass M = 90.0 kg. The pivot under the left end exerts a normal force n1 on the beam, and the second pivot located a distance = 4.00 m from the left end exerts a normal force n2. A woman of mass m = 55.0 kg steps onto the left end of the beam and begins walking to the right as in Figure P10.28. The goal is to find the womans position when the beam begins to tip. (a) What is the appropriate analysis model for the beam before it begins to tip? (b) Sketch a force diagram for the beam, labeling the gravitational and normal forces acting on the beam and placing the woman a distance x to the right of the first pivot, which is the origin. (c) Where is the woman when the normal force n1 is the greatest? (d) What is n1 when the beam is about to tip? (e) Use Equation 10.27 to find the value of n2 when the beam is about to tip. (f) Using the result of part (d) and Equation 10.28, with torques computed around the second pivot, find the womans position x when the beam is about to tip. (g) Check the answer to part (e) by computing torques around the first pivot point. Figure P10.28
A force of F=(2.00i+3.00j) N is applied to an object that is pivoted about a fixed axle aligned along the z coordinate axis. The force is applied at the point r=(4.00i+5.00j)m. Find (a) the magnitude of the net torque about the z axis and (b) the direction of the torque vector .
Answer yes or no to the following questions. (a) Is it possible to calculate the torque acting on a rigid object without specifying an axis of rotation? (b) Is the torque independent of the location of the axis of rotation?
A rod 7.0 in long is pivoted at a point 2.0 m from the left end. A downward force of 50 N acts at the left end, and a downward force of 200 N acts at the right end. At what distance to the right of the pivot can a third force of 300 N acting upward be placed to produce rotational equilibrium? Sole: Neglect the weight of the rod. (a) 1.0 m (b) 2.0 m (c) 3.0 m (d) 4.0 m (e) 3.5 m
A person stands a distance R from a doors hinges and pushes with a force F directed perpendicular to its surface. By what factor does the applied torque change if the persons position and force change to (a) 2R and 2F, (b) 2R and F, (c) R and F/2, (d) R/2 and F/2?
What force must be applied to end of a rod along the x-axis of length 2.0 m in order to produce a torque on the rod about the origin of 8.0k Nm ?