SITUATIONAL ANALYSIS: Light bulb A is rated at 120V and 25W for household applications. Light bulb B is rated at 12V and 25W for automotive applications. (a) What is the current through each bulb? (b) What is the resistance of each bulb? (c) In one hour, how much charge passes through each bulb? (d) In one hour, how much energy does each bulb use? (e) Which bulb requires larger diameter wires to connect its power source and the bulb?

SITUATIONAL ANALYSIS: Light bulb A is rated at 120V and 25W for household applications. Light bulb B is rated at 12V and 25W for automotive applications. (a) What is the current through each bulb? (b) What is the resistance of each bulb? (c) In one hour, how much charge passes through each bulb? (d) In one hour, how much energy does each bulb use? (e) Which bulb requires larger diameter wires to connect its power source and the bulb?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 1RQ: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive...

See similar textbooks

Similar questions

1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive circuit?
An ac resistance is higher than a dc resistance. True False
20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ
Two 220 V fluorescent lamp units A and B are arranged to overcome stroboscopic effects. Unit A has aseries capacitor fitted and takes a current of 0.5 A at a PF of 0.9 leading. Unit B takes a current of 0.73A at 0.6 PF lagging. Determine the total current and the overall PF. Ignore PF improvement.
3. The figure on the left below shows a schematic diagram of a battery. The voltage measured by U1 is called the terminal voltage given R1 = 1 ohm. In the figure on the right below, the terminal voltage of each of the battery-resistor combination is Vr = 1.5 volts. Find the following: a. The current passing through R5. b. The currents passing through R1 and R3 C. The voltage across R1. d. The voltage of the battery EMF. e. The percentage of voltage loss ot the battery due to the internal resistance R1. The power dissipated by the internal resistance R1. g. The power dissipated by R5 if R1 = R2 = R3 = R4 = 0. h. The percentage of power dissipation loss due to the four resistors R1, R2, R3, and R4 f. R1 R3 S10 R1 U1 1.500 EMF EMF R5 100 V1 R2 $10 EMF R4 EMF EMF
When a voltage of 100V at 50Hz is applied to a choking a coil A, the current taken is 8A and the power is 120W, when applied to a coil B, the current is 10A and the power is 120W. what power will be is 10A and the power is 120W. what power will be taken when 100V is applied to the two coils connected in series?
Two 220 V fluorescent lamp units A and B are arranged to overcome stroboscopic effects. Unit A has a series capacitor fitted and takes a current of 0.5 A at a PF of 0.9 leading. Unit B takes a current of 0.73 A at 0.6 PF lagging. Determine the total current and the overall PF. Ignore PF improvement.
2. Fifty identical photovoltaic cells are connected in series. Every solar cell has a light generated current of 5.0 Amperes at 25 degrees Celsius. With a dark saturation current of 9 x 10-10 Amperes, a parallel resistance of 8.0 Ohms and a series resistance of 0.008 Ohms. Calculate for the current, voltage, and power delivered when the pn voltage of each cell is rate at 0.6 Volts.
Phase difference of voltage and current of an ideal resistor is zero a. True O b. False
What is the difference between active and passive loads
2. For the characteristics below. Determine the ff: a. ac resistance at l,=2mA. b. ac resistance at I,=25 mA c. Compare the results of part (a) and (b) to the dc resistances at each current level. Ip(mA) 30 25 20- 15- 10- 2 Ala 0.1 0.2 0.3 0.4 0.5 0.6 0.7 08 0.9 Vo(V) AV
A circuit has resistance of 20 ohms and a reactance of 30 ohms. What is the power factor of the circuit? a. 0 b. 0.55 c. 0.832 d. 0.99