S1 R C S2 L 00000 Assume S₁ has been closed and S2 has been open for a long time (so the capacitor is fully charged). The full charge on the capacitor is 0.000009 coulombs, R = 9 QQ, L= 0.012 henrys, C= 0.0000030 farads. Then S₁ is opened and S2 is closed and the circuit begins oscillating. Calculate the charge on the capacitor after 2 cycles.

S1 R C S2 L 00000 Assume S₁ has been closed and S2 has been open for a long time (so the capacitor is fully charged). The full charge on the capacitor is 0.000009 coulombs, R = 9 QQ, L= 0.012 henrys, C= 0.0000030 farads. Then S₁ is opened and S2 is closed and the circuit begins oscillating. Calculate the charge on the capacitor after 2 cycles.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 15RQ: A postage stamp capacitor has the following color marks starting at the upper-left dot: black,...

See similar textbooks

Similar questions

A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz
How should four 2.0 (F capacitors be connected (draw and name the circuit type) to have a total capacitance of (a) 8uF, (b) 2uF, (c) 1.5uF (d) 0.5uF?
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW
4. Find Idc, Vdc and the capacitance that will force the Vr(pp) to 2mV. Draw the output waveform across the capacitor. Fin=60HZ. TX1 D1 Ge Vac Lst 230V Lp 1 RL 12-0-12 Center tapped CL 1k D2 Ge 2
Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF)