8) PLEASE BE CLEAR ON YOUR RESPONSE AND ACCURACY, THANKS. Reflection by thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1and 3. (The rays are tilted only for clarity.) The waves of rays r, and r, interfere, and here we consider the type of interference to beeither maximum (max) or minimum (min). The table below provides the indexes of refraction ng, n2. and ng, the type of interference,and the thinlayer thickness Lin nanometers. Give the wavelength that is in the visible range.ngn2n3Type L A1.43 1.54 1.82 min 254NumberiUnits

Given:- n1= 1.43 n2= 1.54 n3= 1.82 type = min L = 254 Find:- The wavelength that is in the…

Reflection by thin layers. In the figure, light is incident perpendicularly on a thi and 3. (The rays are tilted only for clarity.) The waves of rays r and r, interfer either maximum (max) or minimum (min). The table below provides the index and the thinlaver thickness Lin napom eters Give the wavellength that ie in th

Reflection by thin layers. In the figure, light is incident perpendicularly on a thi and 3. (The rays are tilted only for clarity.) The waves of rays r and r, interfer either maximum (max) or minimum (min). The table below provides the index and the thinlaver thickness Lin napom eters Give the wavellength that ie in th

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 97AP: A diffraction grating with 2000 lines per centimeter is used to measure the wavelengths emitted by a...

See similar textbooks

Similar questions

A ray of light with wavelength 400m passes in a block of ice with n=1.40 that is surroinded by air. 1. What is the min angle for ray 2 that should creatr total intrnl reflectjon (the critical angle). 2. To get critical angle for ray 2, what is the angle of ray 1. 3. What is the energy of the light.
In the diagram shown, waves from the bottom left reach the barrier between one medium and another. The ight gray vertical ine in the diagram marks the border between the two mediums. Which statement best describes what happened to the waves? O The waves reflected off of the barrier, and the angle of incidence equals the angle of reflection. O The wave is moving faster in the medium on the left than it is in the medium on the right, which caused the waves to get shorter and turn. O The wave interfered with the new medium, which caused the waves to get shorter and turn, O The gravitational field in the material on the right is stronger than on the left, which puled the waves in that direction,
Use the worked example above to help you solve this problem. If the spacing between certain planes in a crystal of calcite (CaCO3) is 0.3 nm, find the grazing angles at which first- and third-order interference will occur for x-rays of wavelength 0.0692 nm. 0₁ 02
= Two light rays (1 and 2) travelling in air (na : 1) from source S (1 m above the surface of water) and meet at a point P on a screen (1 m above the surface of water), as shown below. Light ray 2 reflects from the surface of water (nw 1.33). Determine: = i. the phase difference of the light rays at point P, if wavelength of the light is 500 nm. ii. for what wavelengths we will have constructive interference at P? S Ray 1 Ray 2 Air 2 m Water 1 m
A beam of monochromatic light is incident on a single slit of width 0.630 mm. A diffraction pattern forms on a wall 1.35 m beyond the slit. The distance between the positions of zero intensity on both sides of the central maximum is 2.10 mm. Calculate the wavelength of the light. .049 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. nm
A. Determine the extra distance traveled by the wave leaving the bottom of the lower slitas compared with the wave leaving the top of the upper slit and illustrate that distance onthe above figure B. On the figure, sketch the diffraction envelope C. Label the region corresponding to the central diffraction maximum and the regions cor-responding to the secondary diffraction maxima. Also, label the central interference fringeand the fringes corresponding to m = 2, m = −3 and m = −6. Explain as needed
White light is incident on the surface of an oil slick (thin film) on water at an angle of 33 degrees from the normal. Given that the index of refraction of water is 1.33 and that of the oil is 1.4 a, write the expression of the phase change of the refracted wave after emerging from the oil slick (phi2) b, write the expression of the phase difference between the two waves (delta phi) c, Write the condition of perfect destructive interference in this case. d, make the thickness of the oil film (t) the subject of your expression in c), simplify it and write t as function of m and lambda. e, compute the smallest thickness of the oil film that will suppress the reflection of the green light of 532 nm wavelength. f, which thickness will be required to produce the next complete destructive interference of this green light in the reflection spectrum?
Reflection by thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1 and 3. (The rays are tilted only for clarity.) The waves of rays rį and r2 interfere, and here we consider the type of interference to be either maximum (max) or minimum (min). The table below provides the indexes of refraction n1, n2, and ng, the type of interference, and the thinlayer thickness L in nanometers. Give the wavelength that is in the visible range. ng n1 n2 n3 Type L A
Transmission through thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1 and 3. (The rays are tilted only for clarity.) Part of the light ends up in material 3 as ray ra (the light does not reflect inside material 2) and ra (the light reflects twice inside material 2). The waves of r3 and r4interfere, and here we consider the type of interference to be either maximum (max) or minimum (min). The table below provides the indexes of refraction n1, n2, and n3, the type of interference, and the thinlayer thickness L in nanometers. Give the wavelength that is in the visible range. n1 n2 n3 Type L 1.76 1.59 1.52 max 413 Number i 6.57e+2 Units nm eTextbook and Media
Please don't use the Chegg answer. We haven't discussed the phase difference equation 1. a. For the antireflective coating shown in the figure, how thick should the coating be to destructively interfere the incoming light and the reflected light (off the front of the glass) and why? Assume the light has a wavelength in air of 533 nm (green). b. What would the intensity be for 400 nm light and why? (Remember: intensity goes as the electric field squared!)
Reflection by thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1. and 3. (The rays are tilted only for clarity.) The waves of rays r1 and r2 interfere, and here we consider the type of interference to be either maximum (max) or hinimum (min). The table below provides the indexes of refraction n1, n2, and n3, the type of interference, and the thinlayer thickness Lin nanometers. Give the wavelength that is in the visible range. n1 n2 n3 Type L A 1.59 1.37 1.45 min 416 Number i 2.28e+3 Units nm
1.25) is located on smooth, 31. A thin film of oil (n w wet pavement. When viewed perpendicular to the pavement, the film reflects most strongly red light at 640 nm and reflects no green light at 512 nm. How thick is the oil film?