Q4. The probability density function of a signal x(t) is shown below: -2 1/2 fx(x) 2 X The signal's bandwidth is 5 kHz and is transmitted using a PCM system. (a) If sampling is done at the Nyquist rate and a uniform quantizer with 32 levels is employed, wh is the resulting signal to quantization noise? (b) If the available bandwidth of the channel is 40 kHz, what is the highest achievable signal-to- quantization ratio.

Q4. The probability density function of a signal x(t) is shown below: -2 1/2 fx(x) 2 X The signal's bandwidth is 5 kHz and is transmitted using a PCM system. (a) If sampling is done at the Nyquist rate and a uniform quantizer with 32 levels is employed, wh is the resulting signal to quantization noise? (b) If the available bandwidth of the channel is 40 kHz, what is the highest achievable signal-to- quantization ratio.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Frequency spectrum of a signal is given as the following: a) Write an equation for the signal x(t) defined by this frequency spectrum. b) What is the minimum sampling frequency to sample this signal? c) Write x[n] after the signal digitized by an ADC with a sampling frequency of 2 Hz.
please answer with solution. An analog signal with a bandwidth of 36MHz is sampled at a frequency (fs) of 72,000,000 samples per second during the ADC (analog-to-digital conversion) process. What is the outcome of the received signal after the DAC (digital-to-analog conversion) process? a. the signal will have experienced aliasing b. the signal will not experience aliasing c. the signal will not experience quantization errors d. none of the above describes the outcome
Consider an analog source emits a wave that is first sampled while ensuring the Nyquist criterion. Elaborate the further process step by step experienced by the analog signal in your own words with the help of proper labeled diagram
Problem 4: Two lowpass signals each band limited to 3 KHz are to be time multiplexed into a single channel using PAM. Each signal is impulse sampled at frequency of 50% above the Nyquist frequency. The time multiplexed signal wave form is filtered by an ideal LPF before transmission. f1(t) LPF PAM Signal Sampler f2(t) LPF Pulse Clock Gen. a. What is the minimum clock frequency of the system? b. What is the minimum cutoff frequency of the LPF? In the receiver, the signal is impulse sampled and demultiplexed using the system shown, determine the minimum and maximum acceptable BW of the LPF used in retrieving the analog signals.
A continuous time sanal aCt is shown below CG) Aind x[n] with a sampling interval T- O5 and sactch it. Cb) Calculate the energy Ex of the signl (C) Suetch xC3n] and x^) for the DT signal Ex[n) as gou derived in ca). 6o
A signal is bandlimited to 4 KHz and a PCM is used to transmit it. The signal to quantization noise is atleast 40 dB and is normalised. What is the number of levels where the signal is encoded and what is the transmission's bandwidth?
Signal and system problem.plz solve every step with formula
A baseband analogue signal varies between -8 and 4 V, and has a bandwidth of 5 kHz. A segment of duration 7 minutes of this signal is digitised by sampling at a rate of 28 kHz and quantising using a 19 bit uniform quantiser, and then encoded for digital transmission. How many quantisation levels does the quantiser have. Type your answer.
An analog electrocardiogram (ECG) signal contains useful frequencies up to 100 Hz. 1. What is the Nyquist rate for this signal? 2. Suppose that we sample this signal at a rate of 250 samples/s. What is the highest frequency that can be represented uniquely at this sampling rate?
Given the state space representation, draw the signal flow graph and find the transfer function.
(1-4) A sinusoid of the frequency 2100 Hz is sampled at the rate 8/7 samples per baseband cycle. (a) In time domain, draw one cycle of this sinusoid, the corresponding samples, and the reconstructed signal. What is the frequency of the reconstructed signal? (b) In frequency domain, draw this sinusoid, the corresponding samples, and the reconstructed signal. ?. (1-5) The signal r(t) = 100 sin(100)+75c(100m) in
Write mathematical equation an transfer function.