A link has a signal-to-noise ratio of 2000 a bandwidth of 12000 KHz. What is the
Q: When two stations are visible at once, or if one station is hidden from view, wireless networking…
A: Data is sent wirelessly through a wireless network. sent wirelessly. sent from one host to another…
Q: Give a quick explanation of what LTE calls for. In addition, explain the difficulties of OFDM-MIMO…
A: LTE, which stands for Long Term Evolution, is sometimes known as 4G LTE. You may download your…
Q: 85. We can divide today's networks into ____ broad categories based on switching. a. four b. three…
A: We have three types of switching Circuit Switching, Message Switching, and Packet Switching based on…
Q: course: Data communication and communication Networks Q: Compare the different TCP variants…
A: Given:- course: Data communication and communication Networks Q: Compare the different TCP variants…
Q: X.25 and Frame Relay are two protocols applied in packet switching data communication. Packet…
A:
Q: iplexing, delay, and loss with Internet tran
A: Step 1: Multiplexing is a technology that allows multiple communication signals to be combined in…
Q: Q3. A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum…
A: The answer is
Q: Ultra-reliable and low latency communication (URLLC) requirement in 5G (choose all that apply)…
A: URLLC is a feature that should be in 5g.
Q: The throughput loss that occurs in wireless networks is much higher when compared to that which…
A: The throughput loss that occurs in wireless networks is much higher when compared to that which…
Q: Two channels, one with a bit rate of 100 kbps and another with a bit rate of 200 kbps, are to be…
A: The minimum bandwidth rate is 100 kbps.The minimum bandwidth rate is 200 kbps.For the above channels…
Q: mpare the Go-back N protocol with the rest of the protocols for effective frame transmission in…
A: Lets see the solution.
Q: 1. How fast can a 46-byte block of data be transmitted on a 10 Mbps Ethernet packet and a 16Mbps…
A: Let see the solution.
Q: Q3. Make link state packets for all the nodes in the network given in figure 1. Make packet buffer…
A: Given question has asked to make liS. Also given question has asked to make packet buffer for…
Q: Abbreviation of SONET in networking is_____________.
A: This fill in the blank question requires sonet's abbreviation.
Q: Explain the 80/20 rule of networking?
A: INTRODUCTION: Networking is the informal social exchange of information and ideas among people who…
Q: Combine the words. One word in the left column corresponds to one description in the right column.…
A: MIME-------->Multipurpose Internet Mail Extensions CDMA------->Code Division Multiple Access…
Q: Suppose a 128-Kbps point-to-point link is set up between Earth and a rover on Mars. The distance…
A: HELLO STUDENT PLEASE DO LIKE IF THIS SOLUTION WILL HELP YOU
Q: The TCP/IP Networking Model is called a "de facto" standard, while the OSI Networking Model is…
A: TCP/IP networking model (De facto standard) The third type of the standard often seen in the…
Q: Mr. Hadi sent an email using 01 Gbps network bandwidth which contained a message size of 2.5-KB…
A: For any network, Propagation time is regarded as the total time required to transmit a data signal…
Q: Q2/Explain according your understanding the following by short answer: 1-priority in the token…
A: Priority in the token network and what prefer to avoid cut off in the cable. Stations on a Token…
Q: 2. In VoIP, the media transport path is the same as the signaling path. True False
A: Answer: True
Q: Do you agree with the following statements? Justify your answer. Compared to circuit switching,…
A: Given: Justify following: Packet switching is better for mobile networks than circuit switching.
Q: Q3/Explain according your understanding the following by short answer: 1-priority in the token…
A: The solution to the given question is: 1) Tokens are special frames that are passed from node to…
Q: SECTION I: FILL IN THE BLANKS: PICK EXACT TRUE ANSWER* *******Routers are used to connect networks…
A: Answer: Break up.
Q: Why CDMA can make users communicate at the same time using the same frequency band without…
A: In CDMA technique, users are distinguished from each other according to their CDMA codes. CDMA uses…
Q: Consider a 10 km long broadcast LAN has 10^10 bps bandwidth and uses CSMA/CD. The signal travels…
A: Below is the answer with calculation and explanation:
Q: 1. (True or False) The 5G air interface is based on the new waveform of F-OFDM, and uses a fixed…
A: As per Bartleby's answering guidelines I am supposed to answer only the first three questions. To…
Q: 5.a. A link with an optical budget of 8 dB has a remaining margin of 3 dB. What's the total loss in…
A: According to the information given:- We have to choose the correct option to satisfy the statement.
Q: 4. NSA networking defined by 3GPP R15 protocol, which of the following networking architectures can…
A: Answer is a) Option 3
Q: Question 2 In networking, guided media are the different types of wires that carry radio signals to…
A: What is guided media? In guided media, data is transmitted through cabling system that has a fixed…
Q: This question deals with computer networking: 2a) Discuss one advantage and a disadvantage between…
A: Wireless propagation can be done via three modes- ground wave , line of sight, sky wave. Contour of…
Q: a. Explain the controlled access protocol in detail. b. Describe in detail about channelization.…
A: Controlled Access Protocol:- In controlled access, both departments check each other's information…
Q: Discuss any two constraints of computer networks based on shared media with the aid of suitable…
A: Local area networks (LANs) and broad area networks are two fundamental network types (WANs). In a…
Q: Question 2: Wi-Fi connection Suppose that Alice and Bob are connected to the same WLAN via the same…
A: Throughput Throughput tells you how much data was transferred from a node at any given time and…
Q: Don't copy from google or other websites How is the wastage of bandwidth in Synchronous TDM…
A: In synchronous TDM, each gadget which is available in this has given similar time allotment to send…
Q: Q3. A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the naximum…
A: The answer is
Q: Do research on the following protocols: Can Bus protocol SPI I2C USB and draw the transmission…
A:
Q: Throughput loss in wireless networks is substantially higher than it is in traditional networks. I'm…
A: Introduction: Cabled network A network that uses physical wires and cables to link its computers is…
Q: Q3: A channel with bandwidth 10MHZ used to transmit 8-PSK data coming at rate of 8 Mbps. 1. What is…
A: Answer : I attached a image please have a look once .
Q: Question 1 Sam is looking at the services that are provided by the Link Layer. He wants to ensure…
A: To Choose which service is Sam describing about link layer.
Q: Mr. Hadi sent an email using 01 Gbps network bandwidth which contained a message size of 2.5-KB…
A: Given: Network bandwidth = 1Gbps Message size = 2.5kb Distance between sender and receiver i.e., d =…
Q: A ________ is a device in which the stations are completely unaware of its existence.
A: 98.A ________ is a device in which the stations are completely unaware of its existence. a.passive…
Q: Performance is inversely related to delay. When you use the Internet, which of the following…
A: Yes, performance is inversely proportional to delay as with an increase in delay due to latency the…
Q: Mr. Hadi sent an email using 01 Gbps network bandwidth which contained a message size of 2.5-KB…
A: Bandwidth= 1gbps message size= 2.5kb distance =X km from arid number X=701 email speed =2.4 x 108…
Q: B- Compare between circuit ching, message switching,data m packet switching and virtual circuit…
A: It is defined as the data transmits data across digital networks by breaking it down into blocks or…
Q: What is the mutual information I(X; Y)? What is the mutual information of this channel, I(X; Y)?
A: Mutual information is used in machine learning, to measure the amount of information obtained from…
Q: coaxial connectors like me and see and type F type T type and this quads of cable it was implemented…
A: Connection coaxial: Twisted pair is a special form of cable with a ceramic insulator and other…
Q: lleague about the ARP protocol. Mention the layer at which it operates as well as the kind of…
A: Given Inform a colleague about the ARP protocol. Mention the layer at which it operates as well…
Q: r. Hadi sent an email using 01 Gbps network bandwidth which contained a message size of 2.5-KB…
A: GIVEN: Mr. Hadi sent an email using 01 Gbps network bandwidth which contained a message size of…
dont dont answer if you are not 100% sure else strict action will be taken I will compliant for sure skip and dont answer if you dont know
Step by step
Solved in 2 steps
- A line has a signal-to-noise ratio of 1000 and a bandwidth of 4000 kHz. What is the maximum data rate supported by this line? If the bandwidth of the channel is 5 kbps, how long does it take to send a frame of 100,000 bits out of this device? What is the maximum data rate of a channel with a bandwidth of 200 kHz if we use four levels of digital signaling?Example: A telephone line has a bandwidth of 3000. The signal-to-noise ratio is usually 3162. For this channel the capacity is calculated asSuppose that we are sending a 30 Mb MP3 file from a source host to a destination host. All links in the path between source and destination have a transmission rate of 10 Mbps. Assume that the propagation speed is 2 × 108 meters/sec, and the distance between source and destination is 10,000 km. 1. Now suppose there is only one link between source and destination, and there are 10 FDM channels in the link. The MP3 file is sent over one of the channels. What is the end-to-end delay?
- Now suppose there is only one link between source and destination, and there are 10 FDM channels in the link. The MP3 file is sent over one of the channels. What is the end-to-end delay?What is the length of a bit in a channel with a propagation speed of 2 x 108 m/s if the channel bandwidth is 1 Mbps? 10 Mbps? 100 Mbps?Computer Science A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully efficient when there are no errors on the channel. Assume that frame size is 20000 bits and the overhead bits are negligible. What is the bit probability error (as seen at Layer 2) that makes the Go-Back-N ARQ 50% efficient?
- Suppose you are designing a sliding window protocol for a 2Mbps point to point link to the moon, which has a one way latency of 10 sec. Assume that, each frame carries 1KB of data, what is the minimum number of bits you need for the sequence number?A distant planet is about 9 x 1010 metres from the surface of the Earth. What is the channel utilisation of a point-to-point connection that operates at 64 megabits per second and uses a stop-and-wait protocol for frame transmission? Let's say that the speed of light is 3 108 metres per second, and that the frame size is 32 kilobytes.Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the shortest time possible (in seconds) to transmit a 1 Mbyte file over the given link?
- 40 devices share a clean ALOHA channel. The drawer is 2μs in size. Because they want the devices to carry as much as possiblenumber of frames per second, are satisfied with 65% of the maximum achievable channel efficiency.How many frames per second can each device emit to achieve 65% of the maximum achievable channel utilization?Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?Suppose there is a b+n (Sum of first and last digit of your Reg#) Mbps microwave link between a geostationary satellite and its base station on Earth. Every minute the satellite takes a digital photo and sends it to the base station. Assume a propagation speed of 2.4*108 meters/sec. 1. What is the propagation delay of the link? 2. What is the bandwidth-delay product?