Q3/ Air flows through the settling chamber with a particulate matter that must be removed. Find the Dimensions of settling chamber. Use the following data: Chamber dimensions Properties of gas P-2000 kg/m³ Hg-1.8*10$ kg/m-s Properties of particles u-2 m/sec Dp.min = 66 µm D-0.44 m Y-0.432 m AH-0.25 m 7-82.23% Q-8m/s

Q3/ Air flows through the settling chamber with a particulate matter that must be removed. Find the Dimensions of settling chamber. Use the following data: Chamber dimensions Properties of gas P-2000 kg/m³ Hg-1.8*10$ kg/m-s Properties of particles u-2 m/sec Dp.min = 66 µm D-0.44 m Y-0.432 m AH-0.25 m 7-82.23% Q-8m/s

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.35P

See similar textbooks

Similar questions

How to calculate permeability according to silica bead characxteristics without knowing pressure drop? silica diameter: 2.5mm Inlet mass flow rate: 0.3m^2/min Inlet Temperature: -10 degree C
As a process engineer, you are designing a new drinking water treatment plant using conventional treatment process including Two Rapid Mixers as follows: The design flow is 50 million gallons per day (MGD) (1 Gallon = 3.785 L, 1 m³ = 1000 L). The average temperature of water is 5°C with a dynamic viscosity, μ = 1.519 x 10-3 Pa.Sec In each rapid mixer with a square shape, detention time, e = 1 min, water depth H = 13 ft, and power input P = 1.5 kw (1 ft = 0.3048 m, 1 KW = 1,000 W) The equivalent diameter, TE for each rapid mixer is ________ m. TE || AIR 1) 4.1 2) 4.4 3) 4.6 4) 4.8 5) 0.4
Estimate the weight of a 25 km gas pipeline with a DN 600 mm, OD of 610 mm, and a wall thickness of 12.7 mm.
Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the wind tunnel spped is measured with Pitot tube probe. For a certain run, the stagantion pressure is measured to be 472.6 Pa gage and the statric pressure is 15.43 Pa gage. Calculate the wind tunnel speed. a. 18. 3 m/s b. 17. 3 m/s c. 19. 3 m/s d. 16.3 m/s With FBD
Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the wind tunnel spped is measured with Pitot tube probe. For a certain run, the stagantion pressure is measured to be 472.6 Pa gage and the statric pressure is 15.43 Pa gage. Calculate the wind tunnel speed. a.18. 3 m/s b.16.3 m/s c.17. 3 m/s d.19. 3 m/s
A pitotstatic tube to be used in 2n airplane for on-flight measurement was calibrated on ground by using air of density 1.20 kg/m? . A measurement taken at an altitude of 3000 m where the ambient pressure and density were 70 kPa (abs) and 0.91 ke/m? respectively, indicated a velocity of 200 m/s by using the above ground level calibration. Estimate the true speed of the airplane [Take k = 1.4 and R = 287 (kg K)l.
A steam generator generates flue gas at an average temperature of 260 C inside a Chimney. The theoretical draft is 0.5 kPa and the ambient condition of the air is 21 C and 100 kPa. Assume the coefficient velocity to be 0.30 and the molecular weight of the flue gas is 32. For air-fuel ratio requirements per second of 15, calculate: a. The diameter of the Chimney, meter b. The theoretical draft, cm H₂O
Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the wind tunnel spped is measured with Pitot tube probe. For a certain run, the stagantion pressure is measured to be 472.6 Pa gage and the statric pressure is 15.43 Pa gage. Calculate the wind tunnel speed. a.19. 3 m/s b.18. 3 m/s c.16.3 m/s d.17. 3 m/s PLEASE INCLUDE FIGURE OR FBD
Z\0 @ P 0:10 ZAIN IQ II. Quiz 2 Thermo.pdf Gas flowing through a diverging nozzle has at inlet section a temperature of 20 °C, pressure 120 kN/m² and velocity 300 m/s. At the outlet of the nozzle the velocity has fallen to 100 m/s. Assuming an adiabatic flow, what is the values of outlet pressure, temperature, internal energy and specific enthalpy at outlet section. Take y= 1.333 and Cv= 0.86 kJ/kg K.
Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the wind tunnel spped is measured with Pitot tube probe. For a certain run, the stagantion pressure is measured to be 472.6 Pa gage and the statric pressure is 15.43 Pa gage. Calculate the wind tunnel speed. (WITH FREE BODY DIAGRAM) CHOICES: a.17. 3 m/s b.18. 3 m/s c.19. 3 m/s d.16.3 m/s
Moving to another question will save this res Question 10 The static temperature of a moving fluid is greater than stagnation pressure equals to stagnation temperature greater than stagnation temperature smaller thag stagnation temperature AMoving to another question will save this respon
2. In an undistur bed airstream, where the pressure is 14.7 in' and the the velocity n G00 "/secwhat are the velocity, density 10/in? temperaturej 519 'R, and speed of sound where the pressure il 13.9 temperature