Q4. A horizont chlorine at 10t minimum wall and the heads.

Q: 1. Liquid water is vaporized at 100 C and 1.013 bar. The heat of vaporization is 40.69 kJ/mol. What…

A: 1 mol of liq water = 18 g of liq water = 0.018 kgwe can calculate Vliq = 0.018 kg /1000 kg m-3 =…

Q: A coal-burning electric generating plant emits 1.5 kg/min of SO2 from a stack with an effective…

A: Given wind speed is 5 m/s.From Atmospheric Stability under Various Conditions table (which is given…

Q: When a system is taken from state a to state b in the accompanying figure along path acb, 100 J of…

A:

Q: Hot nitrogen gas at 400°C and atmospheric pressure flows into a waste-heat boiler at the rate of 20…

A: Given data :

Q: A powder forms a bed in a small tube. The bed is 0.8 cm in diameter and 3 cm long. The density of…

A:

Q: The following figure shows the brine circulation in Multi-Stage Flash (MSF) desalination process.…

A: The Multi-Stage Flash (MSF) desalination process is a method used to produce freshwater from…

Q: What is the specific internal energy of water at 50 kPa and 220°C? Use data from the steam tables.…

A:

Q: Biological oxidation of phenylacetic acid is inhibited by propionic acid present in wastewater. The…

A: The data given for enzymatic oxidation of phenylacetic acid at different concentrations of propionic…

Q: A AIR B WATER h Hg

A: We know atmospheric pressure is 1.033 kgf/cm2.Pressure read by manometer AThus, absolute pressure…

Q: in determine the molar amounts atomic species balancer and • molecular specier balancen

A:

Q: H.W6: Three beds of equal cross section have permeabilities of 100, 200, and 300 mD and lengths of…

A: GivenPermeabilitiesand

Q: The reaction A -> 2B + C takes place in a catalytic reactor (diagram is given below). The reactor…

A: The catalytic reactor facilitates the conversion of reactant A into products B and C as per the…

Q: The temperature-dependent molar heat capacity of sulfur dioxide gas is given as: Cp,m = a +bT+ c/T²…

A:

Q: question 2.

A:

Q: A process flow diagram of an anode fuel cell.

A: Hydrogen gas is fed to the anode side of the fuel cell.The hydrogen gas is catalytically split into…

Q: Viscosity O IV and III IV Which of the above indicates psuedoplastic flow? O II only O IV only I…

A: A pseudoplastic is the Non-Newtonian fluid whose apparent viscosity decreases instantaneously with…

Q: What is the reading of the thermometer at t = 1 min? How long will it take for the thermometer to…

A:

Q: Acetylene is hyrodgenated to form ethane. The feed to the reactor contains 1.20 mol H₂/mol C₂H₂. The…

A:

Q: Now can you solve for the reactor volumes of CSTR w/ a conversion of X1=20% followed by PFR X2=65%…

A: Given, Molar feed rate of A       The volume of CSTR required to achieve 20 % conversion is equal to…

Q: 2) Find the heat of combustion for CxHy-air mixture at equivalence ratio 0.7 was burnet, when the…

A:

Q: A differential manometer is connected is containing water and the pipe B is c difference of mercury…

A:

Q: 5.9. A rigid vessel of 0.06 m³ volume contains an ideal gas, Cy=(5/2)R, at 500 K and 1 bar. (a) If…

A: Given,

Q: Discuss the irreversibility analysis of liquefaction process in detail.

A: Liquefaction refers to the process of transforming a gas into a liquid state.This physical change is…

Q: Air enters a compressor operating at steady state at 1.05 bar, 300 K, with a volumetric flow rate of…

A:

Q: The total carbonate concentration (CT) in a given water is 2 mM and the pH is 7.9. What is the total…

A: The capacity of water to neutralise acids is measured by its total alkalinity. Calcium carbonate  is…

Q: 1- Determine the pressure (In bar) and volume of rigid vessel if it contains 100 kg of water at 518…

A:

Q: Sketch very roughly the phase diagrams for water and carbon dioxide and use them  to answer this…

A: we have to plot a rough phase diagram of water and CO2 and then from the sketch have to find the…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: Feed at the bottom contains-Basis feed= 100 mol (supposed)Butane= 55% = 55 molButylene= 45% =45 mol

Q: 20.100 kg/s of vapor that was produced in the desalination vessel is condensed in a condenser to…

A: To determine the outlet temperature of the desalinated freshwater, we can use the principle of…

Q: This Levenspiel plot was constructed for a reaction that is to be performed in a PFR.

A:

Q: The equilibrium distribution of a solute A between air and water at low concentration at a…

A: Equilibrium relationship for mass transfer is y = 1.2x Where y and x are the mole fraction of solute…

Q: Pick out the wrong statement.   The annual depreciation rate for machinery and equipments in a…

A: Pick up the wrong statement among the following statements.

Q: total molar flux of methanol, NA, and the mass average velocity

A:

Q: (d) In a second unit, the gaseous hydrofluoric acid is bubbled through water to produce a 1.50 M…

A:

Q: A certain material 2.5 cm thick, with a cross-sectional area of 0.1 m², has one side maintained at…

A: Given,

Q: Mixtures of Non-Reacting Fluids From their extra 70 percent rubbing alcohol, Family Rubbing Alcohol…

A: To solve this problem, we can use the following equation:As given in question solution's starting…

Q: For a carburization process is carried out in gamma (ꝩ)-Fe at an unknown temperature. The diffusion…

A:

Q: Explain the concept of heat transfer and how it applies to chemical engineering processes.

A: The transport of thermal energy from one area to another is known as heat transfer. Since heat must…

Q: A water fountain is designed to cool water initially at 24.9°C to a cool 8.2° C at an average rate…

A:

Q: A combustible gas has an LOC of 9 vol% oxygen in a mixture of the gas with air. Stoichiometrically,…

A: The lowest concentration of a flammable gas in air, below which the combination is too "lean" to…

Q: Q2: Provide an expression for the isothermal compressibility with a gas follows the ollowing…

A: Isothermal process is condition at which temperature of system is kept constant.Compressibility…

Q: Liquid heptane is stored in a 100,000 -L storage vessel that is vented directly to air. The heptane…

A: Given Data:heptane (C7H16) :Molecular weight: 100.21Lower heat of combustion: -4464.9 kJ//molLFL:1.0…

Q: (a) Draw and label a process flow diagram for this process. Number each stream. Clearly label the…

A: Here two unit is used to dewater ethanol.Molar flow rate of feed, F = 110 mol/hr Mole fraction of…

Q: Composition Dry Baser on Wet and and Dy 1) Wet bans-dry bans A stach 15.0% (02, 10.0% 02, and the…

A:

Q: Acetone is used as a solvent for greases and other petroleum products. It is pumped to a machine for…

A: Suitable heat exchanger:This application is a good fit for a shell-and-tube heat exchanger because…

Q: Example: Find 1- Over shot G(s) = Y(s) X(s) 10 s²+1.65+4 2-Rise time 4- T (period of oscillation)…

A: Given,

Q: A 40 kg steel casting (Cp = 0.5 kJ.kg-¹·K-¹) at a temperature of 450°C is quenched in 150 kg of oil…

A: A 40 kg steel casting is quenched (rapidally cooled) in oil.Mass of steel casting, Temperature of…

Q: A soil evaluated for malathion sopriton has been found to follow the Langmuir isotherm with a=0.01…

A: Givena = 0.01, b = 4.5The mass of the soil (m) = 200 kg = 200,000 gLangmuir isotherm........(i)

Q: On a 14 day wilderness expedition you'll need to heat 4.0 kg of water to the boiling point each day.…

A: Given,

Q: You were contacted by a vendor that claims it has a PFR of 200 cubic feet that can achieve 80%…

A: The PFR is a steady state reactor. Since we have allowed fresh feed the initial conversion that is…