Q) For the lossless T.L shown below, the line is driven with a generator that has E-30 V, and Zg 2592, if the VSWR-3.7, find 2, Zr, Zs. Vs, Is and Ps. Using smith chart 1.5 m 0.474 m Zg Eg Z-50 Q (= 50m V min2 V min! Z

Q) For the lossless T.L shown below, the line is driven with a generator that has E-30 V, and Zg 2592, if the VSWR-3.7, find 2, Zr, Zs. Vs, Is and Ps. Using smith chart 1.5 m 0.474 m Zg Eg Z-50 Q (= 50m V min2 V min! Z

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Related questions

Q: 1. 2. 3. 4. What is Q-Point? What is stiff voltage divider? What are the emitter voltage, V₁, and…

A: Given:Wen are given four different questions.Required:We need to answer each question.

Q: The following figure represents an automated machining station controlled by a PLC. The operating…

A: According to the question, for the automated machining head as shown below,The following figure…

Q: Problem 06.046-DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Consider the given circuit under dc…

Q: Which one is the state space model of the following circuit? Input is the source voltage and output…

A: it is asked which one of the given options will match the state space model of given circuit

Q: The switch above the 12 V source in the circuit has been closed since just after the wheel was…

A: In the given questions we need to calculate the voltage v(t).

Q: c) Fig. B2c shows a IGBT with a freewheeling diode use to protect the transistor in a motor control.…

A: According to the question an IGBT with a freewheeling diode is used to protect the transistor in a…

Q: 30V 300 32 + Vc SAN =0.35F v 해 :51

Q: 8.92V (c) (R₁ 12 k Voc +lov Poc 100 R₂ 27 k w-li Re 680 (1 R₁ 15km 8.26 826v

A: c. Given Data:The BJT amplifier circuit with,Voltage across the common terminal Voltage across the…

Q: 2. Consider the following causal difference equation, which operates at a sample rate of 8 kHz: 5 3…

Q: Find 100 + 50, √, (+). + 5 √₂ (2) 1:1 lele rele 1062 V₁ (t) = 20 cosine 377 t √2 (t) = 15 cosine 400…

Q: For the circuit shown in Fig.4, calculate the values for: (a) the potential difference across 25N…

A: The circuit is given asHere we need to calculate voltage, current and power.

Q: b) Fig. Blb shows a DC to AC 3-phase motor control circuit. Explain how a PLC be used for fault…

A: A DC to AC 3-phase motor control circuit is given in the question. It is asked to explain how a PLC…

Q: The op amp in the circuit given below has Ri= 100 k, Ro= 100 , vs= 2 mV, and A = 100,000. Vs 100 Ω…

Q: 1. A Zone 2 fault is detected in 25 cycles of a 60 Hz power system and the circuit breaker clears in…

A: To calculate the fault clearing time (t_clearing)We need to convert the detection time and the…

Q: 3) + R Find u, and is using superposition c iz 1+, V₂ V₁ = 100 cos (306) V/₂= 60 cos (30€ + 60°)…

Q: 8.9 Determine (a) the average and (b) rms values of the periodic voltage waveform shown in Fig.…

A: In this question, we need to determine the average voltage and rms voltage. The time period is…

Q: Q1 (a) Determine i, (t) in the circuit of Figure Q1(a). 2 H

A: In the given questions we need to calculate the current io.

Q: UN Α 2 ΚΩ 4 ΚΩ m 115 V •-15 V b If v, -2 V, the output voltage vo is

A: For the given Op-amp circuit, the input voltage isvs=−2 Volt.To determine: output voltage v0.

Q: Consider a satellite communication system in which a satellite orbiting at 38,000 Km transmits a…

Q: 8.22 In the phasor-domain shown in Fig. P8.22, V = 120/0° V, I = 0.3/30° A, w = 1000 rad/s, R₁ = 200…

A: Given:Required: We need to determine the complex power of each passive element. Also, we need to…

Q: Q1. The voltage gain of an amplifier without feedback is 3000. Calculate the voltage gain of the…

A: Given:Voltage gain without feedback is AOL=3000.Negative feedback is employed in the amplifier.The…

Q: Q3. A three-stage amplifier has a first stage voltage gain of 100, second stage voltage gain of 200…

A: It is given that:

Q: BE(co) 2. For the ECL circuit shown, Vcc V, V. . EE 5.2V, V, VOL -1.65. If In 2.5mA when VA = VOH…

A: For the ECL circuit is shown in the given question.If when ,. To determine the average power…

Q: Determine the output waveform for the circuit of Figure below +10 V V. ἂν -10 V V +4V -4V w 1010 4 w…

Q: what is the voltage and power through each component

A: The circuit diagram,

Q: In the given circuit, v (t) i(t) = 5 e 220 R www = 57 e 220t V t V. t> 0 mA, t> 0 1 C

A: Given Data:An RC series circuit with,Capacitor voltage Circuit current To Find:A. The values of R…

Q: A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source.…

A: It is given that:

Q: Q2) Consider the system given above with G(s) = 0.6 e-Tas 0.3 s + 1 ,H(s) = 1 where the time-delay…

A: Consider the system given above with where the time delay is and the sampling period is .a) To…

Q: A channel has the following (sampled) impulse response: h = [−0.15, 0.70, 0.35, 0.20]. Calculate a…

A: According to the question, a channel has the following (sampled) impulse response: h = [−0.15, 0.70,…

Q: 8 -50 -100 G5 = to the corresponding Bode plots in Figure 0 -90 -180 10 Pair the transfer functions…

A: Given:Transfer functions, To do:We have to pair transfer functions to their corresponding Bode…

Q: When a mobile node moves farther away from a base station, a base station may take a number of…

A: Given:When a mobile node moves farther away from a base station, a base station may take a number of…

Q: he switch in the circuit below had been closed for a long time before it was opened at t = 0. Given…

A: The circuit diagram,

Q: B): For the circuit given below if, Sc(t) = [5 cos we t + 8 cos wet sin w, (t)] and fe= cos wet find…

A: The given circuit isWhere fc=cos(wct);

Q: 1. Construct the equivalent NAND-NAND circuit of the given Boolean function, F=B'(CD'+A) + C'D(A'+B)

A: According to the question, we need to construct the equivalent NAND-NAND circuit of the given…

Q: A thermocouple ammeter gives full scale deflection for a current of 10 amp. When it reads one fourth…

A: In a thermocouple ammeter deflection is directly proportional to the square of current flowing…

Q: 2. Compute the values of battery current I for the following circuit when a. Switch S1 is open 2A b.…

Q: Draw what makes this a direct coupled 2 stage amplifier on the diagram?

A: According to the question, for the given circuitWe need to draw what makes this a direct coupled 2…

Q: 3. Write the nodal voltage equations using Inspection method and solve the equations. 20 ΚΩ Μ 10 ΚΩ…

A: Givan an electrical circuit Task1: Form nodal voltage equations by inspection Task2: Solve the nodal…

Q: 30. The speed regulation of a synchronous motor is always (a) 1% (b) 0.5% (c) positive (d) zero

A: It is given that:synchronous motorsynchronous motor

Q: The current I in the circuit shown is

A: It is given that:

Q: Assuming the passive sign convention and an operating frequency of 5 rad/s, calculate the phasor…

A: For the given circuit specifications the value of phasor voltage needs to be calculated. The…

Q: 17.00 cos(100t-90°) Report your answer so that all angles are in the range of 0 degrees to negative…

A: In the given questions we need to change the continuous time signal into the phasor form.

Q: Need truth table, Verilog code, testbench,circuitry design for 4-bit Fibonacci series generator

A: According to the question, we need to design truth table, Verilog code, testbench, circuitry design…

Q: 1. Explain how the initial voltage of the capacitor can be calculated. 2. Indicate which switches…

A: The given circuit is1. We need to find the initial voltage across the capacitor i.e to fully…

Q: Solve for the phasor voltage V1 shown in Figure 12, using node voltage. 10/0° 50 www C 2/0° +j5 Ω 3…

A: Calculation of phasor voltage V1 of the given circuit using nodal analysis:

Q: Name the circuit diagram shown below. If, m(t) = 2 sin w, (t) find Sc(t) DSB signal m (1) -90% -90⁰…

Q: Derive the transfer function for the non-inverting op-amp shown below. Use Step-by-Step in depth…

A: The given circuit is shown below.We need to derive the transfer function.

Q: Explain the diagram

A: According to the question, we need to explain the given circuit diagram as shown below

Q: Calculate the total current when three 1002 torch bulbs are connected in parallel across a 12V…

A: In this question, we need to determine the total current in the circuit. here three loads are…

Q: Problem 8 Determine Z, and I for the given circuit below.

A: It is given that:

Question

mms
Q) For the lossless T.L shown below, the line is driven with a generator that has E-30 V,
and Zg 2592, if the VSWR-3.7, find 2, Zr, Zs, [Vs], Is and Ps. Using smith chart
1.5 m 0.474 m
Z₂
Eg
Z-50 Q
( = 50m
V min2
Vminl
Zt

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Required

Step 2: Analysis

Step 3: Continue

Step 4: Smith chart

Solution

Step by step

Solved in 5 steps with 11 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A loss less TiL with characteristic impedance of to is terminated in Zr=3Z0. use crank diagram to sketch the voltage versus distance from the load, (Assume vst = 1 volt). @ Repeat the above How for Zv=Zo/3-
A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
19- Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
What is load curve
a shunt generator supplies a load of 5,500w at 110v through a pair of feeder conductors having a resistance of 0.02 ohm each. the armature, shunt field resistances are 0.15 ohm and 50 ohms respectively, find the emf generated.
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
Q4// for the power system as shown in the figure below, using Gauss-Seidel, determine the voltages at bus-2 and bus-3 after first iteration. V₁ = 120° P.U Slack bus 0.4+ j0.3 P.U (3) (1). jo.025 P.U jo.05 P.U j0.2 P.U -(2) 0.8+ j0.6 P.U
6-A lossless T.L. has Zo = 100 N and is loaded by an unknown impedance Its VSWR is 4 and the first voltage maximum is A/8 from the load . Find the load impedance .
A synchronous generator supplies rated power at 0.8 pf lagging.ra = 0.015p. u., andxl 1p.u. . Find out the possible terminal voltage. In case of the practical operation, which terminal voltage is more feasible? =
Find the inductive reactance per mile of a single-phase line operating at 50 Hz. The conductor has a GMR of D, 0.0217 ft, and spacing GMD is 15 ft between centers. O 0.41 O 0.66 O 0.79 O 0.49