Provide a complete and logical solution for the problem. If linear interpolation is required in the problem, tabulated values is considered as a solution. Also, provide T-S or P-V diagrams for each problem. For a Rankine Cycle, steam at 5.25 MPa, 435°C expands to 0.036 MPa. For 10 kg/s of steam, determine: a. Heat added b. Heat rejected c. Work of turbine

Provide a complete and logical solution for the problem. If linear interpolation is required in the problem, tabulated values is considered as a solution. Also, provide T-S or P-V diagrams for each problem. For a Rankine Cycle, steam at 5.25 MPa, 435°C expands to 0.036 MPa. For 10 kg/s of steam, determine: a. Heat added b. Heat rejected c. Work of turbine

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

JO 100 4ll a 0 77) 3:01 X A make up : Qz1, .. mlms.hu.edu.jo Consider a turbine that operates between two states (1, 2) and a compressor that operate between two states (3,4) if they are subjected to some heat loss with affecting the initial and final states then : Select one: A. Other parameters need to be known to determine the heat loss effects on W, t,out and W. c,in increases and B. W. t,out decreases due to W c,in heat loss. c. W. t,out decreases and W increases due to с,in heat loss. D. Both W, and W t,out c,in decrease due to heat loss. E. Both W, t,out and W, Cos. increase due to heat •..
Q1 Explain the following sub steps breifly. (a) Explain The Following Terms: Isolated System, Open System And Closed System And Give Example Where Ever Possible (b)Explain the following with the help of diagram: Extensive properties, Intensive properties and specific properties. Enthalpy, Entropy and Internal energy. (c) What Happens If Petrol (Gasoline) Is Used In A Diesel Engine, Siesel Engine Will Work?
1.5 Develop an expression for the thermal efficiency of the air-standard diesel cycle as a function of the compression ratio r. = V1N2 and the expansion ratio re = V4 / V3. Assume the working fluid is an ideal gas, and the volume effect of moles of gas %3D generated is small relative to the effect of heating from combustion.
HANDWRITTEN AND FINAL ANSWER MUST BE IN ENGLISH UNITS. Show solution.ANSWER iii. Consider an ideal gas with the following characteristics: R = 115 ft-lbf/lbm-R Cp = 0.25 + 0.00035T (BTU/lbm-R) i. Solve for the value of k at 1250 R. ii. Refer to the table shown below: SEE IMAGE iii. Solve the following unknown parameters for Carnot cycle: Volume at end of isothermal compression Heat added and Heat rejected Wnet Efficiency Mean effective pressure iv. Solve the following unknown parameters for Otto Cycle Mass Pressure and Temperature ateach corner Heat added and Heat rejected Wnet Efficiency Mean effective pressure Percentage clearance v. Solve the following unknown parameters for Diesel Cycle with 6% cut-off. Compression ratio Percentage clearance Heat added and Heat rejected Wnet Efficiency Mean effective pressure
Open with Google Docs 4-43 Air expands through a turbine from 10 bar, 900 K to 1 bar 500 K. The inlet velocity is small compared to the exit veloc- ity of 100 m/s The turbine operates at steady state and devel- ops a power output of 3200EW Heat transfer between the tur- bine and its surroundings and potential energy effects are negligible. Calculate the mass tlow rate of air, in kg/s, and the exit area, in m. 499 Relr
Rankine cycle/ engine (Thermodynamics) Show complete and step by step solution and the diagram. Answer as soon as possible. Note it is 750°K
2. Use only the MD below to solve this Item; use it by plotting data and process to determine items being asked. Steam enters a turbine at 117.4308 atmgage, and 932 deg. F, and expands isentropicaly to 177.17 inches of Hg. For 2 + (SN/X) kg/sec of steam, what is (a) the ideal work done (KJ) if AKE = 0 and actual exhaust enthalpy is 2700 KI/kg. a)Ans: (b)ne = (c)Determine: ideal steam moisture at exhaust. Ans: (d) Actual steam quality at exhaust Ans: (e) Actual steam temp at the exhaust. Ans. _f) Degree SH of the steam at turbine inlet. Ans g) change in entropy during the actual process. www Ans
3. The working substance for a Carnot cycle is 8 Ib, of air. The volume at the beginning of isothermal expansion is 9 ftand the pressure is 300 psia. The ratio of expansion during the addition of heat is 2 and the temperature of the cold body is 90 °F. Find: a) Q, and Qr (BTU), b) V, and Ps, c) V, and P4, d) mean effective pressure (psia).
1:09 PM O FINAL EXAMINATION IN ME 324 6 of 10 47:48 / 03:00:00 A test on a single-cylinder, four-stroke cycle gasoline engine yielded the following data: Torque = 950 N m Indicated mean effective pressure = 759 kPa, Bore = 28 cm, Stroke = 30.5 cm, Speed = 300 rpm, Fuel consumption = 10.9 .and hr Heating value of the fuel = 41,900 Determine the kg Mechanical efficiency 83.73 % 81.49 % = 79.52 % 77.79 % Next » II
Rankin cycle (Thermodynamics) Show complete and step by step solution. And show the diagram.
1. Two kilograms of air at a pressure of 2.25 MPa and temperature of 27C is heated atconstant volume to a final pressure of 2.5 MPa. Compute for the:a. Change in internal energyb. Change in enthalpyc. Change in entropyd. Heat transferrede. Non-flow work 2. In a constant pressure process, 325 KJ of heat are added to 6.55 kg of ideal gas(R=208 J/kg-K and k = 1.65) initially at 290 K. Calculate:a. Final Temperatureb. Change in enthalpyc. Change in internal energyd. Change in entropye. Non-flow work
1. An engine operating on the air standard heat engine has 13 KJ heat added at isochoric process, heat ratio of air = 1.35. If the minimum pressure and temperature are 101 KPa and 305 K, respectively. The maximum volume of 3.8 x 10 2 m³ with clearance of 10%. Determine • The work of cycle in KJ • The mep in MPa