Pick the right combination of True Statements. 1. As the by-pass factor (BPF) of the cooling coil increases, temperature difference between air at the outlet of the coil and coil ADP decreases. 2. As the by-pass factor (BPF) of the cooling coil increases, temperature difference between air at the outlet of the coil and coil ADP increases. 3. During cooling and humidification process, the enthalpy of air may increase, decrease or remain constant depending upon the temperature of the wet surface. 4. During sensible cooling of air, dry bulb temperature decreases but wet bulb temperature remains constant 5. The sensible heat factor for a sensible heating process is 1.0

Pick the right combination of True Statements. 1. As the by-pass factor (BPF) of the cooling coil increases, temperature difference between air at the outlet of the coil and coil ADP decreases. 2. As the by-pass factor (BPF) of the cooling coil increases, temperature difference between air at the outlet of the coil and coil ADP increases. 3. During cooling and humidification process, the enthalpy of air may increase, decrease or remain constant depending upon the temperature of the wet surface. 4. During sensible cooling of air, dry bulb temperature decreases but wet bulb temperature remains constant 5. The sensible heat factor for a sensible heating process is 1.0

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter3: Refrigeration And Refrigerants

Section: Chapter Questions

Problem 31RQ: Define a near-azeotropic refrigerant blend, and give twoexamples.

See similar textbooks

Similar questions

For Questions 7 and 8 Air enters a humidifier at 34.25°C and 30% RH. If the air leaves the humidifier at 70% RH. Determine: Question 7 The exit dry-bulb temperature of the air in °C. Add your answer Question 8 The saturation effectiveness in %. Round your answer to 2 decimal places. Add your answer Polves POD ON
Evaporation cooling in cooling towers heat transfer analysis.
In air-conditioning, how are two or more streams of air mixed? typwritten
Pls. Answer thank you!Atmospheric air from the inside of an automobile enters the evaporator section of the air conditioner at 1 atm, 27 C and 50 percent relative humidity. The air returns to the automobile at 10 C and 90 percent relative humidity. The passenger compartment has a volume of 2 m3 and 5 air changes per minute are required to maintain the inside of the automobile at the desired comfort level. Sketch the psychrometric diagram for the atmospheric air flowing through the air conditioning process. Determine the dew point and wet bulb temperatures at the inlet to the evaporator section, in 8 C. the required heat transfer rate from the atmospheric air to the evaporator fluid, in kW. the rate of condensation of water vapor in the evaporator section, in kg/min.
Using a psychometric diagram, describe the heating and humidification process from the following data. Initially the air was at dry bulb temperature (DBT) 35 ° C and RH 35%. air preheated to DBT 85 ° C. The heated air is then flowed through a humidifier to increase the RH to 25%. for this process, count, a. change in absolute humidity of air from initial to final conditions = ..... (kg water / kg air) b. change in air enthalpy from initial to final conditions = ..... (kj / kg air)
If the dry-bulb temperature of the air surrounding a typical cooling is 90 degrees Fahrenheit and the relative humidity of the air is 50%, the cooling tower should be able to cool the water in the tower to a temperature of: A. 82 degree Fahrenheit B. 75 degree Fahrenheit C. 89 degree Fahrenheit D. 95 degree Fahrenheit
Recirculated air from the indoor space is 7,500 cfm (75 degrees F dry bulb, 50% RH). Ventilation air from outdoors is 2,500 cfm (95 degrees F dry bulb, 76 degrees F wet bulb). Leaving air off the cooling coil is 10,000 cfm (55 degrees F dry bulb, 90% RH). What is the wet bulb temperature of the indoor air that is being recirculated? Group of answer choices 61.5 degrees 63.5 degrees 62.5 degrees 61 degrees
11 of 13 The temp. of the air in a dryer is maintained constant by the use of steam coils w/in the dryer. the product enters the dryer at the rate of one metric ton per hour. The initial moisture content is 3 kg moisture per kg of dry solid. Air entors the dryer w/ humidity ratio of 0.016 kg moisture per kg. of dry air & leaves w/ a relative humidity of 100 % while the temp. remains constant at 600C. If the total pressure of air is 101.3 kPa. dotermine: a. Total required amount of air in kg / hr. under entrance condition b. Capacity of forced draft fan to handle this air in m3 / min. NOTE: at pt.3: @600C. Psat 19.94 KPa & Pv = Psat. HR2 = 0.016 kg w.v. / kg d.a. V2 = 0.9675 m3 /kg HR3 = 0.1524 kg w.v. / kg d.a. O a. 5,200 kg/ hr b. 87.50 m3 / min O a. 4.315.25 kg / hr b. 95 m3 / min O a. 5,315.25 kg/ hr b. 88.70 m3 / min a. 5,315. 25 kg /hr b. 85.708 m3 / min.
The use of a stream of 30 m3/h (total) of exhaust air at 5% (percentage) of humidity and 80ºC will be carried out by mixing it with another air stream with 100 m3/h, 20% of percentage humidity and 20ºC. Ask if: -The percentage humidity of the outlet air: _______ % [round off to one decimal place] ; -Outlet air temperature:______ ºC [round off to one decimal place].
Q# 2: Chapter 14: Gas vapor mixtures and air-Conditioning (Psychrometric chart) doly to design air conditioning systems using the psychrometric chart, and mass and energy balance relations CLO 4 Air enters an air-conditioning system at 20C and 70 percent relative humidity at a rate of 2 m' /min It is cooled to 15 °C and saturated when the liquid water leaves the system at 32°C. Calculate the amount of water removed from the air and the rate of heat removal from the air.
JUST NEED QUESTION 2 NOT 1 1. Air at a dry bulb temperature (dbt) of 40 oC and a relative humidity of 30% is heated to a dbt of 80 oC. Using psychrometric chart to determine: a. The change in moisture content per kg of dry air. b. The change in enthalpy from the initial unheated air to heated air. 2. The previous heated air is then conveyed through a humidifier to raise its relative humidity to 25%. Using psychrometric chart to determine: a. The change in moisture content per kg of dry air. b. The change in enthalpy from the heated air to final humidified air. Hint: the humidifier changes the humidity ratio without changing dry bulb temperature.
f. A single-family detached residence of moderate construction has a total sensible load of 53,300 Btu/hr. The design humidity ratio is 0.021 lb of vapor/lb of dry air. Determine the total cooling load.