One input to a conventional AM modulator is a 600 kHz carrier with amplitude of 22 V. The second input is a 20 kHz modulating signal that is of sufficient amplitude to cause a change in the output wave of ±9 V. Determine: a. Upper and lower side frequencies. b. Percent modulation. c. Peak amplitude of the modulated carrier and the upper and lower side frequency voltages.

One input to a conventional AM modulator is a 600 kHz carrier with amplitude of 22 V. The second input is a 20 kHz modulating signal that is of sufficient amplitude to cause a change in the output wave of ±9 V. Determine: a. Upper and lower side frequencies. b. Percent modulation. c. Peak amplitude of the modulated carrier and the upper and lower side frequency voltages.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

12- A DVM measure... a- peak value. b- RMS value. Average value. d- peak to peak value. 13 The study of energy distribution across the frequency spectrum of a given electrical signal is done by a Distortion meter b-wave analyzer.
1)to VRMs value to generate a signal with a peak voltage of 10 V with a signal generator in a multisim program..................... must be entered. 2)) the frequency of the signal generator to produce a signal with a period of 10ms...................... must be entered as. What should come to the dotted line?
Facts A clipper is an electronic circuit that produces an output by removing a part of the input above or below a reference value. That means the output of a clipper will be the same as that of the input other than the clipped part. Due to this, the peak to peak amplitude of the output of a clipper will be always less than that of the input. The main advantage of clippers is that they eliminate the unwanted noise present in the amplitude of an ac signal. Question: What do you think is the main disadvantage of a Clipper circuit over a Clamper Circuit?
Find the resonance point and the half-width of the speed versus frequency curve for the damped harmonic oscillator, under the action of a sinusoidal driving force. *It is all the data
a carrier frequency 10⁶ and amplitude 3V frequency modulated by a sinusoidal wave of frequency is 500 HZ and the peak amplitude 1 Volt as a consequence , the frequency deviation is 1 KHz. The level of the modulating waveform is changed to 5 Volt peak and the modulating frequency is changed to 2KHz. Write an expression for the new modulated waveform.
What is the problem with AM signal when overmodulation occurs?
drive a formula for (SNR) of sinusoidal signal has been sampled and quantized.
How to calculate the efficiency in frequency modulation and what is the highest value for efficiency in frequency modulation
a. What is the condition for over modulation and what are its effects? b. Name the frequencies generated in the output of an Amplitude Modulator.
Q2/ One input to an AM DSBFC modulator is an 800 kHz carrier with an amplitude of 40 vp. The second input is a 25 kHz modulating signal whose amplitude is 1O vp. Determine a. Upper and lower side frequencies b. Modulation coefficient and percent modulation c. Maximum and minimum positive peak amplitude of the envelope d. Draw the output frequency spectrum e. Draw the envelope
Determine the power saving in percent when the carrier is suppressed in an AM signal modulated to 80%
a.Derive the excitation equations b. Determine transition and output equations c. Derive the transition/output table and Draw the state diagram.