Need full case study with results discussion Introduction etc. Dont use guideline answer ok need full accurate case study. Case History A 32 year old male was found unconscious in his flat following a night out with friends. Attempts to resuscitate the male were unsuccessful. The postmortem indicated sudden cardiac death through cardiac dysrhythmia (arrythmia). There was no medical history of previous heart disease. Two opened packets of Jumping Beans were found on a table close to the body. A specimen of cardiac blood was taken and submitted to the toxicology laboratory for analysis along with the two Jumping Beans packets. . Guidance for Preparing the Case Report The coursework assessment for the module is to prepare a case report in the form of a case report scientific paper published in the Journal of Analytical Toxicology. This guidance information has been taken from the Instructions for Authors for the Journal of Analytical Toxicology however please use the information below as there are a number of differences. This information should be read alongside the marking criteria grid that is at the end of this document. A Case Report presents the details of real cases from practice within the scope of the Journal. If results are presented, the report should provide sufficient validation details such that the results presented can be evaluated for quality. Structure of the report The report should be structured and contain the following sections with clear sub- headings correctly indicating the content of the section. Each section should contain appropriate content and marks will be awarded for each section according to the criteria and mark scheme given at the end of this document. Title; Abstract; Introduction including Case History; Methods; Results; Discussion; Conclusion; References The report word count should not exceed 2000 (+10%) words of text excluding references, tables and figure/table captions. No more than 2 figures in the results section. The quality of the presentation should be equivalent to that of case report papers published in the Journal and so please refer to examples of these papers as additional guidance to this document. An example is: Hobbs J.M., DeReinz R.T., Baker D.D., Shuttleworth M.R., Pandey M. (2022) Fatal Intoxication by the Novel Cathinone 4-Fluoro-3-methyl-α-PVP. Journal of Analytical Toxicology, 46, e101-e104. Analytical Method Validation All described analytical methods must be validated. The extent of validation experiments depends on the purpose and use of the methods. The Journal of Analytical Toxicology recommends the ANSI/ASB Standard 036 for Method Validation in Forensic Toxicology as a guide for method validation in forensic practice. This provides specific validation requirements for qualitative and quantitative methods, and generally include calibration model (linearity), limit of detection (LOD), limit of quantitation (LOQ), bias (accuracy) and precision, carryover potential, interference, ionization suppression/enhancement (for LC–MS and other applicable techniques), dilution integrity, selection of an internal standard, and processed sample stability. Please note: for our case report only a partial re-validation is required and the necessary data is provided for you to be able to demonstrate successful re- validation. References References should be numbered consecutively in order of citation in the text, (within parentheses, not superscripted) and listed in numerical order at the end of the text.