List two types of friction force. For each type, draw free body diagrams of a book on a board that is tilted up at an angle alpha, labeling all forces acting on the book with up as + and to the right as +. For each drawing, explain the velocity and acceleration of the book.

List two types of friction force. For each type, draw free body diagrams of a book on a board that is tilted up at an angle alpha, labeling all forces acting on the book with up as + and to the right as +. For each drawing, explain the velocity and acceleration of the book.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 31PQ: A hockey stick pushes a 0.160-kg puck with constant force across the frictionless surface of an ice...

See similar textbooks

Similar questions

The pulley system shown in the figure is used to lift a m= 67-kg crate. Note that one chain connects the upper pulley to the ceiling and a second chain connects the lower pulley to the crate. Assume the masses of the chains, pulleys, and ropes are negligible. Determine the force F required to lift the crate with constant speed. Determine the tension in the upper chain. Determine the tension in the lower chain.
The diagram below shows an object of mass m= 20kg being acted upon by a force F=50N at an angle of θ=30o. The coefficient of kinetic friction between the object and the surface is 0.100. a.Draw a Free Body diagram for the object. Be sure to show all forces as well as the reference x,y axis. and Using Newton’s 2nd law, write the force equations for both the x and the y directions. Write these equations in terms of the letters m, F, θ, FN, g, f (little f stands for the friction force). X-direction: _______________________________________________________________ Y-direction:________________________________________________________________ b.Solve for the Normal Force c .Use your answer from part b to find the frictional force. d .Solve for the acceleration of the object. e.If this object was originally moving at 4 m/s, how fast would it be moving after 8 seconds? f .How far will…
A В
Draw a diagram of the situation and label the givens in the problem: The cart's mass and the hanger's mass. Also label the direction of the cart and hanger's acceleration. Draw two force diagrams. One for the cart and one for the hanger. You can treat the track as frictionless. Remember that the force in the string will be the same throughout the entire string. Then define an x-y coordinate system and find the x and y components of the forces in your diagrams.
A crate at rest having a weight of 1.60KN was dragged with a constant force of 0.75KN at an angle of 3V:4H only on the first 6m of its motion. If the coefficient of kinetic friction between the crate and the horizontal surface is 0.20; a. Compute the velocity of the crate if the distance it traveled was 9m.b. What is the total distance that the crate traveled until it stops?
Some sliding rocks approach the base of a hill with a speed of 11.0 m/s . The hill rises at 42.0 ° above the horizontal and has Part A coefficients of kinetic and static friction of 0.350 and 0.580, respectively, with these rocks. Start each part of your solution to this problem with a free-body diagram. Find the acceleration of the rocks as they slide up the hill. Express your answer in meters per second squared. ? a = m/s? Submit Request Answer Part B Once a rock reaches its highest point, will it stay there or slide down the hill? stay there slide down the hill Submit Request Answer Part C If it slides down, find its acceleration on the way down, else enter 0. Express your answer in meters per second squared. ? m/s?
Two blocks are connected by a string. The inclination of the ramp is θ, while the masses of the blocks are m1 and m2. Friction is negligible. 1. Write an equation for the magnitude of the acceleration the two blocks experience. Give your equation in terms of m1, m2, θ, and the acceleration due to gravity g. 2. Write an equation for the tension in the string in terms of m1, the acceleration due to gravity g, and the acceleration of the two blocks a.
MI M2 In the system shown above, the block of mass M1 is on a rough horizontal table. The string that attaches it to the block of mass M2 passes over a frictionless pulley of negligible mass. The coefficient of kinetic friction ug between M1 and the table is less than the coefficient of static friction µ, a. Draw an FBD of M1 and M2. b. In terms of M1 and M2 determine the minimum value of µ, that will prevent the blocks from moving. The blocks are set in motion. In terms of M1, M2 µlk, and g, determine each of the following: c. The magnitude of the acceleration of M1 d. The tension in the string.
Between two ski hills, there is a valley. Hill 1 is 735m and the second hill is 625m. From point A to point B, a skier skis. The skier starts at rest at point A and finishes at rest at point B. Between the two points, the total length of the path is 4.11m with an average slope of 40 degrees from the horizontal. a) Sketch the free body diagram and show all the forces on the skier. Indicate the location where the gravitational potential energy is equal to zero on the diagram. b) assuming the system is skier and the earth, and there is friction involved between the ski and the snowy ground ( coefficient of kinetic friction), determine the thermal energy that is lost to the surrounding when the skier is skiing from point A to point B in terms of variables, m, L and theta c) Calculate the value of coefficient of kinetic friction between snow and ski which would make the skier stop at the top of the lower point B
A 25 kg box is given an initial velocity of 65 m/s up a plane from the bottom of the plane. The plane is inclined 35° to the horizontal. The coefficient of kinetic friction between the box and the plane is 1. 0.45. Sketch a free body diagram of the box, labelling all the forces acting on the box. a. b. Resolve the weight of the box into: i. a horizontal component parallel to the inclined plane, and ii. a vertical component perpendicular to the inclined plane. By applying Newton's second law of motion perpendicular to the plane, determine the normal reaction force of the box. d. By applying Newton's second law of motion parallel to the plane, determine the acceleration of the box as it travels up the plane. Calculate the distance the box travels up the plane before coming to a stop.
Consider the figure shown in the following figure. You are lowering two boxes, one on top of the other, down a ramp by pulling on a rope parallel to the surface of the ramp. Both blocks move with constant velocity of 10.0 [m/s]. The coefficient of kinetic friction between the ramp and the lower box is 0.555 and the coefficient of static friction between the two boxes is 0.750. A. Draw the Free-Body diagram of both blocks. Set the ?-axis parallel to the ramp. B. Write Newton’s 2nd law along the ? and ? directions for both blocks considering their state of motion (accelerations).
A 25 kg box is given an initial velocity of 65 m/s up a plane from the bottom of the plane. The plane is inclined 35° to the horizontal. The coefficient of kinetic friction between the box and the plane is 1. 0.45. Sketch a free body diagram of the box, labelling all the forces acting on the box. a. b. Resolve the weight of the box into: i. a horizontal component parallel to the inclined plane, and ii. a vertical component perpendicular to the inclined plane. By applying Newton's second law of motion perpendicular to the plane, determine the normal reaction force of the box. с. d. By applying Newton's second law of motion parallel to the plane, determine the acceleration of the box as it travels up the plane. Calculate the distance the box travels up the plane before coming to a stop.