Answered: In the figure, fluid fills the…

In the figure, fluid fills the container shown here. At which of the indicated points is the pressure the least? -A -B -C -D -The pressure is the same at each of the labeled points.

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Solids And Fluids

Section: Chapter Questions

Problem 50P: An airplane has a mass M, and the two wings have a total area A. During level flight, the pressure...

See similar textbooks

Related questions

Q: A swimming pool with a width of 15.0 m and a length of 20.0 m is filled with water. the total force,…

A: Given Data: Width of the pool is, w = 15 m. Length of the pool is, l = 20 m. Total force exerted on…

Q: An incompressible and frictionless fluid flows left to right at a constant volumetric flow rate…

A: Equation of continuity

Q: A manometer is connected to a gas tank shown below. Atmosphere Gas tank What is the pressure inside…

Q: A ball of volume 11.1 m³ is placed in a container of fluid of density 947 kg/m³. Calculate the…

A: Given: Volume of ball Vball=11.1 m3 Density of fluid ρl=947 kg/m3 Volume submerged Vsub= 8.4 m3 Let…

Q: d. The force of the liquid acting on the interface between the two middle liquids. Your answer e.…

Q: Pressure Pump P Po h Water

Q: From the diagram which shows pressure / time dependence find the beat frequency. Time is in seconds…

A: we know that the beat frequency is the difference between two frequencies beats = f2 - f1 or beats…

Q: 1.6 A manometer connects an oil pipeline and a water pipeline, as shown. Determine the difference in…

A: Pressure due a column of fluid is given by P = ρgh, where ρ = the density of the fluid, g =…

Q: luid fills the container shown in the figure. At which of the indicated points is the pressure…

A: Write the given parameter of the problem- Four points is given A,B,C,D Depth(h)

Q: Consider the U-tube manometer shown in the figure. Both ends of the Utube manometer is open to…

Q: ermine the pressure at the base of an open tank, if it contains a layer of 7 cm of Hg, 20 cm of…

A: Given:- it contains a layer of 7 cm of Hg 20 cm of water 30 cm of oil and specific density areas…

Q: Fluid fills the container (of different shapes) as shown in the figure. Which of the indicated…

A: Given data: At depth h four different points are A, B, C and D Required: Compression between the…

Q: A viscous fluid flows through the pipe shown. The three marked segments are of equal length. Across…

A: According to the continuity equation, the product of the area of cross-section of pipe and velocity…

Q: Does a floating object sink more in a liquid with low density than in a liquid with high density?…

A: Density of the liquid determines whether the object will sink or float in another liquid. If an…

Q: 1) In the figure, the radius of the submerged cylinder is 10 cm. The height is 25 cm. The cylinder…

A: r = 10 cm h = 25 cm d = 2.7 g/cm3 (density of aluminium)water density = 1 g/cm3

Q: In liquid A, a body floats with 9/10th of its volume immersed, while in liquid B it floats with…

Q: . The velocity of a falling ball in a viscous fluid is explained by the following relationship a. F=…

A: According to Newton's, the frictional (or viscous force ) between two layer depends upon the…

Q: Three drinking vessels are filled up with identical liquids to levels shown in the diagram. In which…

A: The pressure at the bottom of the liquid level can be described as, P=ρgh Here, ρ and h represents…

Q: Three containers are filled with water to the same height (see the figure below). For which…

Q: Which of the following statements about pressure is correct? Select one: O Pressure is directly…

A: Q. Given that Pressure ( P ) Let start with the definition of the pressure.

Q: As shown in the figure, fluid fills a container having several sections. At which of the indicated…

A: Water is filled in several sections with different shape and pressure is to be analyzed below height…

Q: Three containers of different shapes, as shown in the figure Each container is known by the year,…

A: pressure only depends on the ,density, acceleration due to gravity and height of the liquid it is…

Q: How is head loss related to pressure loss? For a given fluid, explain how you would convert head…

A: The head loss represents the additional height the fluid has to be raised by a pump in order to…

Q: Water flows through a horizontal pipe with a cross sectional area of 4m^2 at a speed of 5m/s with a…

Q: The horizontal constricted pipe illustrated in Figure below, known as a Venturi tube, can be used to…

Q: An incompressible and frictionless fluid flows left to right at a constant volumetric flow rate…

A: Given order of area ( from figure ) AB > AA > Ac > AD

Q: Rank the pressures from highest to lowest: (a) bottom of a 10-cm-tall container of salt water, (b)…

A: Pressure in at the height below h from the surface with density ρ of the liquid is: p=ρgh Salt water…

Q: Speed Pressure Remain the same Increase Remain the same decrease

Q: A 0.98-kg beaker containing 1.98 kg of oil (density = 916.0 kg/m3) rests on a scale. A 1.99-kg block…

Q: Use the diagram below to show that the pressure difference between the two ends of the tube is…

Q: Choose the most appropriate answer. In which of the following fluid flow, does the fluid properties…

A: Steady flow is a type of flow in which there is no variation of fluid properties with respect to…

Q: A friend can inhale to create a gauge pressure of -70 mm Hg (Hg density = 13.6 g / cm3). The height…

A: Since, the pressure are same then, p1gh1=p2gh2p1h1=p2h2

Q: A manometer using oil (density 0.9-- g/cm^3) as a fluid is connected to an air tank. Suddenly the…

A: Assume a manometer using oil as a fluid is connected to air tank. The density of the oil is ρoil =…

Q: When atmospheric pressure changes, what happens to the absolute pressure at the bottom of a pool? A)…

A: The absolute pressure is given by pressure from the pool plus the pressure from the atmosphere.

Q: Question : A liquid flows in a horizontal pipe of radius 0.04 m in a section of the tube of…

A: Given: The radius of the main pipe at the first point is 0.04 m. The radius of the restricted…

Q: 4. A- is a devise that decreases the speed of the passing fluid while increasing its pressure. o…

A: Hi. as you have posted multiple questions and have not specified which question needs to be solved,…

Q: A liquid of density 884.4 kilograms per cubic meter flows through at vertical tube. If the pressure…

A: Write the given values with the suitable variables. ρ=884.4 kg/m3h1=5.7 mv1=8.3 m/sh2=4.4 m Here, ρ,…

Q: What is the pressure difference between points A and B of the tanks shown in the figure?

A: Here given the figure with two points of the tank A and B. We have to find the pressure difference…

Q: What is the difference between the pressure on the bottom of a pool and the pressure on the water…

A: As we know that,

Q: In the hydraulic lift shown in the figure, A1 < A2. How does the pressure (P1) caused by F, compare…

A: Pressure is defined as the force acting per unit area. P=FA

Q: As shown in the figure, fluid fills a container having several sections. At which of the indicated…

A: The expression for the pressure is,

Q: The spring of the pressure gauge shown in the figure below has a force constant of 1,200 N/m, and…

A: Its given:

Q: A cubical block of wood, 10.0 cm on a slide, floats at the interface between oil and water with its…

A: Given: Density of the oil is 0.79 g/cm3. Block is floating at a distance of 1.50 cm below the…

Q: atm water oil h

A: The depth of water and oil in the cylindrical tank are the same which is equal to h.

Q: A steel ball of density 7.90 g/cc and 4 mm diameter requires 55 seconds to fall a distance of 1 m…

A: Given data: The density of steel ball, d=7.90 g/cc. The diameter of steel ball, D=4 mm. The density…

Q: What is the total pressure at point A?

Question

In the figure, fluid fills the container shown here. At which of the indicated points is the pressure the least?

-A

-B

-C

-D

-The pressure is the same at each of the labeled points.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) The pressure inside an alveolus with a 2.00104 -m radius is 1.40103 Pa, due to its fluid-lined walls. Assuming the alveolus acts like a spherical bubble, what is the surface tension of the fluid? (b) Identify the likely fluid. (You may need to extrapolate between values in Table 11.3.)
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?
Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
Pressure in the spinal fluid is measured as shown in Figure 11.43. If the pressure in the spinal fluid is 10.0 mm Hg: (a) What is the reading of the water manometer in cm water? (b) What is the reading if the person sits up, placing the top of the fluid 60 cm above the tap? The fluid density is 1.05 g/mL. Figure 11.43 A water manometer used to measure pressure in the spinal fluid. The height of the fluid in the manometer is measured relative to the spinal column, and the manometer is open to the atmosphere. The measured pressure will be considerably greater if the person sits up.
(a) A water hose 2.00 cm in diameter is used to fill a 20.0-L bucket. If it takes 1.00 min to fill the bucket, what is the speed v at which water moves through the hose? (Note: 1 L = 1 000 cm3.) (b) The hose has a nozzle 1.00 cm in diameter. Find the speed of the water at the nozzle.
(a) Calculate the absolute pressure at an ocean depth of 1 000 m. Assume the density of seawater is 1 030 kg/m3 and the air above exerts a pressure of 101.3 kPa. (b) At this depth, what is the buoyant force on a spherical submarine having a diameter of 5.00 m?
You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius. (a) What force in newtons must you exert to create a pressure of 6.90105 Pa (b) What is unreasonable about this (a) result? (c) Which premises are unreasonable or inconsistent?
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?
A spherical submersible 2.00 m in radius, armed with multiple cameras, descends under water in a region of the Atlantic Ocean known for shipwrecks and finds its first shipwreck at a depth of 1.75 103 m. Seawater has density 1.03 103 kg/m3, and the air pressure at the oceans surface is 1.013 105 Pa. a. What is the absolute pressure at the depth of the shipwreck? b. What is the buoyant force on the submersible at the depth of the shipwreck?
An airplane has a mass M, and the two wings have a total area A. During level flight, the pressure on the lower wing surface is P1. Determine the pressure P2 on the upper wing surface.