In the circuit given below, the charge on capacitor at t = 0 sec is 90 μC.
Q: 3. Find Find Reg. 40 ww Rog => 360 30 На H ww 3.P www 32 5.0 G Reg -10.52
A: Question 3:Given that, Equivalent resistance Req =?Note:By bartleby…
Q: 7.23 The switch in the circuit in Fig. P7.23 has been in the left position for a long time. Att = 0…
A: The solution is given below Explanation: If you are having doubt in any step please comment…
Q: answer the following question about the circuit diagram below
A: (a) Time constant: τ=45.4545μsIt reaches steady state at: tS.S=227.2725μs (b) At…
Q: O Amplifier O Oscilloscope O Actuator O Bandwidth can measure sound by converting that sound into…
A: The device that measures the sound needs to be identified from the given options.
Q: 1. An oscillating voltage drives an alternating current through a resistor, an inductor and a…
A:
Q: A 4-pole, 50-Hz, three-phase asynchronous motor is operating at a shaft speed of 1750 rpm. What is…
A: The given data is shown below:
Q: *4.35 Draw the Direct Form II realization of the LTI system d²x dx +2 dt +3y(t)=4 +5 d12 +6x(t). dt
A: The LTI system,
Q: Find the currents 11, 12, and i3 if A=25 2, B=75 2, C=25 2, V1=13v, and V2=5 v. V₁ Hint: 10.26857 i1…
A: By Taking the Middle node as V3.By applying Nodal analysis at Node V3,(V3-V1)/A + V3/C + (V3-V2)/B…
Q: The circuit below is fed with alternating voltage U with frequency f. a) Calculate the current Ic…
A: We will solve for each parallel brancha.) has in branch2 the value from C is unknown so we save it…
Q: LOAD COMPA COMPB 0 pwmA pwmB Same period (frequency), different duty cycles.
A: Please refer below pages. In solution I have taken you through the terms such as:1.Count down…
Q: For the following circuit, initial conditions are as follows: Current across the inductor i L (0) =…
A:
Q: Problem 06.039 Section Break Consider the circuit given below, where RC=150 Q Rc VBB 10 V www RB 470…
A: In the given question we need to calculate the base resistance.
Q: What assumption from the ideal diode derivation implies the following relation? qV bi/KT • P=P по ро…
A:
Q: P.29, Page 723 ..A 2.0-μC point charge and a 4.0-μC point charge are a distance 1 m apart. Where…
A: In the given question we need to calculate the distance x at which net force will be zero on third…
Q: The circuit in the figure is supplied with a sinusoidal alternating voltage. a) Calculate the source…
A: Here we have calculated all the parameters that have been asked. If any doubt please feel free to…
Q: C. Supply Voltage = 40 V Load Torque, T (N.m.) Armature Current, Ia (A) Shaft…
A: The given table:Load Torque, T(N.m)Armature current Ia (A)Shaft speed…
Q: For a certain alternating current, i(t), [A] i = 2 ⋅ sin (500 π ⋅ t + ) π, where the time is in…
A: The objective of the question is to determine the peak value, rms value, period, and frequency of…
Q: Circuit Theory: I have this following circuit but its not producing the correct output. My input is…
A: Please refer below pages.If you have any doubts please feel free to ask.Explanation:Step 1: Step 2:…
Q: O Calculate the equivalent capacitance if C₁ = 4 F C₂ = 6 F C3 = 1 F C₁ C3 C₂
A: Ceq = 12/17 FExplanation:When capacitors are connected in series, the total or equivalent…
Q: Consider a point charge Q surrounded by two different materials. The properties of the materials are…
A: The solution is attached below.I have also solved further parts for better…
Q: Please answer in typing format
A: In this question, we need to choose the correct option. what is angle θ based on for a series RC…
Q: I need a handwritten expert solution and the correct and complete question prompt.
A: Z11=(5−j6)Ω Z12=5Ω Z21=5Ω Z22=(5+j8)ΩExplanation:Step 1:Step 2:
Q: For a R-C series circuit if the power commend by the resistance is 500 W at 100V. If the input…
A: The given data is shown below:
Q: positive-asserted reset negative-asserted set D Q R D (a) You are given a D flip-flop with…
A: Complete the waveform diagram of part a and part b
Q: Q5/ A three bus power system is shown in Figure (3) The system parameters are given in Tables below.…
A: θ2=−4.01°θ3=−4.08°V3=1.0304puV1=1.05∠0°,V2=1.03∠−4.01°,V3=1.0304∠−4.08°Explanation:Step 1:…
Q: R1=220 2 R2=68 Ω EV + R₁ R2 A B
A: The given circuitHere given that circuit is supplied sinusoidal voltage so supplied voltage assume…
Q: Question 1: In Figure 1, what is the peak output voltage if the diodes are silicon? Determine…
A: Given:A rectifier circuit with silicon diodes,we need to find:peak output voltageDC (average value)…
Q: 1. Assuming that the diodes in Figure 1 are constant voltage-drop diodes with a voltage drop of…
A: A diode is a two-terminal semiconductor device that allows current to flow in only one direction…
Q: For the energy conversion system shown in Fig., if the airgap length is reduced from x = 0.05 to…
A: In the given question we need to discuss about the effect of reducing the air gap length.
Q: 5. Find I, using superposition. 240°A ΙΩ 10 -j10 ww + 640°V
A:
Q: A 20ohm resistor and a 1μF capacitor are connected in parallel. This parallel combination is…
A:
Q: If the peak value of a sine wave is 19 V, the peak-to-peak value is O None of the others O 38V O 19V
A:
Q: Parallel connected RC circuit is given. a) Calculate the current Ic through the capacitor b)…
A: In this question, we need to determine the current in capacitor, value of capacitor, total impedance…
Q: In a RC type low pass fitter, the cut- off frequency is 1500 Hz, Assuming the capacitance to be 500…
A: In this question, we need to determine the value of resistance R of the low pass filter. It is given…
Q: Q4. Calculate io(t) for t> 0 in the network shown below. 2e 'u(t) V ΙΩ ww 1 F i 1 H m 4u(t) A ww 192
A: Given:a circuit,we need to determine current i0(t) for t>0.
Q: 100 Resistor ⚫ 1 mH Inductor (with label 102) ⚫ 10 E Capacitor (it is a beige ceramic capacitor…
A:
Q: Q-2) Try to obtain the ratio between the average and RMS value of the signal wave given below: v(t)…
A: Given:we need to find the ratio of average value to the rms value.
Q: Two batteries have each been measured with the following data: E1 = 33.6 V, R1 = 2.2 Ω E2 = 24 V, R2…
A: a. Calculate the current flowing through circuit.b. Calculate the voltage UAB c. What is the…
Q: A circuit is shown in the figure. C = 8x104 F, L = 4×102 H, and R = 9 Q2. The AC source has a…
A: The circuit diagram is shown below,
Q: + V1- 11 12 V2+ 1ΚΩ 1ΚΩ 13 5V 1ΚΩ + V3 + V4 . a) Write down Kirchoff Current Law (KCL) equations! b)…
A:
Q: Consider the circuit in (Figure 1). Figure Part A 2202 250 www 6.0 V HH 15 120 140 Determine the…
A:
Q: 3. In a TEM using beam energy of 70 keV, if the film thickness is t = 30 nm, and magnetic inductance…
A: Given parametersBeam energy =70keVFilm thickness is t=30nmMagnetic inductance due to in-plane…
Q: Using Multisim please
A: The objective of this question is to design a traffic control system for a four-way intersection…
Q: switch is in position 2, circuit will discharge the inductor draw the circuit in discharge phase,…
A: In the given circuit the value of the voltage and current during discharge phase, circuit at…
Q: *4.19 The current source shown in the circuit of Fig. P4.19 is given by the displayed waveform.…
A: Solved below .Explanation:
Q: 3. Find Vs if V = 8445°V. w 20 12 Vs |+ j20 ele HH -j292 V1 20 w Vo
A: The supply voltage Vs for the given circuit has been calculated. A detail explanation has been given…
Q: For certain dynamometer ammeter, the mutual inductance M varies with deflection = (expressed in…
A: The given data is shown below:
Q: Review | Constants The steady-state voltage drop between the load and the sending end of the line…
A: The given circuit diagram is shown below,
Q: BJT Circuit Theory: I have this following circuit but its not producing the correct output. My input…
A: Please refer below pages.If you have any doubts please feel free to ask.Explanation:Step 1: Step 2:…
Q: Calculate the inductor's energy if i = 10 A L = 6 H о- о L
A: 300 JoulesExplanation:Approach to solving the question:The energy of inductor is given by the…
Step by step
Solved in 3 steps with 12 images
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
- A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
- Consider the circuit in figure given below: A B The capacitor C is initially charged. At time 0, the switch is connected from A to B and the voltage across the capacitor is measured. The following data are recorded by a data acquisition system: t(s) 0.0 0.1 0.2 0.3 0.4 0.5 V(V) 4.98 1.84 0.68 0.25 0.09 0.03 (a) Determine the linear correlation coefficient betweent and V. (b) Determine the linear correlation coefficient between t and In(V).Caculate the time for 21(Tau) in (milliseconds) for the following RC Circuit. Assume switch is closed and capacitor is in a charge state. t=0 LE -10 V R1 1kQ C1 1uFThrough a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm