In a RC circuit with power supply with an emf of 10 V, capacitance 5 µF, and resistance 10000, the slope (in units of C/s) of the curve of Q (the charge on the capacitor) vst (the time elapsed after starting the charging) at t = 0 s is: tnill O a. 0 2020 O b. -0.1 O c. -0.01 O d. 0.1 O e. 0.01 Clear my choice

In a RC circuit with power supply with an emf of 10 V, capacitance 5 µF, and resistance 10000, the slope (in units of C/s) of the curve of Q (the charge on the capacitor) vst (the time elapsed after starting the charging) at t = 0 s is: tnill O a. 0 2020 O b. -0.1 O c. -0.01 O d. 0.1 O e. 0.01 Clear my choice

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 68AP: A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The...

See similar textbooks

Similar questions

A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Differential Equations: Electric Circuits When a resistance R (ohms) and a capacitance C (farads) are connected in series with an emf E (volts), the current I (amperes) is given by the equation: dE 1 R- +-I = dtC dI C dt If R = 1000 ohms, C = 5x10-4farad.and I t = 1 second and E = 100 volts. a. 1.35 amperes b. 2.35 amperes c. 3.35 amperes d. 4.35 amperes 10 amperes for t = 0, find the current for
Circuit Problem: Express each labelled voltage and current (e.g., vx, ix) in terms of the resistances and source currents and voltages (e.g., R0).
A TV works properly under the voltage of 4V= 110 V with power P = 1560 W. Express the current I through the power P and the voltage AV. I = Calculate the working current of the TV in A. I = Express the resistance R through the voltage AV and the current I. R = |Calculate the numerical value of R in 2. R =
01701&cmid=97298page38 For the following circuit in the figure below. Determine V,-V, (in units of V) for E = 48.5 V. a t of estion 20 20 50 9. Select one: OA. 8.08 OB. -40.42 OC. -9.70 OD. -8.08 OE 9.70 ous page brt sc delete backsoace ent
b. The voltage across the plates of a capacitor at any time t seconds is given by t V(t) = Ve¯RC where V, C and R are constants. Given V = 200 volts, C = 0.1 x 10-6 Farads and R = 4 x 105 ohms. Find i. The initial rate of change of voltage ii. The rate of change of voltage after 0.5 s.
Ohm's law gives the relationship between voltage, resistance, and current in a simple circuit: V = IR. a) Find (dV/dt) in terms of I, R, (dI/dt) and (dR/dt). Assume all quantities are functions of time. b) We have a circuit with 500 Ω resistor, and we ramp up the voltage. How quickly is the current changing when we are increasing the voltage by 10 V/s? It will help to remember that t is the independant variable here. Include units, note that 1Ω = 1V/A. c) Is the current increasing or decreasing? How can you tell?
An uncharged capacitor and a resistor are connected in series to a battery. If & = 9.00 V, C = 20 μF, and R = 2 Mº. a. Find the time constant of the circuit. b. Find the voltage across the resistor at the moment the switch is closed. c. The maximum charge on the capacitor. d. The voltage across the resistor 20 seconds after the switch is closed. e. The time it takes the capacitor to be 50% charged.
You are measuring the current of a certain component in a circuit board and it reads negative (-) 8.77MA. What does it means? a. There is an error on the digital multimeter. b. The numerical value of the current is negative. c. There is an error in the circuit. It is short circuit. d. It indicated an inverse direction. You have switched the positive and negative terminal of the DMM.
C, - 10µF C, = 10µF Oane 12V FIGURE 1 Refer to the figure 1. Two electrolytic capacitors are connected in parallel across a 12-volt supply. What is the total charge of the given circuit? A. 240 μC B. 0.6 μC С. 60 иС D. 720 µC Select one: О а. А O b. B О с. С O d. D
A heater has a resistance of 400Q when the potential difference across it is 12V. If this same heater is connected in series to a circuit with a 98V supply and a resistor S, how much resistance should S have so that the potential difference on the heater is 12 V? a. 2867 Q O b. 2467 Q O c. 3267 e O d. 3667 e